Question about 2003 Toyota Tundra

Open Question

How do I replace left rear tail light on 2003 Toyota Tundra?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 Toyota Sienna - Need to replace left rear brake light

Hi -
I just replaced my left rear brake light on my 2005 Sienna. I followed the manual directions and removed the two metal bolts from the tail light cover. However the assembly did not come off. I could open it a little and it appeared to be bolted from the inside. I looked online but didn't find an answer. I had already gotten pulled over and I didn't want to go to the dealer so I pulled on the assembly a little harder applying even pressure to the top and the bottom and it popped loose. I didn't yank it. There are two metal pegs that have a little lip on them and thats where you are getting the resistance. Hope this helps.

Posted on Jan 11, 2009

mecanica03
  • 881 Answers

SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights

check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me

Posted on Jul 05, 2009

  • 4 Answers

SOURCE: 2002 Toyota Highlander Cracked Tail Light

Inside your trunk on either side of your tailgate are panels that allow you access to your taillights....I'll add more later.

Posted on Sep 04, 2009

  • 1986 Answers

SOURCE: How do you replace rear tail light assembly?

Open the trunk and along the bottom of the tail light, there should be a Philips screw securing a cover piece. (your car may or may not have this piece)
With the cover off, there will be another 2 screws securing the bottom of the tail light assembly. Remove the screws and pull the bottom out and the top is held in by two retainers that should just slide right out

Posted on Oct 13, 2009

  • 29 Answers

SOURCE: 2003 Toyota Highlander.The brake light on the

Replace the right rear brake lamp. The bulb possible use two filaments one for brake and tail light. One burnt out filament in one bulb.

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for tail lights on trailer?


that will be because you have a bad ground connection

Oct 18, 2015 | 2007 Toyota Tundra

1 Answer

Trailer marker light fuse 2006 tundra Double cab


have you checked the tow tail light fuse or the tow tail light relay?

Aug 15, 2015 | 2006 Toyota Tundra

1 Answer

Tundra tail lights


Check and replace blown fuses for tail lamps. See you owner's manual for the location and amp rating of the fuse and fuse block.

Apr 07, 2014 | 2002 Toyota Tundra

1 Answer

Replacing tail light lens on 2003 camry after a parking lot incident.


if you remove the rear carpet in the trunk area that the broken tail light is you should see 4 or 5 10mm screws attaching the tail light assembly unplug the bulbs it should take only about 20 minutes

Mar 16, 2010 | 2003 Toyota Camry

1 Answer

2003 Toyota Tundra Limited Stepside truck. No brake light. But the 3rd brake light works. Already checked the 15 amp fuse by the steering column


Hello.

We would suggest that you look at the wiring connector under the bed, that feeds the taillamps.

You will probably find a coroded wire in the connector. If the 3rd brake lamp works, all of the fuses and switches are good.

Dec 25, 2009 | 2003 Toyota Tundra

2 Answers

2003 Toyota Highlander.The brake light on the passenger side is not working. New bulbs, driver side and center brake lights work. Tail lights left and right work. ???


Replace the right rear brake lamp. The bulb possible use two filaments one for brake and tail light. One burnt out filament in one bulb.

Nov 30, 2009 | 2003 Toyota Highlander

1 Answer

How to replace a 2003 Buick Century rear tail light assembly?


open the trunk and unscrew the plastic nuts on the back side of the light assy and replace

Oct 26, 2009 | 2003 Buick Century

1 Answer

2003 Toyota Sienna - Need to replace left rear brake light


Hi -
I just replaced my left rear brake light on my 2005 Sienna. I followed the manual directions and removed the two metal bolts from the tail light cover. However the assembly did not come off. I could open it a little and it appeared to be bolted from the inside. I looked online but didn't find an answer. I had already gotten pulled over and I didn't want to go to the dealer so I pulled on the assembly a little harder applying even pressure to the top and the bottom and it popped loose. I didn't yank it. There are two metal pegs that have a little lip on them and thats where you are getting the resistance. Hope this helps.

Dec 02, 2008 | 2003 Toyota Sienna

Not finding what you are looking for?
2003 Toyota Tundra Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...