Question about 1999 Nissan Quest

1 Answer

My girlfriend was driving, and the van just shut down and stopped working...while driving...still have full battery function, but will not start...comes close to starting, but will not turn over...help!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 4,369 Answers

It is the distributor. ebay rich porter $200

http://groups.yahoo.com/group/villagerquest/

Posted on Dec 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE NO DRIVERSIDE HEAT


The actuator that 'blends' cold with hot is stuck in the cold position. There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need cold.works just fine....

Nov 21, 2011 | 1997 Cadillac Eldorado

1 Answer

I have a 2003 Buick Rendezvous. The drivers side blows hot air and the passenger side blows cold air. The car has that dual zone climate control. I have no clue where to start.


The actuator that 'blends' cold with hot is stuck in the cold position. There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need cold.works just fine....

Nov 10, 2011 | 2003 Buick Rendezvous

1 Answer

How do i reset climate control


There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need cold.works just fine....

Nov 01, 2011 | 2008 Cadillac STS

1 Answer

I have 2003 GMCHD 2500 and the heater is not blowing hot air, turned off the truck and started it again and it will blow hot for 5 seconds and turn to cold again. have you come across this problem before


It is running a test cycle and getting stuck. There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need cold.works just fine....

Nov 01, 2011 | 2003 GMC Sierra

1 Answer

I was driving down the road at about 55 mph, and then it seems that the transmission slipped into neutral, or what I assumed was neutral. I coasted to a stop, put the van in park and shut it off. When i...


If the Battery warning lamp is coming on, the engine stalls and the starter just clicks, and you have to have it jump started to get going again [I assume anyway] then it sounds like the charging system isn't always working and the battery is getting drained to the point that the engine computer and fuel pump quit working. Low voltage can also affect how the transmission functions and when the transmission goes into a default position you'll only have Park, Reverse, Nuetral, and 2nd gear. [it may seem like first gear however] I'd start by having the charging system tested to make sure it's capable of putting out the full amperage and voltage that it's rated at and have all the battery connections and cables looked over to be sure they are capable of delivering all the current needed to run everything. I think you'll probably find the fix for most of the problems in that area. Hope this helps and good luck!

Dec 21, 2010 | 2000 Dodge Grand Caravan

1 Answer

My girlfriend was driving to class when her speedometer, blinkers and cd player stopped working. She pulled into a parking lot and turned it off and then back on, the car didnt run. When i got there 10-15...


ok, try cleaning the battery posts, and if its older then three years change the battery. Once everything is ok check the charging system of the vehicle. The reason your power steering/brakes went out is the engine was off, power sterring works of a pulley on the engine and the power booster for the brakes works off the engine vacuum.

Aug 28, 2009 | 1998 Ford Escort

1 Answer

Van wont start


clean off the battery terminals and make sure it has a full charge also check out the drivebelt

Feb 28, 2009 | 1996 Dodge Caravan

1 Answer

2000 dodge van 5.2 auto shutdown relay tunes van off as i am driv


the auto shut down relay is not like a fuse that can shut the engine off the name it has actually has not much to do with its function.. the relay is controlled by the computer .. its main function is to stop run-on and turns off o2 heaters power to coil and injectors if you had the key in the run position and engine not running your battery would dies faster than a drive in movie.. but anyway if your stalling and think its the relay failing just swap it with another one that looks the same from the PDC.. what you may have is a bad fuel pump or even a crank sensor have you had it scanned for codes? sometimes but not always you may have a code for lean upstream o2 if the pump is failing but not always.. and for the crank sensor you may have a crank shaft position sensor performance or cam/crank sensor code ..

Feb 04, 2009 | 2000 Dodge Ram 1500 Truck

2 Answers

Dodge ram van e250 dies while driving


try changing the coil- sometimes they get hot and break down- once they cool off vehicle will start and run until they get hot again

Jul 05, 2008 | 1992 Dodge Ram 250

Not finding what you are looking for?
1999 Nissan Quest Logo

Related Topics:

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...