Question about 1997 Hyundai Elantra

1 Answer

Ù?ا Ù?Ù? اÙ? ect

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 17,970 Answers

I suggtes visit THIS SITE to know each fault number details...

Ù?ا Ù?Ù? ا - zjlimited_42.jpg

Good luck.

Posted on Nov 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 70 amp battery fuse tripped so I put a 60 amp fuse in it tripped also all connections look good no bare wires ect..


a 60 amp is not rated high enough so that is why it tripped,it needs a 70 amp....if this was a house you could have started a fire

Mar 18, 2015 | Cars & Trucks

1 Answer

Will etc sensor cause overheating in northstar


If you mean ECT (Engine coolant temperature) sensor, yes it can.
The ECT is responsible for turning on & off the radiator cooling fan.
However an ETC (Electronic traction control) sensor typically wouldn't cause the engine to overheat. However if there is a code in the engine computer it can turn off the traction control. So if the ETC is turning off it may be a result rather than a cause.
You'll need to check for codes in the engine computer & if there is one for the temperature sensor you most likely will need to replace it but you'll also need to check the coolant level. If it is low you obviously have a leak.
FOOT NOTE: This engine is well know for its HEAD GASKETS leaking coolant. If you are having persistent overheating conditions & can't seem to locate the cause ie; water pump, radiator, hose ect. you most likely will need to have the head gaskets replaced... & that isn't cheap.

Hope this helps.
FarrouT!

Jul 09, 2014 | 1999 Cadillac DeVille

1 Answer

I had a amp installed into a 2012 Camaro, now when i turn off the car it sometimes turns off and sometimes runs for about 5 seconds after i turn the ignition off. Has anyone seen or know what needs to be...


The AMP has been connected to a power source in conjunction with the ign. system. Change the connection wiring of the AMP to the accessory side of your ign. system. NOTE, Fyi Make sure you know the amperage of your AMP to much amperage can damage your alternator especially when using other systems in the car eg: lights, heater ect ect.

Mar 28, 2012 | 2010 Chevrolet Camaro

1 Answer

CODE #PO128 KEEPS RETURNING AND AC CUTTING IN & OUT


It's a thermostat/coolant issue. The definition is here:


P0128 Engine Coolant Temperature Below Thermostat Regulating Temperature



Possible Causes
  • Check the operation of the thermostat (it may be stuck open)
  • Coolant level is too low, or the coolant mixture is incorrect
  • ECT sensor connector is damaged (check pins for damage, and for moisture)
  • ECT sensor signal circuit has a high resistance condition
  • ECT sensor has failed

Jan 20, 2011 | 2003 GMC Envoy

1 Answer

My speedometer works sometimes & i change the speed sensor & the cluster & it still do the same thing


I don't know if this will help or not , but one time my kids were playing in the trunk and locked themselves in , fortunaly they found the release but not before pulling a ground wire lose in the trunk . when honda is missing proper grounding it freaked out the turn signals , brake lights , third break light ect ect... My honest mechnic found it needed a new ground from the battery to chassies and one in trunk area. don't know if this will help. but took him forever to figure it out and if it had been honda dealer would have cost a fourtune. good luck ... terry

Sep 15, 2010 | 1996 Honda Accord

1 Answer

How do you replace coolant temperature sensor on an 2001 Oldsmobile Intrigue


Removal & Installation To Remove:
ECT sensor 3.5L engine 93174g14.gif

  1. Disconnect the battery ground cable.
  2. Drain the coolant below the level of the engine coolant temperature (ECT) sensor.
  3. Disconnect the ECT sensor electrical connector.
  4. Carefully remove the ECT sensor.
To Install:
WARNING
Damage to the coolant sensor will affect the operation of the fuel control system.
  1. Coat the ECT sensor threads with thread sealer.
  2. Install the ECT sensor. Tighten the sensor to 15 ft lb (20 Nm) on 3.5L engines and 22 ft lb (30 Nm) on 3.8L engines.
  3. Install the ECT sensor electrical connector.
  4. Connect the battery ground cable.
  5. Refill the cooling system using the recommended procedure.
prev.gif next.gif

