Question about 1996 Dodge Dakota

1 Answer

When driving, the fan belts goes fast and the engine slows down, I put on the gas pedal but it works hard just to get it to kick in to drive in normal mode...then there is a clicking sound and Im told its the ball bearings..does it have to do with the engine acting up or is that another thing like a fuel filter...

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,763 Answers

These trucks are famous for fuelpumps going bad, the bearing s noise may be pinging due to a lean fuel mixture because the fuelpump is not putting out enough pressure, the engine is starving for gas, the first thing i would do is have the fuel pressure tested, if the pressure is low then replace the fuelpump, hope this is helpful, good luck.

Posted on Nov 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Unknown Vibration Feeling...


Hi, I would try electrical fault. Try this, If you have engine running and handbrake fully on, and foot brake on, put it in drive and accelerate. If engine is rough or vibrating it could be spark plug, leads or coil pack. Under load any one of these will fail and cause a rumble (vibration) in the engine, when the engine has come off load it will run fine. You could also try putting your foot hard down on the pedal from stop position as if you were trying to do a burn out. It will give you the same result as handbrake test. That could be your problem as you mentioned that when aircon is turned on it does it (which is putting load on engine), but as far as slowing down to corner??????.

Nov 20, 2014 | Cars & Trucks

1 Answer

Loud ticking noise when first staring, engine stalls sometimes when starting it unless I hold the gas pedal down


The TPS would be what I would do had that problem once myself solved the problem. as for the ticking noise sounds like a lifter is bleeding down as long as the noise goes away you will be ok. But may I suggest that if you are going to keep the vehicle for awhile longer you might want to have a set of lifters put in it.

Feb 18, 2014 | 1999 Dodge Durango

1 Answer

Rpm does not drop below 1000


No,only on carburated engines it,idles down to the set point,on yours,it's fuel injected,pushing gas pedal won't kick idle down,should go down after a certain amount of time,does it automatically,If you start and drive a 5 mile ride and stop at a stop sign,it should idle at it's set point if there's no engine problems,which may be.5 to .7 on your tac.When you normally first start,it will idle between 1000 to 1200 rpm's,don't push on gas,let idle say 15 seconds,put in drive and go.

Jan 13, 2013 | 2005 Chrysler Sebring Conv

1 Answer

Getting on interstate when increasing gas pedal (fast)check engine light comes and reduced power light comes on and goes into reduced power,pull over turn off engine and restart ok.Garage put on 2...


Hello, Check the wiring at the throttle body on the motor that drives the throttle plate. Wires can be broken inside the insulation or bad contact at the connector.

Jan 13, 2011 | GMC Envoy Cars & Trucks

1 Answer

Whenever I put the Audi A4 in reverse it shifts fine but when i put in in drive it shifts real hard and when I am slowing down at times it downshifts like something hit me.Where do I add trans fluid?


down the dipstick tube!!!(really)DO NOT OVERFILL...
Your audi is fitted with a fuzzy logic gearbox, it will change according to your driving style.TRY THIS,put into 1st and without touching gas pedal, let the car accelerate to top gear,stop Then using onle 1/3rd gas pedal do it again.then using 2/3rds do it again.then only using the minimum pedal req accelerate to max legal limit.(try not to use brake pedal,let the car slow down itself,until you have to)then drive as normal, it will feel like a different car.

Mar 22, 2010 | 2000 Audi A4

3 Answers

2001 Jeep Grand Cherokee Laredo Overheating


Three possible solutions:

1. Bad Thermostat

2. Fan Relay (most likely)

3. Bad Fan

When the GC reaches a temp of 180 Deg. F the fan relay sends a signal to the fan to turn on, once the temp lowers (around 155 Deg. F) the relay turns off the fan, and so the cycle continues. If the relay is bad there will be no signal to the fan to run. While you are driving your vehicle there is ambient air moving thru the radiator, cooling the engine, but once you encounter slow/heavy traffic or stop there is no air moving and the temp goes up, the fan will not kick in and the vehicle will overheat.

If the fan motor is not working the same will happen, but a more expensive fix, as the motor comes with the fan.

If the Thermostat is stuck in the open position, the water travels to fast in the engine and heat exchanging is not an efficient process, therefore the vehicle might overheat when stopped or in slow traffic.

Mar 31, 2009 | 2001 Jeep Grand Cherokee

1 Answer

My engine light keeps flashing off and on then it stays steady


replace the sparkplug wires. and avoid large puddles
rank me

Dec 11, 2008 | 2001 Ford Windstar

Not finding what you are looking for?
1996 Dodge Dakota Logo

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...