Question about 2002 Honda Odyssey

1 Answer

SRS light stays on

I recently had my rear windshield wiper seize up. Did not blow the fuse but ground the gear up. Anyway while working on removing the motor the battery ran down. Charged the battery but now the SRS light will not go off.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have 2002 Odyssey( 59000 miles without warranty). Several months ago the SRS light stayed on after I started the car. Some people said the dealers usually charge $ 80 to 95 to reset the light. Today I sent the car to dealer. After checking the car, they told me the car is under warranty, the parts and repairing are free.

Posted on Aug 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wipers dont work


This is a complex wiper system . Here are all the components involved !
The Wiper/Washer System consists of the following components:
?€¢
Windshield wiper/washer switch


?€¢
Body control module (BCM)


?€¢
Wiper 1 relay


?€¢
Wiper 2 relay


?€¢
Wiper diode


?€¢
Windshield wiper motor


?€¢
Windshield washer pump


?€¢
Windshield washer nozzles


?€¢
Windshield washer solvent container


?€¢
Windshield wiper arm and blade assemblies


?€¢
Windshield wiper transmission


?€¢
WIPER/SW 10A fuse


?€¢
WIPER 25A fuse


Circuit/System Description
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation. The windshield wiper motor park operation is controlled by the BCM. The BCM recieves an input from the park switch to determine wiper blade position. When the wiper blades are at the bottom of the windshield glass in park position the wiper park switch will open and the circuit will be pulled up to B+ by the BCM. The park signal will be pulled to ground by the wiper motor park switch while the wiper blades are not in the park position.
The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high or low
Diagnostic Trouble Codes (DTCs)
The body control module (BCM) monitors the voltage on the windshield wiper switch signal 2 circuit for diagnostic purposes. If the circuit is shorted to voltage while the driver is commanded OFF, the BCM will store DTC B3715. If the circuit is shorted to ground while the driver is commanded ON, the BCM will store DTC B3715. Refer to DTC B3715.
It would be best to have a factory scan tool to diagnose this problem . it would make it easier anyway .
It

Dec 05, 2015 | Cars & Trucks

1 Answer

I got mercedes benz E320 1995: Every morning My windshield wiper not working about minutes later SRS light warning lighs blink on and off right ways after that my radio turn it self on. my windshield wiper...


WHEN I START MY MERCEDES C- 180 MODEL 1997 YHE SRC LIGHT REMAIN ON AND THE AIR BAG LIGHT DOES NOT COME ON , HOW EVER IF I USE DIPPER OR WIPER BOTH DOES NOT WORK INSTEAD THESR LIGHT FLIERS WHEN WIPER LEVER IS PLACED ON OR THE LIGHT GOES OF TILL THE TIME DIPPER SWITCH IS PRESSED

Mar 04, 2013 | 1997 Mercedes-Benz C-Class

2 Answers

Windscreen wipers not working


WINDSHIELD WIPERS


It can be faulty wiper motor or blown wiper control fuse.


Do you hear any kind of noise when you starter the wiper function. If yes then fuse is ok, but issue is wiper motor.

If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring: -----

For complete troubleshooting i suggest you a helpful link with accurate solutions.

-------------

Click the link below: -------




http://alltypesofpartsreplacing.blogspot.com/2012/12/windshield-wipers-windshield-wipers-not.html

--------

These will help.

Thanks.

Dec 09, 2012 | Cars & Trucks

1 Answer

KEEP BLOWING THE FUSE AS SOON AS IT IS ENTERED IN THE FUSE BOX.


If you can pull the plug from the wiper motor and try fuse. If no change disconnect the plug to the electric windows and try fuse. Unlikly to be in dome light circut unless you have had aftermarket sterio system or other accessory fitted recently

Nov 28, 2012 | Cars & Trucks

1 Answer

ABS and air bag warming lights are On. The turn sigal lightswill work.


I think this is the same as a '94-

Try the rear windshield wiper. It is likely on the same fuse with the airbag, if the fuse is blown, the light will come on.

Check with Crysler/Dodge for a recall. There was one that affected caravans about that vintage for a short that develops in the rear windshield wiper that blows the fuse and lights the airbag warning light.

Oct 02, 2010 | 1996 Dodge Caravan

1 Answer

How do I fix a short in the windshield wiper line? I think that's the problem. Wipers won't work. Change fuse. Turn wipers on and fuse immediately burns out again. Went through four fuses, even trying...


