Question about 1965 Ford Mustang

1 Answer

When i turn off the car the engine stays running do i need a new ignition switch

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 116 Answers


Posted on Nov 09, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1986 2.8 camaro starts an dies, but will run on spray. new computer, dist. injectors an pump.

Hold the ignition switch just off where the engine cranks after it starts, if it stays running you need to replace the ignition starter switch. This is the switch at the bottom of the steering column that the key cylinder operates via a rod. See photo below.

Dec 01, 2016 | 1986 Chevrolet Camaro

1 Answer

Brake lights stay all time without car being on

So they stay on when the car is turned off with no engine running?
I imagine this flattens your battery?
Or do they only stay on once the ignition has been turned to "on" even without the engine running?
Could be the pedal switch sticking in which case you would simply need to look under the dash behind the pedal and try and "jiggle" the switch, though if they only stay on once the ignition is on I would lean towards a bad earth for the globe socket.

First maybe try and disconnect the pedal switch to ensure that its breaking the connection properly and turning your lights on and off.

Depending how handy you are, you could remove the tail light and run an additional earth for the globe socket.

Apr 09, 2014 | 1994 Geo Prizm

2 Answers

Engin keep turning when hand is off the key

You need a new ignition switch. Check with Autozone or OReilly's.

Dec 14, 2013 | 2006 Pontiac GTO

1 Answer

2007 chevy cobalt will start but not stay running

problem in theft security system it has to be reprogrammed to new key new ignition switch key lock system. dealership fix need diagnostic eqquipment to reprogram new ignition key and ignition switch lock cylinder to the immobilizer control module and ECM.

Jan 26, 2013 | 2007 Chevrolet Cobalt Coupe

2 Answers

When I turn my car off the air conditioner still runs-I needed a jump the other day because it ran all night and wore the battery down.

OK, if the relay for the A/C fan is bad, then the radiator's fan will keep running after turning off the ignition. Also, if the fan for ventilation of the A/C in the cabin stays on after the ignition is turned off, the relay for that is bad.

Good luck on this repair.

Sep 20, 2010 | 2001 Buick Century

1 Answer

It cranks up and cuts off

the anti theft system is causing it not to stay running the engine will run for a couple seconds and then the computer will turn off hte injectors. To fix this problem you may have to get a new "programmed" key for the ignition, a new ignition switch or the car may need a new ECM.

Feb 26, 2010 | 2000 Pontiac Grand Prix

1 Answer

Radiator cooling fan stays on after car is turned off, new temperature switches fitted,new relay fitted,,, any one had this problem? Cheers,,,,,,,,,,,,,,,,,,,,,,,GIXXER TIM

It depends, how long is it staying on after you shut the car off and how hot is the temp guage when you turn it off? The fan circuit is separate from the ignition and is designed to run until the engine reads a specific temp irregardless of whether the ignition is on or not. Hope this helps.

Feb 20, 2010 | 1991 Volkswagen Corrado

2 Answers

Has truble starting and staying started

Sounds like a bad ignition switch. Not the lock cylinder, but the electrical switch.

Jun 30, 2009 | 1983 Buick LeSabre

1 Answer

Ignition won't stay in running position.

You are gonna need a New Ignition. Will solve this Problem.

Jan 04, 2009 | 1998 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides