Question about 2006 Chevrolet Trailblazer

1 Answer

I have a 2006 chevy trail blazer, the drivers side door, will not lock or unlock, the electric windows will not operate , or the drivers side and passenger side mirrors will not adjust using the controls on the drivers side door panel. is it safe to assume this is oviously electical maybe a fuse, but where would the fuses be located?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 270 Answers

Problems WithChevy TrailBlazers
ElectricalProblems
Some of the mostcommon problems with the TrailBlazer involve the vehicle's electrical systemand accessories. Many drivers have experienced problems with the dashboardgauges, including the fuel gauge, speedometer and "check engine"warning light. Additional electrical problems include power automatic doorlocks and windows that fail to work or operate intermittently. These problemscan be difficult to diagnose as they can result from anything from a faultybattery to problems with the wiring or other electrical components.
Read more: Problems With Chevy TrailBlazers ' eHow.com
A fuse contains a thin metal bridge between two terminals. When too muchelectrical current is drawn through the fuse the bridge melts, breaking thecircuit. This feature prevents damage to electrical components and limits thepossibility of a fire.The Chevrolet Blazer utilizes small fuses to protect thevehicle's wiring harness from overload. These are typically plug-in blades, notthe glass-barrel fuses used in older vehicles.
Location The fuse panel ona Chevy Blazer is located on the driver's side of the firewall beneath thedashboard. Some later models may be equipped with a fuse panel cover. To removethe cover, pull the retaining clips loose on each side and lift the cover fromthe panel. Replacing a Fuse Locatethe fuse you believe is burned out by its label or use the owner's manual as aguide. To remove the fuse, you may need needle-nose pliers; don't put too muchpressure on the fuse or you could crack the casing. Examine the thin metalstrip between the two terminals. If it is broken, scorched or deformed, it mustbe replaced. Read more: Fuse Box Instructions for a Chevy Blazer ' eHow.com

Posted on Nov 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get in a 2006 trail blazer with dead battery electric locks


even electric door locks still have a key slot on the drivers side

Jan 10, 2017 | Cars & Trucks

1 Answer

Trail blazer gear shift button


Could be the brake switch or the shift lock solenoid. You may be able to turn the key lock to the unlock position, move the shifter out of park, then start the engine in neutral.
The shifter and the shift lock solenoid would need to be inspected.

Jun 19, 2013 | Cars & Trucks

1 Answer

Windows and doors wont open close or lock


i have 06 trailblazer chev all discribed is same here what idid ,behind drivers seat
under pull seat are fuses 2 near door silver fuses I pulled them out and put back and windows and door worked only for it will happen again I will replace them and find out if it is the trouble u could try same if it helps

Jun 07, 2012 | 2004 Chevrolet TrailBlazer

1 Answer

Drivers door control panel (power window heated seat locks ect ) what to do none of it is working 2006 chevy trail blazer


Check fuse #10 in the rear fuse panel. If fuse OK, try switching passenger side control module into driver's side. Also check for broken wires in wiring harness that goes between body and driver's door.

Sep 03, 2011 | 2006 Chevrolet Trailblazer

1 Answer

98 Chev Blazer. power lock problem. driver's door would not unlock doors, now it will not lock doors. passenger side works fine


you may just have a bad connection under the lock button under switch panel on your drivers door. check electrical plug in at door lock switch by removing that panel from driver door.it may be that you have to replace that door lock switch .thers only one fuse for door locks and if pass side works, it's not blown.

Aug 19, 2010 | 2001 Chevrolet Blazer

1 Answer

Where is the fuel filter located on my 2004 Chevy Trail Blazer? WE


On 05+ Trail Blazer, the fuel filter is integral with the fuel pump inside of the fuel tank. It is a non-serviceable part. On 02-04s, the filter is on the drivers side frame rail at about the B-pillar. If your trail Blazer is a late 04 which means that it was build close to the 05 Trail Blazer, you may have a non serviceable fuel filter. Good luck and check under your Trail Blazer or look at your manufactured date sticker on the door which would help you indicate if your 04 is a early Trail Blazer and you'll have the fuel filter on the inside frame rail under the driver's door.

Mar 05, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

2008 Chevy Blazer automatic door lock problem


you have a short in the locking system.

Aug 12, 2009 | 1996 Chevrolet Blazer

1 Answer

Chevy Impala Door lock issue


Which is it, 98 Eclipse, or 06 Impala? Either way, your door lock actuator is stuck in the locked position either electrically or mechaically. The way to check this is to remove the door panel and unplug the actuator. If door lock can now be moved then you have an electrical problem (faulty door lock switch or faulty door lock module). If you still cannot unlock door then actuator is mechanically bad and must be replace (usually the case)

May 30, 2009 | 1998 Mitsubishi Eclipse

1 Answer

4 door 2001 chevy blazer front power locks will not work.


SOUND LIKE THE DRIVERS DOOR LOCK SWITCH IS STUCK IN THE UNLOCK POSITION. SINCE THE DRIVERS DOOR LOCK SWITCH OVER-RIDES THE PASSENGER DOOR, I WOULD REPLACE THE SWITCH WITH A NEW ONE. HOPE THIS SOLVES THE PROBLEM. GOOD LUCK. KEEP US POSTED, WE ARE ANXIOUS TO KNOW.

Apr 30, 2009 | 2001 Chevrolet Blazer

5 Answers

DRIVERS SIDE POWER WINDOW 2006 CHEVY EQUINOX


Check inside wiring by the driver's side door hinge. Remove the rubber boot and you will find broken wires. Make a splice and you are fixed!

Dec 27, 2008 | 2003 Chevrolet Equinox

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

1,628 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...