Question about Mitsubishi Endeavor

Open Question

I am trying to order a part for the passenger side wiper arm on my 2004 endeavor. I am not sure if the part is a bushing or a bearing. It is the point of the arm that is attached to the drive spindle. Is there a specific name for this or a part number?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 713 Answers

SOURCE: 2005 Nissan Murano - wiper arm

Check the nut, that holds the wiper arm on. It may be loose. Tighten nut and recheck. Let me know what you find.

Posted on Dec 01, 2008

  • 373 Answers

SOURCE: wiper arms dont move

there are little teeth on the connection if they are worn then you need to find out hoe to replce them

Posted on Feb 03, 2009

localwonder
  • 6784 Answers

SOURCE: how to a remove the wiper arm

Most windshield wiper arms usually fail due to a loose nut or rusted and worn out parts. Fixing this depends on how the wiper arm attaches to the vehicle. Fixing wiper arm failure is usually as easy as tightening a nut or replacing a worn out or rusted part.

Here is a step by step guide on fixing this issue.

Step1 49869_65x95_aspect.jpg Mark the existing wiper position on the windshield using a crayon. This will help you align the wiper arm correctly when you install a new one. Alternatively you can use the Trucks own markings. At the bottom center of the windshield you will see writing and three small dots. The wiper should rest on top of these dots. Step2 49870_65x95_aspect.jpg Follow the wiper arm down to where it connects with the Truck. You should find a hinged cap at the end. Step3 49871_65x95_aspect.jpg Lift this cap to reveal the nut and screw underneath. Step4 49872_65x95_aspect.jpg Use a wrench (or socket and ratchet) to loosen the nut. Step5 49873_65x95_aspect.jpg Remove the nut completely, leaving the screw stud exposed and the wiper arm free to be removed. Step6 49875_65x95_aspect.jpg Lift the arm straight up. Wiggle the arm and pull upwards at the same time until the arm slides free of the screw. If it seems stuck, push the arm back down and proceed to Step 7. Step7 49876_65x95_aspect.jpg Use a battery cable puller to pry the arm loose. Arrange so the large puller screw cap sits on top of the wiper arm screw. The outside arms have flat fingers that should be fitted underneath the wiper arm. Step8 49877_65x95_aspect.jpg Grasp the handle at the top of the puller and turn clockwise. The puller screw will push down on the wiper arm screw and simultaneously pull up on the wiper arm. A few slow turns should pop the wiper arm free.

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: The windshield wiper mechanism arm fell off.

snapped wiper transmission arm back into place and it works just fine. thanks for your concern. will not need help after all...

Posted on Jan 22, 2010

  • 1 Answer

SOURCE: Rear Wiper does not move

My 2005 Malibu Maxx the motor works but the wiper arm barely moves

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 chevy impala,drivers side windshield works great,the passenger side doesn't work at all,help!


You mean wiper arm ? Probably broken wiper arm linkage bushing you can't see , under the cowling . Can you move the passenger wiper arm up an down without much effort ? An not the drivers side ? To see it or get at it you would need to pull wiper arms off an take cowling off to get at it . How To Install Replace Wiper Motor 2000 05 Chevy Monte Carlo Impala How To Fix Broken Wipers EricTheCarGuy

Feb 12, 2017 | Cars & Trucks

1 Answer

The passenger side wiper arm does not move. The driver's side works fine.


This minivan has just one wiper motor (and it obviously works), so the problem is after the motor.
The linkage between the wiper motor and the passenger wiper arm has come loose or lost a nut.
These wiper arm joints are under some fairly severe service conditions, and like to self-disassemble.

Here's the 2004 Sienna wiring diagram - enlarge to discern.

archaeology_7.gif

Jul 07, 2011 | 2004 Toyota Sienna

1 Answer

Passenger side wiperblade arm not moving, driver's side working fine.


you need to check to make sure the "arm" is moving , some gm vehilce have a sealed wiper unit, but the alero should still have arms. turn wipers on and look down at the cowl vent and see if it appears to move. if it is the mounting post for the arm on the passenger side has PROBABLY stripped out the soft lead mount at the bottom of the wiper arm. make sure the wipers are "parked", then carefully try to wiggle the pass side back and forth (its normal motion...). if it moves you will need to pop the arm off(super careful here..) and the post that looks smooth must be cleaned out with a fine pick or equilalent, the post accually has splines all around to engage the wiper arm. put on the new arm.. presto.... wipers.

Mar 06, 2011 | 2004 Oldsmobile Alero

1 Answer

Windshield wiper on passenger side not moving


Check to see if wiper arm bushing is bad. remove both wiper arms lift cowl cover to access arms from wiper motor should be able to see if arm is off. replace bushing.

Feb 02, 2011 | 2000 Ford F150 Flareside SuperCab

1 Answer

The drivers side windshield wiper arm stopped working although the passenger side wiper is still working. What would be the easiest way to fix it? Should I even bother checking the fuse before the...


65% sure it could the linkage and not a fuse promblem since the other passenger wiper is still working which would have to say the wiper motor is still working, 40 % could be that the linkage is intact and you have a worn out driver side wiper arm bearing..., what you want to check out before the linkage is the gear bearing that holds the wiper arms. You take the rubber thing that cover the bolt on the wiper arm and see if the bolt is loose and if not, unscrew the bolt and see if the tooth gears on the bolt and the wiper arm is worn/dull, if it is.... that can be the promblem.

Jan 13, 2011 | Nissan Altima Cars & Trucks

1 Answer

My passenger side wiper linkage (on a 1999 Caravan SE) stripped during a heavy snow last year. I bought a package of bushings, hoping to repair the problem, but now that I removed the wiper assy, it...


if the little serrated or fluted stem/axle is turning back and forth with the driver side, then yes your problem is that the arm itself is stripped out. that is a good thing as opposed to replacing the whole wiper linkage/transmission. look in the phone book for auto salvage yards and call around until you find one with a vehicle close to yours. bear in mind that most chrysler product vans will have the same wiper arms. when someone says "yeah we got one" take your wiper arm go out there and inspect theirs to make sure it is the same and that the hole is not stripped out already. part should not be more than 10 bucks on a car that old.

Oct 18, 2010 | 1999 Dodge Caravan

1 Answer

How do i replace the bushings on my windshield wipers on a ford explorer? Drivers side wipers bushing is wore and needs replacing. having a hard time putting the arm and new bushing back on the ball of the...


the parts in order for this wiper system has 4 items involved.
the wiper motor, the wiper transmission, the wiper arms, and the wiper blades
if the bushing is too hard to install its destroyed and it will jamb up on you
replace the transmission unit is the best option to do

Mar 06, 2010 | 2001 Ford Explorer Sport

5 Answers

I have a knocking sound in the backend of my 2004 Endeavor.


There are multiple bushings in the rear spindles. I just had to change both driver and pass side rear lower control arm bushings in the girlfriends. They are a mitsu only part and go for about 50 each.

Dec 14, 2009 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...