Question about 2006 Mitsubishi Colt

Open Question

No return on intermittent wiper setting 2006 Mitsubishi colt czc. unknown location of the wiper motor? aparently its either under the bonnet, or its a relay on the end of the stalk??

Posted by on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Windscreen wiper not working

check the switch on the steering usualy it becomes faulty after a while and also your window washers could be blocked but try turning it on if you do not hear a buzzing sound the motors needs to be replaced.

Posted on May 21, 2008

  • 1 Answer

SOURCE: Gear lever stiff and does not return to the centre

Hi, Permanant fix, take to garage and get them to replace link shaft on gear change mechanism. Or temp fix, get a tin of WD 40 with the plastic pipe that can be pushed onto the spray nozzle. Get a chopstick or simillar. Put chopstick down side of gear rubber gater. Do this by pulling blue rubber gater away from gear knob and gently inserting chopstick down into gater. Put the WD 40 plastic pipe down gater alongside the chopstick and spray a good amount. then roll the chopstick around to another possition and spray more WD 40. repeat until you have done it four or five possitions covering all round. Job done.

Posted on Aug 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Under harsh braking the car moves from side to side frighteningly

your brakes are bad,take it to a mechanic b4 you kill someone

May 07, 2015 | 2007 Mitsubishi Colt CZC

1 Answer

Colt CZC 2007 boot problem

The back seat normally is removable. Tug firmly at one of the top corners and if it doesn't pop loose then try a bottom corner.removing the seat portion first may give you a better idea as to how the seat back us attached.

If you need further help, I’m available over the phone at

Dec 31, 2014 | 2007 Mitsubishi Colt CZC

1 Answer

Headlights and indicators work intermittently

Check for dirty (corroded) battery connection terminals...Any starting problems?

Sep 06, 2013 | 2007 Mitsubishi Colt CZC

1 Answer

My boot only opens partly, and i have no elec going to the windows?

We had this problem also - we discovered it was one of the relays operating the roof mechanism. When this was replaced and the system rebooted it worked fine. Has anyone else had problems with the boot button working correctly and causing issues with putting the roof down?

Aug 25, 2012 | 2006 Mitsubishi Colt CZC

1 Answer

Is there a tow bar for my 2007 czc convertable

according to handbook itis not possible for a tow bar to be fitted.

Dec 24, 2010 | 2006 Mitsubishi Colt

1 Answer

Hi how do i get to the wiper motor

I am assuming that you mean the front wiper motor.It iis located under the bulkhead where the wipers pass through the body Lift the bonnet and to access the wiper motor do the following.
There is a rubber strip that crosses the bulkhead that seals the wiper grill frame to the body.Gently lift the seal and you will see 3 number fixing screws.One located at either end side and one in the centre.Remove these with a screw driver.There is then a set of plastic rivets that can be pushed up by hand but be careful the heads have to be retained inside the rubber strip.
Once thise is done you can seperate the grill cover from the body and expose the wiper motor.

I done this last week to replace my wiper motor as it had failed due to ice ceasing it up. I was surprized that it did not blow the fuse.Good luck


Dec 01, 2010 | 2006 Hyundai Tucson

1 Answer

Windscreen wiper not working

check the switch on the steering usualy it becomes faulty after a while and also your window washers could be blocked but try turning it on if you do not hear a buzzing sound the motors needs to be replaced.

May 21, 2008 | Mitsubishi Colt Cars & Trucks

Not finding what you are looking for?
2006 Mitsubishi Colt Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

83843 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides