Question about 1995 Pontiac Grand Am

1 Answer

How do you replace a multifunction switch on steering column 1995 Pontiac Grand AM ??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Pull the stearing wheel, and the plastic shroud around the column, then it will come off

Posted on Nov 22, 2010

  • IanC. Oct 31, 2011

    I just did this on my 1994 and steering wheel does NOT need to be removed! Use short T25 screwdriver bit and 1/4 in. wrench to turn the lower attaching scew

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change the dimmer switch to my Pontiac grand prix


Disconnect the battery ground negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical. Remove the left instrument panel (IP) insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side . Remove the steering column filler. Refer to Steering Column Opening Filler Replacement . Remove the knee bolster bracket. Refer to Knee Bolster Replacement . Lower the steering column. Refer to Steering Column Replacement in Steering Wheel and Column - Tilt. Remove the instrument panel cluster (IPC) trim plate. Refer to Instrument Cluster Trim Panel Replacement in Instrument Panel, Gages and Console. Grasp the headlamp switch and pull firmly to release the retaining tabs from the instrument panel. Disconnect the electrical connector from the headlamp switch. Remove the headlamp switch.



Grasp both sides of the bottom edge of the instrument panel cluster (IPC) trim plate and pull out in order to release the retainer clips. Disconnect the electrical connector from the fog lamp switch. Remove the trim plate from the IP.




qqezpewk1waaaabjru5erkjggg==

gaaaabjru5erkjggg==

Jan 14, 2015 | 2002 Pontiac Grand Prix

2 Answers

I have a 1995 grand prix Blinkers dont work but, other lights do.


First check turn signal fuse and relay if, they are good then try pressing on and off the hazard switch while turning the signal switch on.If signals start to work replace hazard switch.If hazard switch is good then replace turn signal switch.

May 02, 2011 | 1995 Pontiac Grand Prix

1 Answer

My 1995 pontiac grand prix has a probiem with steering collum none of my gauges or speedometer work


check your fuseable links and your electrical ignition switch wear where your key turns and moves the rod to move the switch on the steering column under the dash

Dec 08, 2010 | 1995 Pontiac Grand Prix

1 Answer

I have a 2002 pontiac grand am and there is a constant clicking coming from the hazard switch. I just replaced the switch, part number, old one 22624799 with a new one ac delco part number 10359039. it is...


You have a bad multifunction switch ie. turn signal switch. poor design. easy to replace.
remove the cover off the steering column- three or four screws from bottom
two or three screws hold the turn signal switch, plus two plugs
when installing watch to make sure you get the horn button pushed back in the switch, as not to bend anything.
Good luck
Randy

Nov 09, 2010 | 2002 Pontiac Grand Am

1 Answer

Inoperative taillight,dash lights,and fog lamps on


i have 2001 Audi is a liking gas problem

Mar 14, 2010 | 1996 Pontiac Grand Am

2 Answers

Puffs of smoke coming out of the steering column


the problem is your signal light switch circuit board is worn out. Ive replaced that same part cause i was having the same problem. Then i had to replace my steering column for other reasons and now guess what .......MORE SMOKE!.

Sep 18, 2009 | 1992 Pontiac Grand Prix

2 Answers

How do i remove ignition switch on steering cloumn of 2000 pontiac gran prix


unless u are familiar with air bag assemblies I suggest u take it to a qualified mechanic..if u accidently touch something wrong u can deploy the bag and cause serious harm to yourself..u have to remove the air bag in the steering column

Sep 16, 2009 | 2000 Pontiac Grand Prix

2 Answers

Turn signals work sporadically


you have a bad turn signal multifunction switch in the steering column.

May 10, 2009 | 2004 Pontiac Grand Am

1 Answer

1998 pontiac sunfire


this problem is the multifunction switch in the steering column .there are two different circuits that travel through the multifunction turn signal switch this should be replaced.

Feb 22, 2009 | 1998 Pontiac Sunfire

1 Answer

Replace multifunction switch on Pontiac Gran Prix 2000


no just the top and bottom of the steering wheel cover

Dec 07, 2008 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
1995 Pontiac Grand Am Logo

Related Topics:

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...