Question about 1985 Chevrolet S-10 Blazer

1 Answer

I have a 85 s10 blazzer 2.8 . I just had a new carb put on and everything was going good then I started having this isue. At idel it runs good but when i drive it it starts gasping, choking. I dont have any touble codes popping up and i cant get it to have this problem in the drive way when im under the hood

Posted by on

Ad

1 Answer

You need to have the aluminum knocked off the bottom mounting plate,if it isn't,so you can remove the cap on the idle adjusting screw.
About 1 and 3/4 turns out.from seated, will be close, to getting it running and thru inspection.
About 12 degrees on initial timing. (I know it says 10)

I only rebuild my OE Carbs,never use a replacement
Is yours an Electrical California Version?

Also check that the coke is open when warmed up
May have to drill out rivets and tap for screws, on the coils cover,then adjust, to get it open

Posted on Nov 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Don't here the fuel pump go on when i turn the key on on already checked fuses..been sitting for almost 2 yrs...when stopped everything running good.. got new battery for it but didn't here fuel p.


Hi Baltazar:
Have you tried to start it?
It wouldn't hurt to give it a SMALL prime. Remove the air filter and put a thimble or 2 (NO MORE) into the carb ant then try to start it. Sometimes they just need a bit of encouragement.
After sitting for 2 years the gas in the carb, fuel fump, and tank may have gelled, so there is a possibility that you will have some cleaning and flushing to do.
Work patiently, and stay safe.

Apr 13, 2015 | Cars & Trucks

1 Answer

84 s10 1.9


clogged cat converter

Jan 26, 2014 | 1984 Chevrolet S-10

1 Answer

84 s10 1.9


Check if the timing advance is working. The vacuum advance on the distributor may be bad. A timing light should show good advance when engine is revved up.

Jan 26, 2014 | 1984 Chevrolet S-10

1 Answer

1996 GMC jimmy rough idel and dieing when driving.


i have seen many strange things happen with the distrib cabs on these

Aug 22, 2012 | 1996 GMC Jimmy

1 Answer

'87 300ZX(NON-TURBO) STALLS OUT/BOOGS DOWN


overhaul of carb needed, check the vaccum advancer for wear n tear, rapace f necessary fo

Jul 19, 2009 | 1987 Nissan 300ZX

1 Answer

Wont idel when warmed up


seems to me there may be a problem with the transmission, because you say it runs fine in neutral and dies when you put it in gear!!!
only logical thing if everything else you mentioned has been ruled out!!!

Jun 18, 2009 | 1995 Dodge Dakota

1 Answer

Test for fuel cut off relay


Sam so right now you have crank no start,or no crank , no start. Not clear.
If its no crank no start.Your looking at battery, cables, ignition switch , starter relay.
If its crank no start, you know that B+ is making it to starter. Ok now listen for fuel pump to buzz or hum when you put key in ignition and turn to on position. No buzzing or humming fuel pump or relay.
make a set of jumper cables run them from battery to fuel pump, Does the pump run? If yes. The pump is good relay is not. If pump doesn't run then its the pump. Remember when you do this test you don't need the key in ignition Battery doesn't have to be connected, because your bypassing the control circuit.

Jan 24, 2009 | 1987 Honda Prelude

Not finding what you are looking for?
Cars & Trucks Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...