Aug 29, 2010 | 2001 Oldsmobile Intrigue

1 Answer

Temperature gauge location


Removal & Installation To Remove:
  1. Before servicing the vehicle refer to the precautions at the beginning of this section.
  2. Remove or disconnect the following:
    • The coolant to just below the level of the engine coolant temperature (ECT) sensor
    • The air intake duct (1997-1998) gm_mv_ven_ect.gif

    • The ECT sensor electrical connector
    • The ECT sensor
To Install:
  1. Install or connect the following:
    • P/N 9985253 sealer or equivalent to the threads
    • The sensor
      1. Torque to: 15 ft. lbs. (20 Nm) (2001-2005)
      2. Torque to: 17 ft. lbs. (23 Nm) (1997-2000)
    • The ECT sensor electrical connector
    • The coolant
prev.gif next.gif

Aug 17, 2010 | 2000 Oldsmobile Silhouette

1 Answer

Trouble locating cooling sensor on 2003 gmc envoy


4.2L Engine To Remove:
  1. Disconnect the negative battery cable from the battery.
  2. Drain the coolant from the engine.
  3. Disconnect the engine coolant temperature (ECT) sensor connector. Engine coolant temperature sensor removal and installation gm-04-42-1509.gif

  4. Remove the engine coolant temperature (ECT) sensor from the engine.
To Install:
  1. Apply thread sealer P/N 12346004 or equivalent to the engine coolant temperature (ECT) sensor threads.
  2. Install the engine coolant temperature (ECT) sensor into the engine. Torque the sensor to 12 ft-lb (16 Nm).
  3. Connect the engine coolant temperature (ECT) sensor connector.
  4. Refill the engine with coolant.
  5. Connect the negative battery cable to the battery.
5.3L & 6.0L Engines To Remove:
  1. Drain the coolant from the engine.
  2. Disconnect the engine coolant temperature (ECT) sensor connector. Engine coolant temperature sensor removal and installation removeect.gif

  3. Remove the engine coolant temperature (ECT) sensor from the left cylinder head.
To Install:
  1. Apply thread sealer P/N 12346004 or equivalent to the engine coolant temperature (ECT) sensor threads.
  2. Install the engine coolant temperature (ECT) sensor into the left cylinder head. Torque the sensor to 15 ft-lb (20 Nm).
  3. Connect the engine coolant temperature (ECT) sensor connector.
  4. Refill the engine with coolant.

Jul 08, 2010 | 2003 GMC Envoy

2 Answers

Where is the coolent control sensor located on a 2002 LT trailblazer


2.2L & 2.4L Engines
  1. Turn OFF the ignition.
  2. Drain the coolant system to below the ECT sensor.
  3. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
  4. Carefully remove the ECT sensor.
  5. Installation is the reverse of the removal procedure. Coat sensor threads with thread lock sealant and tighten sensor to 89 inch lbs. (10 Nm).
It looks like this:

5cfd7c8.jpg

Typically screwed into a coolant passage in the intake manifold or the thermostat housing.

Nov 13, 2009 | 2002 Chevrolet TrailBlazer

3 Answers

I have a 2004 VW Beetle. I keep getting the engine diagnostic code P2181. This code is not in my manual. What is it?


Trouble Code: P2181

Cooling System Performance Malfunction
Possible Causes:


ECT sensor has failed ECT Sensor (on Radiator) has failed ECT sensor signal circuit is open (inspect wiring & connector) ECT sensor signal circuit is shorted Cooling system malfunction, or the thermostat is stuck Engine not operating at normal operating temperature EOT sensor is damaged or it has failed

Sep 28, 2009 | 2004 Volkswagen Beetle

Not finding what you are looking for?
1997 Hyundai Elantra Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...