Question about 1999 Isuzu Rodeo

1 Answer

1999 isuzu rodeo slow to shift. Engine revs very high before it will shift.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 14,585 Answers

There is a cable that goes from the throttle body to the transmission. usually by the throttle body you can adjust the cables lenghth by pushing in the tab. only move this a couple of notches at a time, test drive and see where it shifts. adjust as necessary. 1st gear should be at 15 to 20, 2nd at 30. Let me know if this works for you , we can go from there.
Randy

Posted on Nov 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my isuzu rodeo stay in gear


there are only 3 issues here.
1 weak engine, , even 1st gear I have no engine power.
2: 1st revs normal but wont shift up.
3: the transmission slips. (flares) RPM goes nuts.

which one?

Jul 14, 2014 | 2001 Isuzu Rodeo

1 Answer

Isuzu owners club


who says it over rev'd what authority,
the scan tool
the dash board.
or pistons flying out hood.

Jun 30, 2014 | 1999 Isuzu Rodeo

2 Answers

Transmission shift hard in 2'nd to 3'rd gear on a automanic transmission on a 1999 Isuzu Rodeo


Hello
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

Sep 03, 2012 | 1998 Isuzu Rodeo

1 Answer

Isuzu rodeo 04 loss power on hills will not rev above 2000 revs have checked fuel supplie ok


Take your altenator to AutoZone and have it tested. If the voltage regulator is defective, you might notice your volt meter running up over 14 volts. The extra voltage messes with the electronic shift and your car stays in high gear instead of downshifting.

May 16, 2011 | Isuzu Rodeo Cars & Trucks

1 Answer

1999 isuzu rodeo LS: Revs high sometimes then revs low to the point it stalls. goes back and forth , won't maintain a level idle. I have to press the gas pedal so it won't stall, so either im stalling at a...


Do you have a check engine light? Which engine? My 1996 Trooper with a 3.2 D.O.H.C. is awful for plugging up the E.G.R. I have cleaned it several times! Good Luck!

Mar 21, 2010 | 1999 Isuzu Rodeo

1 Answer

Motor idling to high in my 1999 rodeo . changed


It sounds like it might be your throttle position sensor. Is your check engine lite on?

Aug 05, 2009 | 1999 Isuzu Rodeo

1 Answer

2001 Isuzu Rodeo Check Engine Light flashes when accelerating.


I would change the trans flter, trans fluid, and have the linkage on the trans adjusted.

Jul 21, 2009 | 2001 Isuzu Rodeo

1 Answer

1999 isuzu 3.2 misfire


This could be a problem with the spark plug wires. If resistance is high or the boots have carbon tracks, they could be causing spark to go places it shouldn't. Distributor cap?
Make sure places like that are clean and dry. Check for grease or dirt inside spark plug boots. If all else fails, open the hood in the dark and look for sparks jumping around the engine when you rev it up. If so, replace the plug wires.

May 19, 2009 | 1999 Isuzu Rodeo

1 Answer

1998 Holden Rodeo TR series 5-speed manual 2WD


run the fault codes
look for ambient temp sensor or baro sensor problems

Jun 30, 2017 | 1992 Isuzu Rodeo

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...