Question about 2008 Toyota Sienna

Open Question

I have a 2008 Toyota Sienna and received the error code P2197: oxygen sensor or a/f sensor stuck lean-bank 2 sensor 1. How hard is it to replace myself?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Adding daytime running lights to a 2008 Toyota Sienna

http://www.siennaclub.org/forum/index.php?showtopic=3772

DRL's can be added simply by adding a 20 amp fuse into an empty slot in the fuse box.

Posted on Sep 03, 2008

Ad
  • 101 Answers

SOURCE: P2195 Trouble code

There is a TSB for this car (Avalon) to replace both AF sensors and bank 1 exhaust manifold/convertor . Its covered under your 3yr/36k warranty.

Posted on Apr 24, 2009

  • 1201 Answers

SOURCE: 2008 Toyota Sienna Engine knocking

Have the knock sensor checked.

Posted on Jul 22, 2009

  • 1986 Answers

SOURCE: toyota mr2 roadster 2001 engine light on code po141 oxygen sens

bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know

Posted on Sep 08, 2009

geaeri95
  • 127 Answers

SOURCE: I have a 2003 Ford Expedition XLT 4.6L 2WD Auto

Sounds to me like you have an intake gasket or a vac line leaking. Get a can of brake cleaner or starting fluid (brake cleaner is preferred) and spray it around the engine with it running at idle and listen for the engine to rev up. if you spray is near the intake and it revs up, time for new gaskets. If you spray it away from the intake, near a line or something, and it revs, start looking around there for a broken line. if you fined one, it can be easily repaired with a 2 inch section of rubber tubing about the same diameter. just slip the line into the tubing and it should work just fine.

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Keeps throwing up trouble codes p1506,p1151,p0302,p0171


Definition of Diagnostic Trouble Code P1506 Audi: Closed Throttle Position Switch Does Not Open/Short to Ground BMW: Idle-Speed Control Valve Opening Solenoid Control Circuit Signal High Ford: Idle Air Control Overspeed Error (see P0507) Jaguar: Idle Air Control System RPM Lower Than Expected - B Bank Kia: IAC Valve Opening Coil Voltage High Lincoln: Idle Air Control Overspeed Error (see P0507) Mazda: Idle Air Control Overspeed Error Mercury: Idle Air Control Overspeed Error (see P0507) Porsche: Throttle Jacking Unit Lower Mechanical Stop, Signal Implausible Volkswagen: Closed Throttle Position Switch Does Not Open/Short to Ground Volvo: IAC Valve Opening Signal
------------------------
Definition of Diagnostic Trouble Code P1151 Audi: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Signal Intermittent (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Jaguar: Lack of H02S-21 switch, sensor indicates lean Land Rover: Lambda control limit bank 2.Implausible signal/condition Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Subaru: HO2S-12 Heater Circuit High Input Toyota: Coolant Path Clog Up for Coolant Heat Storage System Volkswagen: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded
------------
Definition of Diagnostic Trouble Code P0302 Category: Powertrain Definition: Cylinder 2 Misfire DetectedNote: This definition of P0302 is applied to all manufacturers
--------------------------
Definition of Diagnostic Trouble Code P0171 Category: Powertrain Definition: System Too Lean Bank 1Note: This definition of P0171 is applied to all manufacturers

Jun 17, 2015 | Cars & Trucks

1 Answer

Will not start p2045 p2197 p0190 p2247 p2245 p2248 p2249 p2518 comes up


code p2045 refers to reductant temperature sensor--high input==causes --wiring faulty sensor
code p2197 refers to heated oxygen sensor(HO2S)1 bank 2-- signal stuck lean===causes HO2S---fuel pressure---injectors---intake leak
also refers to oxygen sensor (O2s)1 bank 2 -signal stuck lean===causes--O2S--fuel pressure---injectors---intake leak
also refers to heated oxygen sensor (HO2S) 1 bank 2--implausible signal===causes wiring---short to ground--short to positive--HO2S---ECM
code po190 refers to fuel rail pressure (FRP) sensor-circuit malfunction===causes --wiring ---fuel rail pressure sensor---ECM
code p2247 refers to heated oxygen sensor (HO2s) 1 bank 1 reference voltage--open circuit===causes--wiring ---ho2s
also refers to o2s 1 bank 2 reference voltage ---open circuit===causes wiring---o2s
also refers to HO2S 1 bank 2 ---no signal===causes wiring--ho2s---ECM
code p2245 refers to HO2S 1 bank 1 --reference voltage --circuit low===causes--wiring short to ground--ho2s also refers to o2s 1 bank 1 circuit low===causes wiring short to ground--o2s
code p2248 refers to the ho2s I bank --performance problem===causes --wiring--ho2s
code p2249 has the same causes short to ground---ho2s and o2s
code p2518 refers to a/c refrigerant pressure sensor B ---circuit high===causes wiring short to positive--a/c refrigerant pressure sensor.
so after all that replace all the ho2s and o2s sensors using the correct tools so that the wiring is not damaged and check the wiring back to the ECM for burns and rub marks.

