Question about 1990 Ford F150

1 Answer

Where to plug in the computer to my truck - 1990 Ford F150

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Under the hood, above the lf wheel well

Posted on Nov 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Oldsmobile Aurora will not accelerate it is only running on half the motor I changed control model ignition coils plugs iron computer still won't accelerate


Check engine light on ? How does it idle ? Have exhaust check for back pressure . Possible catalytic converter plugged . Also check fuel pressure with fuel pressure gauge . Iron computer ? PCM/ECM engine computer . Testing for plugged clogged restricted exhaust converter

Dec 07, 2015 | Oldsmobile Cars & Trucks

1 Answer

My 1992 gmc only turns over but wont start. it ran no problem before i had to remove computer to access the heater motor. reconnected computer now truck only turns over but doesnt start


Recheck the computer plugs to ensure they are fully engaged. Hopefully, you unplugged/plugged the computer with the battery disconnected since these devices are not intended to be plugged in hot.

Jan 18, 2015 | GMC Cars & Trucks

1 Answer

My 94 cadi fleetwood broughm has a fuel problem. The #6 spark plug keeps flooding with fuel. I replaced the injector, the regulator, the filter what else could it be?


Possibly the spark plug is not firing.. Change the plug. Check to see if it is firing? If its not then find out why? Coil, Plug wire, Plug wire connector, Possibly something as sinister as the computer, but, i doubt that it is the computer.

May 10, 2014 | 1994 Cadillac Fleetwood

1 Answer

Computer reads misfire cylinder 2 and 6


Like Ronald Wilson said it could be something linked to the ignition ( ignition coil, spark plugs or spark plug leads ).
No injectors or oxygen sensor.

Mar 21, 2014 | 2001 Jeep Grand Cherokee

1 Answer

Cougar troubleshooting


Problem may not be the computer, but the PROM a.k.a. the chip. The PROM is the block inside the coputer that the plug plugs into. Unplug the computer, then pull the block out that the plug plugs into

Mar 06, 2014 | Cars & Trucks

1 Answer

Car running rough after spark plugs. Changed on a 2001 Ford Focus


There could be too many reasons. Were the plugs gapped correctly? Are you sure that the wires are correct in order? If so, the next thing you should try is to reset the computer. Sometimes it is possible for the computer to read the old spark plug values even if you replace with new ones. Reset the computer by disconnecting the battery for 10-15 minutes. The reset may cause the computer to take time gathering new spark plug values until few duty cycles. I hope this information helps you!

May 21, 2013 | Cars & Trucks

1 Answer

Where under the hood is the computer plug


Hi,

Not sure which computer plug you are referring to, as your vehicle does not have any computer connections under the hood.

All computers are mounted in behind the front console (in behind the ashtray area), and some computers up inside the sides of the dashboard.

If you are simply referring to your vehicle's OBDII plug, then this connection is UNDER the dash, above the driver's knee.


Cheers,

Sep 25, 2011 | 2001 Mitsubishi Diamante

1 Answer

I unplug my battery , and when I plug again my radio doesnt work , the radio ask me for a code what I do?


Each time you disconnect the battery, the computer loses all codes for security system, radio, etc. If you know the code for radio, enter it into radio using the number buttons. To prevent this again in the future, you should purchase a power cord for the computer. It has the lighter plug on one end and a plug you connect to the car's computer. Plug the lighter plug into any 12 volt plug (not the lighter socket in your car)...you can purchase a portable jump starter with the 12 volt socket. The purpose of this is to keep the car's computer "powered" while you disconnect the battery.

Nov 13, 2010 | 1999 Honda Accord

1 Answer

Changed the battery and truck will not start.Does the computer need to be reset? If so how do I go about resetting computer?


the computer is reset by just removing the battery and let it sit for about 10 minutes then just plug it back in but i think your terminals might be dirty scrub them and plug the battery cabels back and started

Nov 06, 2009 | 2003 Ford Expedition

Not finding what you are looking for?
1990 Ford F150 Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...