Question about 1999 Plymouth Grand Voyager

1 Answer

How do you remove and replace a blower motor on a 1999 Plymouth Grand Voyager?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Plymouth Master
  • 6,674 Answers

Caution : BEFORE STARTING, DISCONNECT BATTERY ( - ) NEGATIVE CABLE FROM BATTERY TO AVOID POSSIBLE AIR BAG DEPLOYING, AND WAIT 3 or 4 minutes before beginning to be sure.. Removing glove box will make it easier. In behind there, you'll see a cover over motor, remove it, then you'll see motor and fan wheel. Remove wiring connector and push it back through into housing . Remove 3 screws holding motor/fan assembly and lower it down and out of housing. Reverse procedure for install, and don't forget wiring back through housing and grommet on wiring. Re-connect battery clamp after all installed and test it. Good Luck.

Posted on Nov 10, 2010

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
wracefans24
  • 1985 Answers

SOURCE: replace blower motor 1998 plymouth voyager

it is located behind and below the glove box,you might want to remove the glove box assembly to see it easier,
there are four screws holding a blower motor cover you to take off first,now remove the screws holding the blower motor up,disconnect the motor wires.
if your changing this because you think its bad,you should test the blower motor wires with a test light with the key on and blower switch turned on.if you have power in the wires,then it is bad.
but if you have no power in wires it could be blower motor resister,or switch.

Posted on Dec 06, 2009

  • 67 Answers

SOURCE: 1999 plymouth voyager blower motor

you have to replace it its located on the passenger side under the dash

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I want to replace the blower motor resistor but I need a diagram or picture to identify under the dash


blower motor resistor for that should be under the hood, on firewall behind passenger side strut mount. Little tight to get at but it should be there. Approx 1-1/2" x 3" block with screws on each end . Remove connector, & screws, and pull to one side and out at same time.

Dec 11, 2010 | 1999 Plymouth Grand Voyager

1 Answer

1999 voyager heater motor worked on high then not at all


Sounds like resistor gone for blower motor. Should be located under hood, passenger side behind strut tower on firewall. Little tight to get in there, remove 2 screws and slide it hard to one side and pull out at opposite end hard.

Nov 06, 2010 | 1999 Plymouth Grand Voyager

1 Answer

1999 plymouth voyager blower motor


you have to replace it its located on the passenger side under the dash

Feb 04, 2010 | 1999 Plymouth Voyager

1 Answer

'99 Plymouth Grand Voyager fan switch issues


The problem is not with the switch, it's the blower motor resistor. The resistor is usually located in duct work near the blower motor. It will have 4or 5 wires going to it and is held in place with a couple screws. These things generate heat, so they put them in duct work so the fan blows air across them to keep them cool. Sometimes the plug gets hot and melts, you should be able to buy the resitor and the plug with wires (pig tail) from an auto parts store or a dealer. The resistors are usually about $50 the pig tail is about $30.

Dec 02, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Blower motor not working


your mechanic didn't connect all connectors make them check and connect and tell them next time to do a better job

Jul 24, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Replacing Blower fan info


Should be only 3 screws holding it in Unplug, remove the screws and remove the blower motor.

May 29, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Blower motor


It's in behind glove box, you will probably have to remove glove box, but a good look up from under will tell you. You did check fuses & resistor right? Did it run for a while on high only?

Jan 08, 2009 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1999 Plymouth Grand Voyager Logo

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...