Question about Nissan Sentra

Open Question

Where is the location module airbag for nissan sentra 2010

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: 1996 nissan sentra

Find the big hose that comes out of the top of the radiator and follow it to the engine and that is where the thermostat is located. My advice is to be sure to get a factory thermostat and rubber gasket as it makes installation much easier. I have done it both ways and the factory one is easier to install.

Posted on Jun 29, 2008

Ad
bitchn65cuda
  • 70 Answers

SOURCE: locate fuel filter on 2007 nissan sentra 2.0 liter engine

its in the gas tank but it doesnt have to be changed!!!YAY

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: 06 kia sportage airbag control module

If your refering to the light on top of the dash that says "psgr air bag not connected" here;s the deal.

The module is activated when someone sits in the seat. Turn the key on and the notification will light. Go around to the psgr side of the car and sit in the seat and the light should go out.

Posted on May 03, 2009

jj127
  • 37 Answers

SOURCE: 2000 Chevrolet Malibu LS airbag problems

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

Posted on Jun 20, 2009

johnjohn2
  • 5763 Answers

SOURCE: i need a fuse diagram for a 2002 nissan sentra

this is all i could find,the fusebox locations and fuse location #, but nothing about which fuse is which, i hope this will help,9064463.gifb2bc6d0.gif4587b25.giffac1af0.gifb6b500c.gif

Posted on Feb 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Sentra 2010 blower resistor location? Is there an easy way to get at it without removing the entire dash?


if it has blower resistors in a pack , they will be in the blower case to be cooled with blower air
it has a modular control talk with a service center as to where it is and how to get it out

Sep 26, 2016 | 2010 Nissan Sentra

1 Answer

LOCATION OF AIRBAG CONTROL MODULE THX


How To: Remove SRS Airbag Computer Control Module ...

? 5:12
https://www.youtube.com/watch?v=kPduYbtAYds
Jun 23, 2012 - Uploaded by Charley O'Neill
This video will show you how to locate and remove airbag control ... How To: Remove SRS Airbag Computer ...Missing: thx

how to know or diagnose airbag SRS air bag control module ...

? 4:55
www.youtube.com/watch?v=2MdTkmk4FiQ
Feb 3, 2010 - Uploaded by vehix411 http://karmanauto.com/product/honda-and-acura-airbag-module-reset- ... will show you how to reset and or ...

Oct 30, 2015 | 2007 Toyota Tacoma

1 Answer

How to turn my airbag light off on my 2010 Nissan Sentra


use the scanner and scan for codes do the necessary repairs and then use the scanner after the repairs are done to clear the code.

Feb 10, 2015 | 2010 Nissan Sentra

1 Answer

Nissan sentra 2010 computer with gauges turns off


Hi. This sounds like a body control module issue. At a nissan dealership they should be able to reprogram the bcm. There is often new updates available. I am a nissan tech but not at work right now. If you want, I can check to see if there is any bulletins on this when I get to work in the morning.

Feb 18, 2014 | Nissan Sentra Cars & Trucks

1 Answer

Airbag module location for 2010 acura tl


Where is the airbag module located at in a 2010 Acura tl

Aug 28, 2012 | 2008 Acura Tl

1 Answer

2010 sentra transmission fluid pressure sensor location


First off do not listen to Autozone, they are very quick to spend your money, they are screen readers not trained automotive technicians. No fault code with few exceptions tells you exactly what is wrong, it can be the sensor, the wiring to it or the control module (computer) that has the problem. The pressure sensor is inside the transmission a really dirty big job to access, so have a TRAINED technician look into this before any parts are replaced.

Jul 19, 2012 | 2010 Nissan Sentra 2.0

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

639 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...