Question about 2004 Ford Ranger

Open Question

My 2004 Ford Ranger XLT 4WD 4.0 L V6 automatic transmission will develop a bad engine miss about 2 minutes after it is started for about 30 seconds and then will run just perfectly after that. It does this every time it is allowed to cool off for several hours. The Check Engine Light has never come on during this. The light does work though. It has 30,000 miles. It has done this for awhile (6 months) but seems to be getting worse.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2002 Ranger Cruise Control

p 1780 tcs

Posted on Jan 25, 2009

lester482529
  • 226 Answers

SOURCE: miss fire

the fuel injector may be faulty in that cylinder

Posted on Jun 07, 2009

  • 651 Answers

SOURCE: 1992 Ford Ranger XLT V6 wont start without ether

first go to an auto partstore and have the code checked. most do it for free. could be coil, fuel pump, fuel filter, air filter or even a bad gas cap. but the dianogstic test should pin point the problem.

Posted on Jul 01, 2009

  • 63 Answers

SOURCE: 1994 ford ranger 2.8 v6 engine automatic 4 wheel

That could Be caused by the TFI module Located on the side of the distributor its grey module that requires a special tool to remove the two screws

Posted on Aug 13, 2009

  • 1 Answer

SOURCE: 2000 Ford Ranger XLT electrical problem

I suggest the possibility of a loose connector, maybe the main engine connector remove inspect pins apply diaelectric compound and reconnect the connector with care to assure good contact with all pins.

Posted on Nov 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2004 ford explorer xlt v6 4.0l gas. need a o2 sensor diagram. I need names and description. for example bank 1 sensor 2 after catalytic converter


https://www.google.com/search?q=1998+BMW+318i+Automatic+Torque+settings+Head+gasket&biw=1360&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwie8o3ix8_QAhUJRSYKHdIXBrkQsAQIKQ#tbm=isch&q=2004+ford+explorer+xlt+v6+engine+firing+order

Hope this helps

Bank two are the even cylinders. Follow exhaust manifold on the side. You will find an O2 sensor just after or on the manifold, before the catalytic converter. Then, look after the catalytic and you should find another O2 sensor, this is the one you mention in your post.

Nov 30, 2016 | 2004 Ford Explorer XLT

1 Answer

What is the firing order on a 92 Ford ranger xlt 3.0 v6


The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 ) The distributor rotor turns CLOCKWISE ( 1 - 4 - 2 - 5 - 3 - 6 ) The marked # 1 position on the distributor cap faces towards the firewall and slightly towards the passenger side The engine cylinders / spark plugs are numbered : passenger side of engine , front to rear , 1 , 2 , 3 and drivers side of engine , front to rear , 4 , 5 , 6

Dec 08, 2010 | 1992 Ford Ranger

2 Answers

Will a 87 ford ranger v6 4 wheel drive trans. fit in a 86 ford ranger 4 cyl 4 wheel drive


If automatic transmission wont work engine block's are not the same, if stander transmission you could swap out bell housing held on with four bolt's from one to the other. Good luck and hope this was very helpful.

May 19, 2010 | 1986 Ford Ranger 2WD

1 Answer

Fluid capacities and fluid specs


2000 TOYOTA TACOMA 2.7L 4-cyl Engine Code 3RZ-FE

Engine Oil Grade 1......API* All TEMPS......5W-30 Optional ..10W-30
Engine, 2WD, with filter..........5.5 liters
Engine, 4WD, with filter..........5.4 liters

Manual Transmission,......GL-5/ GL-4 All TEMPS......75W-90
Automatic Transmission,A340E......AF3 / A43D......AF3

Differential, Front/ Rear W/ ADRD......GL-5 ALL TEMPS......75W-90
Differential, Front Less ADRD......GL-5 ALL TEMPS......80W-90

Transfer Case,......GL-4/GL-5 ALL TEMPS......75W-90 Gear oil.

Capacity:
Cooling System, Initial Fill..........8.5 liters
Automatic Transmission, A340E Initial Fill..........1.6 liters
Automatic Transmission, A340F Initial Fill..........2 liters
Automatic Transmission, A43D Initial Fill..........2.4 liters
Automatic Transmission, Total Fill
4 speed A340E..........7.2 liters
4 speed A340F..........10.1 liters
4 speed A43D..........6.5 liters
Manual Transmission, ..........2.5 liters
Differential, With ADRD Front..........1.2 liters
Differential, Without ADRD Front..........1.1 liters
Differential, 2WD V6 Rear..........2.6 liters
Differential, 4WD Extra Long Rear..........2.5 liters
Differential, Short WB With LSD Rear..........2.7 liters
Differential, Short WB Without LS Rear..........2.6 liters
Transfer Case, Electronic..........1.2 liters
Transfer Case, STD..........1 liters


Feb 09, 2010 | 2000 Toyota Tacoma PreRunner

4 Answers

Does the 3.0l transmission fit on the 4.0l engine


Hiya,

There are 5 automatic transmissions used in the Ford Ranger, Explorer and Mountaineer. They may be identified by checking the transmission code on the Safety Standard Certification Label attached to the driver's side door post, in the space marked Trans. The transmissions can also be identified by a tag attached to the lower left hand extension attaching bolt. The transmission codes are as follows:
  • 1991–94 code T is for the A4LD transmission
  • 1995–99 code T is for the 4R44E (2.3L, 2.5L & 3.0L) or 4R55E (4.0L) transmission
  • 1996–99 code U is for the 4R70W (5.0L) transmission
  • 1997–99 code D is for the 5R55E (5-speed automatic) transmission
So, what you need to do now is...establish from a FORD workshop, whether both the A4LD and 4R55E transmissions share the same components and mounting dimensions.

Cheers,

Scott

Nov 12, 2009 | 1992 Ford Ranger

1 Answer

4WD seems stuck, RPMs up to 4000 at 35 MPH


There is a motor on the rear of the tranny that switches this. check the plug and it is easy to remove the motor and test its operation. then there is a keyway that you can easily turn with a small blade screwdriver...., Odd but there are no vacuum hoses going to the transmission... OH rats unless it is an automatic... but still the 4WD shifting is electrical..

Jan 04, 2009 | 2003 Ford Ranger Regular Cab

Not finding what you are looking for?
2004 Ford Ranger Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...