Dec 30, 2013 | Cars & Trucks

1 Answer

2007 Toyota sienna V6 P2197 code from Autozone diagnostic.


Solved. I have 2008 Sienna with Check Engine and VSC lights on. Scanned codes were P0051 and P2197. Oxygen Sensor Bank 2 Sensor 1 needs to be replaced. You can see this sensor on the right side of the engine when you open up the hood. You need to get an Oxygen Sensor socket (I used Tekton 7/8in 22mm which costs $9) and a wrench extension to reach it. Spraying liquid wrench a few times on the base of the old sensor also helped to loose it. The replacement sensor I used was Denso 234-9049 which costs $85 from eBay. Lights went off after the sensor was replaced. It took me 30 minutes to replace.
2007-toyota-sienna-v6-p2197-code-from-l0sykieabygz51ktlgs3lp2u-4-0.jpg

2007-toyota-sienna-v6-p2197-code-from-l0sykieabygz51ktlgs3lp2u-4-1.jpg

2007-toyota-sienna-v6-p2197-code-from-l0sykieabygz51ktlgs3lp2u-4-3.jpg

2007-toyota-sienna-v6-p2197-code-from-l0sykieabygz51ktlgs3lp2u-4-6.jpg

2007-toyota-sienna-v6-p2197-code-from-l0sykieabygz51ktlgs3lp2u-4-10.jpg

Sep 07, 2012 | 2008 Toyota Sienna

2 Answers

P2197 p2187 p2177 p2195 p2179 p2189


P2197 - Oxygen Sensor Signal Biased/Stuck Lean Bank 2 Sensor 1
P2187 - System Too Lean At Idle Bank 1
P2177 - System Too Lean Off Idle Bank 1
P2195 - Oxygen Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1
P2179 - System Too Lean Off Idle Bank 2

I am not sure what your Mazda is, but from the sounds of it, both of your Oxygen Sensors are shot. Replace them both, or check for vacuum leaks. It may be a good time to inspect and replace the PCV Valve and PCV Valve hose, too.

Mar 12, 2011 | Mazda MAZDA6 Cars & Trucks

1 Answer

I have 2004 ford escape with V 6 engine 2 engine codes p2195 & p2197 it running ok but I don't know if this is a O2 sensor and if it is where would they be on the truck


p2195
02 sensor signal stuck lean bank 1, sensor 1
p2197
o2 sensor signal stuck lean bank 2, sensor1

i beleave this will be the sensor before the catalytic converter

Aug 21, 2010 | Ford Escape Cars & Trucks

1 Answer

P2195 and p2197 are the 2 codes that pop up what are they and what do i need to change? mazdz mpv 2005 3.0 li


P2195 and P2197 means that the O2 sensors on each bank are seeing WAY too much oxygen in the exhaust gas. In normal operation the signal from the O2 sensors should swing back and forth between rich and lean... Your sensors are locked on lean. Replace both O2 sensor.

Hope helps (remember rated this).

Jul 22, 2010 | 2005 Mazda MPV

2 Answers

I have a 2003 3.0 engine Honda Accord that is giving me trouble codes P2197 P0154 P2254, what do these mean? Thank you.


Here it goes.
P2197 - Front Air Fuel Sensor (O2 sensor) Bank 2 - Sensor 1 Signal stuck lean.

P0154 - Front Air Fuel Sensor (O2 Sensor) Bank 2 - Sensor 1 Heater System Malfunction.

P2254 - Front AIr Fuel Sensor (O2 Sensor) VS Line high voltage.

IF Trouble codes P0134 or P0154 are present diagnose them before code P2254.

The first thing I would do would be check the heater circuit. You will have ground, and 12V+ to the 02 sensor heater line on a cold start. This heats up the oxygen quicker and allows it to operate in the correct amount of time. 9/10 times if there is a heater circuit code it is the oxygen sensor. But 1/10 times it is a blown fuse. So checking the voltage at the sensor is a quick test for P0154.

I would backprobe the signal line when the vehicle is at a full operating temp with a graphing meter (if avail) or use a DVOM. You should see it switch between .1 volts to 1V. It should not continuously move up and down. This indicates the computer is in good fuel control.

Diaginosis the heater circuit first is best because code P2197 can be set from anything that can cause that motor to run lean. (Plugged fuel filter, low fuel pressure/volume, vacume leak).

Hope this gives you a solid path to go on & good luck.

Nov 16, 2009 | 2003 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...