Question about 2003 Lincoln Navigator

1 Answer

I have an 03 navigator with a suspension problem. Right front air shock fully inflated and will not deflate with engine running and trans in gear.vehicle tries to level out, but right front stiff as a brick while driving. Is there a way to manually deflate air bag to level out vehicle?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had same problem check ride height sensor on the right front mine was stripped ....Bad news theyare 300 bucks each.

Posted on Dec 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Range Rover l322 My front air supension is iactice/inflates then deflates whilst the back remains stable


They have problems with the air bag shocks leaking. The shocks typically have a large bladder bulit into them that will over time develop leaks causing the problem you describe. could be a damaged line to the shock but most often the shock. Start the car and run until it inflates. Stop the vehicle somewhere quiet then put your head by the top of the wheel that deflates. Listen and you should head an air leak. It usually requires replacement of the shock to fix.

Dec 06, 2013 | Cars & Trucks

1 Answer

My Lincoln Navigator air suspension went flat after we replaced all four tires, it won't air back up...please help!!!


AIR COIL SPRINGS WILL DEFLATE AND BE DAMAGED IF YOU DID NOT TURN OFF AIR SUSPENSION SYSTEM BEFORE RAISING VECHICLE AND CHANGE TIRES IF YOU DONT TURN OFF AIR SUSPENSION IT WILL CAUSE AIR SPRINGS TO OVER INFLATE CAUSE AIR SPRING SPRING DAMAGE.

Oct 16, 2011 | 2004 Lincoln Navigator

2 Answers

2000 navigator: sit higher on one side than the other.


the air ride suspension has level sensors under the vehicle, one of the sensors must be bad making the truck deflate the airbag or inflate it too much. you may need to have someone with a scan tool to access the air suspension module and check for fault codes. you can try turning the air suspension switch off for about an hour to see if the system will reset. the switch is located under the dash on the right side kick panel.

Aug 03, 2011 | 2000 Lincoln Navigator

2 Answers

I replaced the air shocks on my Olds Silhouette with no problem and thought the problem I had (van sitting very high in back) was solved. Rode great first week or so afterwards. Now it is back to shocks...


Check the bleed port on the controller, it may be plugged with dirt. or the controller may have failed. A full funtion scanner would help find the problem.
An other option is to by-pass the auto- leveling system and install a manual scrader valve in the air line, this would allow you to add and remove air with any source. They are availble at most autopart stores.

May 12, 2011 | 2000 Oldsmobile Silhouette

2 Answers

04 lincoln navigator, Air ride problem. Driverside front and rear bags appear fully inflated. The passenger side looks normal height. When I shut the truck off driverside stays jacked up and passenger side...


My suggestion to you and all the other folks leaving questions on this board about collapsed air suspension systems in luxury cars is to fix that one by replacing it with a real spring and shock system which you can buy at www.strutmasters.com if it is economically feasible, then sell it and avoid air suspensions systems like the plague. There are legions of old 70s Citroens still sitting idle 30 years later on collapsed air suspensions systems in garages and barns all over the country which cars the buyers can't let go because they cost so damn much. Get a coleman air mattress and use it every day, see how long it really lasts.

Dec 12, 2010 | Lincoln Navigator Cars & Trucks

2 Answers

My licoln navigator front suspension is not working..stays deflated


First, you should have a warning light telling you it is not working. There is a switch for the air suspension underneath the glovebox-right hand side or in the rear hatch area on the left panel..make sure it's on. If all 4 air bags are deflated it could mean the air pump or actuator is malfunctioning.

Dec 13, 2009 | 2004 Lincoln Navigator

1 Answer

My airride on 2000 lincoln navigator will inflate but not deflate


MY 2000 LINCOLN CONT INFLATED A MONTH AGO AND WILL NOT DEFLATE. THE LIGHT COMES ON SAYING CHECK AIR RIDE SYSTEMS. HOW DO I DEFLATE?

Apr 11, 2009 | 1999 Lincoln Navigator

2 Answers

93 Subaru Legacy front suspension problem after CV joint replaced


the air bag is not ok, this is exactly what they do when they have a leak, these air bags are shot at about 100,000 miles, they start to leak at the creases, u will see cracks there.

