Every time you turn to the left it makes a noise

if hub bearing replacement did not fix the noise

when noises are on left and right turns
that has CV joints /drive shafts
would say they are the issue
replace both sides

and replace the left hand hub bearing at the same time

i have been fooled by this one way to many times. when a wheel bearing or hub assesembly is making noise, it will sound like it is comming from the other side. i do not know why this is. but one test will prove if and which one. when growling noise occurs, notice, when turning left or right, does noise get louder and quieter as you turn? if so then it is wheel bearing. when turning left the right side will make more noise. when turning right the left side will make more noise. if always the same then, tires or transmission need addressing. the cv axle does not make a growling noise, unless front wheel drive car does not move, it makes a clicking or poping noise. sorry but at least you dont have to replace other axle

I’m happy to assist further over the phone at https://www.6ya.com/expert/christpher_f760d0f18f8eedc3

use an electronic stethoscope to find it , or 2 persons.
no body here can find noise, ,impossible.

Looks like it's time for a right wheel bearing, or however many there are in the hub. I'm assuming you do not have a 4 wheel drive. Remember, if it makes noise when turning left, you are "loading" the right wheel bearing. ( Shifting more weight to the side inside your turn). Think this way. When turning left at a higher speed, the left tire might even come up off the ground! That puts all the weight on the right. If you've 4 wheel drive, could also be c.v. joints, or universal joints.

Check front tyres & wheel bearings espesially the R/H/F. Feel tyre for high / low spots on inside & jack up & spin wheel if you get noise while jacked up it is not the tyres but wheel bearing or brake pads but more than likly a crook bearing by the sound of it. It needs to be tended to ASAP

Does it make this noise every time you push in on the clutch, or just when coasting?
If it always makes noise when you push in the clutch, it could be the throw out bearing.
But if only coasting and not when turning left a little, then a front wheel bearing is more likely.
The brake will also wear faster, get hotter, feel a little spongy at first hit, and the brake pedal will vibrate if the wheel bearing is going. But if it is a wheel bearing, you can wait until it is worse.

its due to low/no fluid level in the power steering reservoir.Check the fluid in the power steering. If it is low the car will make noise when you turn the wheel. the internal parts gets rubbed hard and noise occurs. refill the fluid and let it reset for some time then try it will get the fluency to move smooth and noise will get stopped. -------- This will help. Thanks please keep updated.please do rate the solution if helped.thank you for using fixya.

That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

You also could have received a bad axle. Sometimes the rebuilds don't hold good tolerance and can make the same noise you are trying to get rid of. Is it full-time 4wd? Maybe the driveshaft ujoint also.

Does it make a clicking noise ? if so sounds like a CV shaft look at the rubber boots and make sure they arent torn