Question about 1990 Dodge Caravan

1 Answer

Supertine belt Dodga caravan1990-91 supertine belt digram.(AC)

Posted by on

  • jfmmrr Nov 02, 2008

    superine belt routing on engine

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For a 3.0 L engine. The belt positions are shown in the 1990 manual which can be found at some public libraries. The critical part is getting the cam shafts in the right positions and that is done by matching the markers on the toothed sprockets of each with those of the engine block. There is no room for a single tooth position out of alignment. Belt goes over the cam drums, under the water pump drum, outside the crankshaft sprocket, inside the belt tightener wheel.

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Serpentine belt diagram 2002 Ford escort zx2


The picture is for a zetec. Let me know if wrong diagram?
26017169-0d1su300qx55v1h5u01lpo5r-3-0.jpg

Dec 21, 2015 | Ford Cars & Trucks

1 Answer

How to put supertine belt on 2004 grand prix


Under the hood there will be a routing diagram for the serpentine belt. Use that as a guide for replacement routing. There is an automatic belt tensioner in the loop. Use an appropriate tool to release the tension on the old belt and remove it from the vehicle. Route the new belt as per the diagram and allow the automatic tensioner to re-tension the belt.

Jan 11, 2015 | 2004 Pontiac Grand Prix

1 Answer

Digram for 1998 GMC savana 2500


diagrapm under hood on emission decal? Goodyear belts usually have a pic on the sleeve

Nov 14, 2014 | 1998 GMC Savana

1 Answer

Need a digram for alternator belt on mk5 golf 1.6 fsi 04 reg thanks


The serpentine belt routing diagram on VW Golf mk5 1.6 FSi m.y. 2004

1. Without A/C (Air Conditioning)

tdisline_902.jpg


2. With A/C (Air Conditioning)

tdisline_903.jpg
AC = Air Conditioning (A/C)
CS = Crankshaft
G = Guide pulley
Gen = Generator (Alternator)
T = Tensioner
WP = Water Pump

Sep 20, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

Install a altenator for a 2006 jeep commander


I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

May 20, 2010 | 2006 Jeep Commander

1 Answer

Supertine belt diagram Ford Escort ZX2 1999 Old brken off now replacing it with new but no picture or diagram showing how its to be installed properly.


If timing belt broke when the engine was running then a belt wont fix your problem as when the belt brakes the valves stop straight away and the crankshaft will still turn over at least 4to6 times adn in that time could AND would bend a couple of valves at least.if
not a lot more problems BUT if you still go ahead with fitting the belt then all the casings are marked to fit the belt and the keyway in crankshaft is always at 12 oclock to start with.. Ron

Oct 13, 2009 | 1999 Ford Escort

2 Answers

Belt on my 19tdi has snapped and i dont know the path


if its a supertine belt the digram is shown under the hood look arround find the pitcure if just reg belt u may or may not haft to remove the other ones to get it on like say if its in the back pulley its got to bee in line with the pully on the moter u should have a slide arm on the alt with about an 1/2 eanch bolt loosen that the alt will give just enuif to get it off put back same way u take off a#1 in tn

Apr 04, 2009 | 1997 Volkswagen Passat

2 Answers

Supertine belt


Some of these have a motor mount that has to be removed in order to take the belt off. I am assuming that you have probably gotten that far and need to know why the belt is wrapped aroung this mount? Hope this is helpful.

Feb 01, 2009 | 1998 Oldsmobile Eighty Eight

2 Answers

I need a diagram of 1999 ford contour serpentine belt


8f5f8d7.png
Top one is for a 2.0, with AC, bottom one is the 2.5 with AC.

8ebea63.png

Jan 24, 2009 | 1999 Ford Contour

Not finding what you are looking for?
1990 Dodge Caravan Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...