Mar 26, 2009 | 1993 Subaru Legacy

1 Answer

Rear air ride shock over inflate and will not deflate


I would recommend going to strutmasters.com and taking a look at the conversion kits. these convert you from the airbag to a powder coated American made steel coil spring that is guaranteed to last the life of the car. Airbags and compressors are constantly having to be replaced. Also something alot of people don't know is that theses air suspensions are not meant to be in temperatures above 90 Degrees or below 40 Degrees. That is most of the world. The temperature will cause you to replace alot of bags. and typically when your replacing a bag you are going to have to replace the compressor to because the bag had a hole or small crack in it causing the compressor to over work and it will die. I posted the link below so you can take a look http://www.strutmasters.com/lincoln-suspension-parts-s/1.htm I hope I was of some help Good Luck!!!

Jan 30, 2009 | 1994 Cadillac Fleetwood

2 Answers

Where are the leveling sensors located on a 2003 Navigator?


There is one at each wheel. here is some info

Vehicle Dynamic Suspension The four wheel air suspension system is comprised of the following components:
  • service switch
  • control module
  • two front height sensors
  • one rear height sensor
  • compressor and drier assembly (includes vent solenoid)
  • air lines
  • front and rear air spring and shock absorber assemblies
  • four air spring solenoids
s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The service switch for the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the jack storage area in the rear of the passenger compartment. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.
Air Suspension Pneumatic Diagram 17d59a6.gif
Item Part Number Description 1 5319 Air compressor and drier 2 5B322 Air line T-fitting 3 5B321 Air line union 4 — Air line Y-fitting 5 18945/5311 Air spring and solenoid

Suspension Height Sensor Removal and Installation
NOTE: Front shown, rear similar
  1. s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the LH quarter trim panel. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
    Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Disconnect the sensor arm. 721ed10.gif
3. Remove the bolts and the sensor. b198e3c.gif
4.
  1. Disconnect the electrical connector.
---------------------------------------------------------------------------------------------

Ride Height Adjustments
Special Tool(s) s3j~us~en~file=st2332a.gif~gen~ref.gif Worldwide Diagnostic System (WDS)
418-F224

New Generation STAR (NGS) Tester
418-F052 or equivalent scan tool
Inflation and Deflation of the Air Suspension System
  1. NOTE: Make sure that the air suspension switch is in the ON position
    NOTE: Make sure that a battery voltage of at least 11 volts is maintained while carrying out this procedure.
    Turn the ignition switch to the ON position.
  1. Connect scan tool to the data link connector (DLC).
  1. Select Air Suspension Control Module under Active Command Mode:
    • VENT FRNT to deflate the front down.
    • LIFT FRNT to inflate the front up.
    • VENT REAR to deflate the rear down.
    • LIFT REAR to inflate the rear up.
Calibration
Ride Height Resetting
  1. NOTE: Make sure that the air suspension switch is in the ON position
    NOTE: Make sure that a battery voltage of at least 11 volts is maintained while carrying out this procedure.
    Turn the ignition to the ON position.
    • Exit the vehicle, close all doors and allow the system to vent the vehicle down to kneel height (approximately 45 seconds).
  1. With the ignition remaining in the ON position, shift the vehicle into DRIVE and then back to PARK.
    • Exit the vehicle, close all doors and allow the vehicle to pump to trim (approximately 45 seconds).
  1. Measure the ride height. For additional information, refer to Section 204-00 .
  1. Open the LF door.
  1. Connect scan tool to the data link connector (DLC).
  1. While outside of the vehicle, select the proper vehicle year, model and engine type.
  1. Select 4WAS module.
  1. Using the active command mode, vent or lift the vehicle to achieve the correct ride height.
  1. Select the "Save Calibration Values (Store Ride Height)" scan tool command to calibrate the 4WAS module.
-------------------------------------------------------------------------------

Jan 09, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
2003 Lincoln Navigator Logo

506 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...