First of all disconnect the motor before you change the fuse and then try it out. If the fuse blows out hten you have a fault in the line that goes through the harness. If you are not able to isolate the line cut off and use a new line to the motor. However if the fuse stays fine the it is confirmed that your motor is short. You will need to remove the wiper motor unit and check inside for a short in the motor winding or the cummutators. USe a ggood multimeter to see for short and if it has burned then you will need to replace or rewind as acordingly to the cost feasibility. If the motor was stuck due to a damaged spiral gear or the drive wheel replace and proceed. Hope you try this out one by one. Good day

Jul 30, 2010 | 2002 Toyota Sienna

1 Answer

The fuse that runs my windows, lights and windshield wipers keeps blowing in my 2001 ford expedition, what is the problem?


could be many things. could be a short to ground. find out what wires work on this circuit. and check all the connections and insulation of the wires. if there was any sound system put in or recent electrical work i would double check the quality of that.

Apr 03, 2010 | 2001 Ford Expedition

1 Answer

99 Nissan Quest real wiper runs continually when ignition is on


Principles of Operation
Operation of the windshield wiper and washer is controlled by the front wiper/washer amplifier assembly. The front wiper/washer amplifier input comes from the multifunction switch by means of a voltage divider circuit. A constant voltage is applied to the multifunction switch by the front wiper/washer amplifier. When the multifunction switch is moved into the LO, HI, or intermittent position, the voltage is directed through a series of resistors. This results in various voltages being returned to the module for each switch position. The module then grounds the appropriate circuit, based on the voltage signal received back from the multifunction switch. This causes the wipers to run intermittently, or at the appropriate speed. Voltage is supplied to the wiper motor by the CJB fuse F46 (20A).
When the multifunction switch wash button is depressed, it bypasses all of the resistors returning a full voltage signal to the module. The module then grounds the appropriate circuits to operate the windshield washer pump for as long as the switch is depressed. The windshield wiper speed is dependent on the position of the windshield wiper/washer switch.
Voltage for the windshield washer pump is also provided by CJB fuse F46 (20A).
Operation of the rear wiper and washer is controlled by the rear wiper/washer switch.
Voltage is supplied to the rear window wiper motor by the fuse junction panel fuse F44 (10A).
The rear window wiper motor ground is made or broken by the rear wiper/washer switch. When the rear wiper/washer switch is moved into the WIPER position, it grounds the rear window wiper motor circuit, causing the rear window wiper motor to run once every 10-15 seconds.
Voltage to the rear washer pump motor is also supplied by the CJB fuse F44 (10A). The rear washer pump is directly controlled by the rear wiper/washer switch which makes or breaks the ground for the washer pump motor, depending upon its position.
If the vehicle is equipped with a movable liftgate glass, a liftgate glass switch is utilized to prevent rear window wiper operation when the liftgate glass is open. This same switch also causes the rear window wiper to drop down approximately three inches when the liftgate glass latch is released.
------------------------------------------------------------------------------------------
  • The wipers stay on continuously — rear wiper
  • Circuit.
  • Rear wiper/washer switch.
  • GO to Pinpoint Test L .


---------------------------------------------------------------------------------------------
Measure the resistance between rear wiper/washer switch C288 pin 6, component side and rear wiper/washer switch C288 pin 2, component side.
  • Is the resistance less than 5 ohms with the switch depressed, and greater than 10,000 ohms with it released?
sxv~us~en~file=arrow.gif~gen~ref.gifYes GO to L2 .
sxv~us~en~file=arrow.gif~gen~ref.gifNo INSTALL a new rear wiper/washer switch. TEST the system for normal operation.

Measure the resistance between rear wiper/washer switch C288 pin 6, circuit WB08 (BU/YE), harness side and ground.
  • Is the resistance greater than 10,000 ohms?
sxv~us~en~file=arrow.gif~gen~ref.gifYes INSTALL a new rear wiper /washer switch. TEST the system for normal operation.
sxv~us~en~file=arrow.gif~gen~ref.gifNo REPAIR circuit WB08 (BU/YE). TEST the system for normal operation.

65501dd.gif 7e9d21a.gif

Dec 08, 2008 | 1999 Nissan Quest

1 Answer

97 mazda protege dx wipers keep blowing fuses


try grounding the wipermotor housing.

Nov 14, 2008 | 1997 Mazda Protege

1 Answer

Honda Pilot 2005 windshield wiper stopped working


What you are doing gets things working again, but its just not safe. If the wiper motor or wiring has a short in it, it creates heat, and the wires leading to the wiper motor are not set up to handle the amperage that the higer rated fuses are sending trough them. Its only going to get worse, and if you put in a larger fuse, it will get hotter. Eventually you will have a fire. You need to find out what is causing the issue and get it resolved. I am not sure that the SRS(airbag) system will work with the light on either. Id take it to another shop if you cant afford the repair work at the honda dealership. Good luck.

May 18, 2008 | 2004 Honda Pilot

Not finding what you are looking for?
2002 Honda Odyssey Logo

1,179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...