Question about 1992 Honda Accord

Open Question

How do i replace the alternator on a 1992 honda accord lx, i had to get a tensioner bolt also and dont know where to put it

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: Alternater replacement

TO remove :

  1. With the ignition OFF, disconnect the negative battery cable.
  2. Remove the power steering pump. Refer to for the complete procedure.
  3. Remove the cruise control actuator but do not disconnect the actuator cable; simply move the unit out of the way with the cable attached.
  4. Unplug the multi-pin electrical connector.
  5. Remove the terminal nut and remove the wire from the terminal.
  6. Loosen the adjusting bolt; remove the alternator nut.
  7. Remove the belt from the alternator pulley.
  8. Remove the adjusting bolt, the lower through-bolt and the small support stay.
  9. Support the alternator. Remove the upper through-bolt and remove the alternator.
  10. If desired, remove the alternator mounting brackets.
  11. If the alternator brackets were removed, reinstall them. Coat the bolts with a thread sealer or liquid thread lock. Install the bracket bolts and tighten them to 36 ft. lbs. (50 Nm).
  12. Fit the alternator into place. Install the upper through-bolt and tighten it to 33 ft. lbs. (45 Nm).
  13. Install the small stay, the lower through-bolt and the adjusting bolt. Make certain the adjusting bolt is properly installed.
  14. Install the belt. Install the alternator nut. Adjust the belt tension. Tighten the alternator nut to 19 ft. lbs. (26 Nm).
  15. Connect the wire to the terminal and tighten the nut.
  16. Engage the multi-pin connector to the alternator.
  17. Install the cruise control actuator.
  18. Install the power steering pump.
  19. Connect the negative battery cable.15463b8.jpg

Posted on Oct 14, 2008

xcanox
  • 32 Answers

SOURCE: thermostat in honda accord LX 1992

The hose that goes from the radiator to the front of the motor. There are two bolts on the engne block. The thermostat is located in there.

Posted on Dec 20, 2008

  • 3 Answers

SOURCE: where does the transmission fluid go in a 1992 honda accord lx st

in the same place that you check the fluid you will probably need a very small funnel

Posted on Jan 09, 2009

  • 29 Answers

SOURCE: how to put a fuel pump on a 1992 honda accord lx

Most likely you have to remove your fuel tank, set it down, and remove the old fuel pump and then put everything back together. I wouldn't advise you trying to do it yourself, if you need further directions. you could damage a slew of sensors and then your probelm just gets worse.

Posted on Jun 20, 2009

  • 113 Answers

SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement

Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 honda accord lx battery keeps dieing aletrnator is going bad starter is almost shot but the fuse under hode the 80amp box one was blow i replaced will that help


check alternator with a multimeter engine with running you should have 13-14.5 volts anything less means alternator is bad.

Apr 09, 2011 | 1992 Honda Accord

1 Answer

I bought a 92 accord LX that was sitting in a lot for 5 yrs. Towed it to my house and replaced the battery and alternator and she fired right up. Drove it for about 30 miles and parked it overnight. the...


dont think timing is jumping as you describe but more like the advance unit on the distributor ,advance timing and it will start but when cold zilch had this before more than once and on more than one make of vehicle ,favourite for this is the old land rover discovery with teh V8 engine ,pull vacumn pipe off the inlet manifold for the advance unit and **** on and you you will see what i mean ,**** and put tongue on end of pipe and it will lose the **** ,.

Mar 13, 2011 | 1992 Honda Accord

1 Answer

I have a 92 honda accord LX. How do i remove and replace the alternator?


Unplug the battery
Loosen and move the power steering pump out of the way (don't disconnect the hoses to it)
Loosed the bolts on the alternator (should be a 14mm on the top bolt, then there will be another lower (hard to reach 12mm bolt) where it pivots. Then, on the lower front of the alternator, there will be two 10mm bolts visible for the alternator belt tension bracket, loosen the RIGHT one as that will release the tension on the belt. You may need to bang or pry to get the alternator to swing out even if you have all the bolts out. They like to lock in there.

