Question about 2002 Chevrolet Venture Passanger

1 Answer

Stripped gear window gear stripped

Posted by on

  • cheapy Jun 19, 2008

    howk handle off do i get the crank handle off??



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,010 Answers

Go to a mechanic that build the part again and hide the window gear.

Posted on Jun 17, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Loss of automatic gears and windows on Nissan mica

Most likely your window motor is bad or the gear stripped out. Regardless you will have to put in a new window motor. You can get one pretty cheap online. Check Rock But pull your door panels off and check it out. BigD

Feb 16, 2015 | 2006 Nissan Micra 1.4

1 Answer


I just went thru this 4 months ago. Both windows stopped working on the same day on my 95 Ford Explorer. It's the window motors. Pop off the door panel and try to see if the window regulator (looks like huge scissors) gear is stripped. If the window regulator gear is stripped, the the regulator is the problem. If not the gear isn't stripped, then it's the motor, which is hard to see. If you can't see either gear, you will have to take out the window regulator out no matter what, so take that out and inspect it. If it looks fine, then it's definitely the motor and needs to be replaced. Either way the window and regulator have to be removed. You can then remove the window motor freely. If you are unsure of how to do any of this, buy the Haynes manual for your vehicle ($20) and it will guide you through it. Toughest part is the drilling out the rivets if you have them. You can replace the rivets with screws that are slightly larger than the rivet hole you drilled out. Make sure you drill out dead center of the rivet. You can start out the drilling with a punch to help the drill bit stay centered. Good luck

Nov 30, 2013 | 1997 Ford Thunderbird LX

1 Answer

Windows wont roll up or down

window regulator. no clue without looking at it if you have a cable driven one or a gear driven one though.
if cable driven, sounds like the cable has snapped. if gear driven (most likely) then the plastic gears inside the window motor on the regulator have finally worn and stripped out.

Jun 17, 2011 | 2002 Ford F350 Super Duty DRW Reg. Cab

1 Answer

Drivers side pwr window not working, motor runs but window will not move, in up position

If the motor moves then either the gears are stripped in the regulator or the window is off track. More then likely its the motor assembly which has the gears in it. Some older fords offer a gear rebuild kit for the window motors or you can buy the motor with the gear assembly for about 30$
Please rate me

Aug 25, 2010 | Ford Tempo Cars & Trucks

1 Answer

Power Window will not work. The motor runs but the window won't move

the plastic drive gear has probably stripped the teeth off the gear or the cable may have broken on the mechanism

Jul 02, 2010 | 1999 Jeep Grand Cherokee

1 Answer

Drivers side window (power) will go down about 4 inches then stops. I hear a grinding sound like gears not meshed. Wont go up unless I assist by hand. Passenger side window works fine

Replace the Track strip for the window. There is a track guide inside the door with teeth on it and you have lost a few of the teeth on that strip creating a bad spot. It is usually about $12 to $15 and a 30 minute job to replace. Once you get the door panel open it should be pretty obvious how to remove the old strip and install teh new one.

Oct 07, 2009 | 1994 Oldsmobile Cutlass Supreme

1 Answer

My 96 civic passenger side windows will not roll down but motors work

If you can hear the motor spinning and the window isn't going up or down the gears on the motor or regulator might be stripped. Some vehicles use plastic gears on the window motor making it quieter however more prone to problems like yours.

Sep 27, 2009 | 1996 Honda Civic

1 Answer

Driver window won't go up

there are a few things that can cause this to happen. Since you do not say if you have electric, or manual windows, it makes it a little harder to diag. If you have manual windows, you could have a gear that is stripped (normally you can tell because the handle rotates freely with little resistance) or your window jumped off the track from a large bump or ware. For electric windows, there are a lot more problems that can acure. To start, the window switch could be bad/shorted out; window regulator needs replaced; the electric motor itself could be bad; a gear is stripped; or a number of other things. Since there are so many componants to the operation of a window, it is hard to know what is actually wrong with such a vegue discription.

Aug 31, 2009 | Toyota Camry Cars & Trucks

1 Answer

88 toyota p/u window arm removal

remove the window by un-doing the two bolts at bottom, then undo bolts that secure window mechanism to door. I think you will find that it is not the gear that is stripped. The shaft that supports the gearruns in a pressed steel bush, this is what will have worn. I just cleaned away the sahrds and tacked on a nut of the right size to act as a replacement bush.

Jan 02, 2009 | 1988 Toyota Pickup

Not finding what you are looking for?
2002 Chevrolet Venture Passanger Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides