Question about 1985 Mazda RX-7

1 Answer

1985 rx7 the car runs great untill i take a trip with the air on. about 45 minutes into the trip the car will start to sputter and die. when you try to restart it sputters and will not run. if i let it sit for about 15 minutes it will start and run fine for a little while and do this all over again. any ideas?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 42 Answers

Dude change the coolant oil if ters any provision for it...

Posted on Jun 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 Ford Ranger 2.3 starts and idles good. But when put in gear dies until it reaches full temp.


Hmm...........
1985..........
Probably carb? Automatic choke not working? Remove air filter and spray carb with cleaner, Make sure all parts move freely. With engine cold, check automatic choke position. Start and check function as it warms up.

Feb 21, 2016 | Ford Cars & Trucks

1 Answer

Have a 99 Frontier 3.3. Started running real rough, bucking and jerking. Didn't idle. Hard to start when warm.


I have seen a few crank sensors do this. When I pulled them, they had a small crack in them. Don't know where yours is. But guessing under the harmonic balancer.

Dec 02, 2015 | Cars & Trucks

1 Answer

1991 Nissan maxima hesitates


Best guess is O2 sensor is reading too much unburned fue in the exhaust for some reason and leaning out the fuel flow to compensate. Runs when you throw more throttle at it but leans out as you try to hold steady speed. Should throw a code though.

Apr 25, 2013 | 1991 Nissan Maxima

1 Answer

My car routinely dies on me and leaves me stranded.


Check the fuel pressure on the fuel rail on the injectors in the engine should read about 55lbs

Mar 25, 2012 | 1995 Pontiac Grand Am

2 Answers

I have 85 rx7 12a engine carb getting spark and fuel,it will turn but it won't start what could it be.


It takes 3 things for a car to run... spark, fuel, and air. Sounds like you should be looking for a problem with the air, IF it is getting spark and fuel. Food for thought.

Feb 29, 2012 | 1985 Mazda RX-7

1 Answer

My dodge dakota 4.7 starts without any problem and runs great for approximately one minute. It then starts floundering and will die. You can turn it off or wait for it to die, and restart it and it runs...


Sounds like you have a restricted fuel filter that is causing your vehicle to start sputtering because it can't meet the engine's demand for fuel and then dies when fuel is depleted. After your vehicle stops running, fuel starts seeping by and you can start it again with ease hot or cold and you get the same results moments later if this sounds right replace your fuel filter.

Mar 30, 2011 | 2003 Dodge Dakota Club Cab

1 Answer

1987 rx7 starts and runs wont rev over 2500


dirty or clogged injectors or fule filter i just had the same problem

Apr 22, 2009 | 1987 Mazda RX-7

1 Answer

1985 rx7 13b will not hold idle


A large rubber hose feeds air to the large block with "RE-EGI" cast into it. Between that intake hose and the RE-EGI block, called the dynamic chamber, is the throttle valve. You can adjust the idle speed by adjusting a screw in the top of the throttle valve to 800 rpm.

Feb 18, 2009 | 1985 Mazda RX-7

2 Answers

Car dies seconds after it starts


possible tps sensor or iac valve you can pull neg cable pull plug off iac pull it out clean iac reinstall if it runs thats ur problem

Dec 07, 2008 | 1995 Oldsmobile Achieva

2 Answers

Runs for 45 minutes and wants to die


Try pouring a little water over the base of the coil and if the car stops running its the coil ,Common problem

Oct 18, 2008 | 1994 Chevrolet Cavalier

Not finding what you are looking for?
1985 Mazda RX-7 Logo

Related Topics:

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...