Jun 13, 2010 | 1992 Honda Accord

2 Answers

How do i tighten belts on 1997 honda accord?


to tighten the thin belt, loosen the top and then the bottom nuts that go through to the frame. The turn the bolt on top, the closest to the front of the car, clockwise. Then tighten both through bolts up. For the thick belt, loosen the through bolt on the alternator, then turn the long bolt at the bottom, front of car, of alternator clockwise.

Apr 22, 2010 | 1992 Honda Accord

1 Answer

How to tighten drive belt in my 92 honda accord LX?


if it gets louder when the lights are on that means its the alternator belt,and you will have to look under the alternator there you will find the manual tensioner you have to loosen the mounting bolt in order to tighten it with the long tensioner bolt.

Apr 04, 2010 | 1992 Honda Accord

1 Answer

Is there a tension pully for the serpintine belt on a 92 honda accord


no, you set the tension by slackening the bolts on the alternator and using a long handle screwdriver wedged between engine and alternator tighten so that the longest part of the belt between pulleys has about 1/2 to 3/4 inch slack too tight and the belt will snap very soon....too slack and the belt will slip...

Mar 24, 2010 | 1992 Honda Accord

1 Answer

How do i put a tension pully on a 92 honda accord it is missing


The 92 Accord has no tensioner, not should it have. Drive belt tension is provided by moving the belt driven accessories. On some components (alternator, for example) there is a pivot bolt and an adjusting bolt, both of which have to be loosened, then the component is moved away from the engine to put more tension on the belt, and held in place while the adjusting bolt is tightened (then the pivot bolt is tightened). Since there is usually more than one belt, you have to look around in order to determine which components have adjusting bolts (some components actually have a longer bolt which is used, by turning it, to move the component away from the engine and tighten the belt).
I hope this helps you understand the system.

Dec 03, 2009 | 1992 Honda Accord

1 Answer

Where does the transmission fluid go in a 1992 honda accord lx st


in the same place that you check the fluid you will probably need a very small funnel

Jan 09, 2009 | 1992 Honda Accord

1 Answer

Thermostat in honda accord LX 1992


The hose that goes from the radiator to the front of the motor. There are two bolts on the engne block. The thermostat is located in there.

Dec 20, 2008 | 1992 Honda Accord

1 Answer

Alternater replacement


TO remove :

  1. With the ignition OFF, disconnect the negative battery cable.
  2. Remove the power steering pump. Refer to for the complete procedure.
  3. Remove the cruise control actuator but do not disconnect the actuator cable; simply move the unit out of the way with the cable attached.
  4. Unplug the multi-pin electrical connector.
  5. Remove the terminal nut and remove the wire from the terminal.
  6. Loosen the adjusting bolt; remove the alternator nut.
  7. Remove the belt from the alternator pulley.
  8. Remove the adjusting bolt, the lower through-bolt and the small support stay.
  9. Support the alternator. Remove the upper through-bolt and remove the alternator.
  10. If desired, remove the alternator mounting brackets.
  11. If the alternator brackets were removed, reinstall them. Coat the bolts with a thread sealer or liquid thread lock. Install the bracket bolts and tighten them to 36 ft. lbs. (50 Nm).
  12. Fit the alternator into place. Install the upper through-bolt and tighten it to 33 ft. lbs. (45 Nm).
  13. Install the small stay, the lower through-bolt and the adjusting bolt. Make certain the adjusting bolt is properly installed.
  14. Install the belt. Install the alternator nut. Adjust the belt tension. Tighten the alternator nut to 19 ft. lbs. (26 Nm).
  15. Connect the wire to the terminal and tighten the nut.
  16. Engage the multi-pin connector to the alternator.
  17. Install the cruise control actuator.
  18. Install the power steering pump.
  19. Connect the negative battery cable.15463b8.jpg

Oct 14, 2008 | 1992 Honda Accord

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...