Question about Land Rover Discovery

1 Answer

I have a landrover diso and the alam and the imobilisa r stuck on and wont start off kea

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Land Rover Master
  • 14,585 Answers

Turn the ignition on, but don't try to start it. leave it on for ten minutes, then turn it off, don't take the key out. try to start it. you may have todo this three times, rememeber don't take the key out.

Posted on Nov 09, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ok replaced fuel pum on 2003 kea that was not the problem its still doing same thing

run the fault codes to find which sensors are faulty . Have a pressure test done on the fuel manifold to check pump---regulator and filter.

Jan 28, 2014 | Cars & Trucks

1 Answer

What sends power to the coil pack

it should be fed by the ecu check all your fuse's and plugs this could be due to an imobilisa falt

Dec 31, 2013 | Cars & Trucks

1 Answer

My mondeo st24 r rweg wont start on the key? it bump starts, wont even go on jumpleads, no clicking like a norm dead batt would? just nothing, all alam ect still works???

Could be a number of problems:
1: Faulty starter motor (brushes perhaps) or ignition wire to it fallen/broken off
2: Faulty relay
3: If it is an automatic there might be a wire off by the gear change consul
4: Faulty ignition key.

Check in the order and please get back if this has solved it

Thank you

Sep 24, 2011 | 1997 Ford Probe

1 Answer

Anti lock theft alam wont start

try the spare key ,if no spare then make sure that you havent lost the chip out of the key ,if so then call the dealer to have it sorted or a auto locksmith

May 29, 2011 | 1992 Dodge Dynasty

1 Answer

Key fob has stopped working wont turn off alam,immobiliser.

lock the car with the key and hold opver for 30 secs then press/hold unlock button on key fob for 30 secs,should reset....

Mar 21, 2010 | 1995 Saab 900

1 Answer

I connect a 1997 landrover discovery computer to the 1994 landrover discovery and it won't start.

if it is a mems unit , it will need to be programed to the key fob and alarm . (there is no way round it).

May 21, 2009 | 1994 Land Rover Discovery

1 Answer

Landrover discovery wont start but battery is good

This usually is the starter, especially if your truck has had an oil leak going for a while as the oil will run down into the starter and cause it to intermittenly fail. Also check your battery terminals and make sure you have a good connectivity.

Mar 27, 2009 | 1998 Land Rover Discovery

1 Answer

1997 Landrover will not start, battery is good

Bad battery cable connections (loose/dirty). Starter (stuck/dead). Only going by what you wrote, could possibly be engine (seized). I hope not! Most likely it's bad cable connections. Best wishes. Hope that I helped.

Jan 21, 2009 | 1997 Land Rover Range Rover

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers


Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides