When opening the doors Console and Radio turn off!!

The P1594 means that the battery voltage sense input is above the target. This is most probably a problem with the alternator. I would take it to a shop where they can test the alternator for you.

You have all the fuse locations. I have seen some that after radio was put in did that. usually it turns out that re-grounding the dash or using different power supplies for the radio has corrected it. otherwise, I'd check the light switch and make sure it's OK.

check the wire harness where the door hinges are located. between both hinges there is a rubber boot, sometimes the wiring gets frayed and a short develops in this area;between the door and the dash, Also wires inside the door will shortt out. i hope this helps you

I’m happy to help further over the phone at https://www.6ya.com/expert/gregory_8e6ba270263743ac

Seems to be a chronic problem with crank position sensors... On yours it is tested between b&c terminals and should have no continuity there. (should show an open circuit if good)

It could be your Crank Shaft Sensor. That's what it was on my 99 Cherokee Sport the first time that happened.

The battery seems to be sending the wrong signals. get it replaced.

It just pops off and on. just start at a bottom corner and gently pull. then go to the next bottom corner then work your way up.

Look for a button like thing sticking out of frame where door closes, or even on door frame for same. May even look like a wedge shaped black button, spring loaded, try moving it to see. That will be your switch that turns on the light when open.

door ajar switch in doors dims lights till off turns radio off clean latches with pbblaster close doors severral times fixed

Hi,

Either the radio's output ICs are fried or speaker/wires needs to be checked.

Incidentally, there are some higher end versions that has an Infinity Amplifier (P/N: 56038407AD) powering the speakers and not the radio (alone). If so, this amp needs a trigger on from the head unit to work and therefore, the trigger wire/connection must be checked. Otherwise, it may likewise require an internal check.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.