Question about 1997 Ford Windstar

Open Question

I HAVE A SEVERE VIBRATION IN MY FORD WINDSTAR VAN 2000YR WHILE IDELING.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: change oxygen sensor 2001 ford windstar

fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words

Posted on Jan 01, 2009

Ad
  • 5 Answers

SOURCE: ford windstar van, 2003

I had a small plastic piece replaced in the transmission and it solved the problem(2007). My car was still under warranty, so it only cost me about $100.00. The actual cost was closer to $900.00 because of the labor involved. I used the Ford Dealer in Schulenburg, Texas. They would know exactly what you are talking about, if you ask them.

Posted on Mar 31, 2009

  • 14 Answers

SOURCE: My Ford windstar van 2002 shakes when i stop at

O2 sensors

Posted on Jan 27, 2010

  • 68 Answers

SOURCE: Driving a 2003 Ford windstar. Went to pass and

Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.

Posted on Mar 01, 2010

gandergmm
  • 145 Answers

SOURCE: 1999 ford windstar.

replace VSS (speed sensor) and/or TRS (range sensor) use a DTC reader to confirm

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The van is ideled high when started


The choke is sticking, or your Cold Air Idel sensor is bad

Feb 19, 2013 | 2001 Ford Windstar

1 Answer

My 1999 Ford Windstar keeps lockng the doors and blinking the interior lights while driving.


You need the dealer to scan the Body control module while this is happening, i think you have a defective door ajar switch here.

Jun 12, 2012 | 2000 Ford Windstar

2 Answers

HAVE A SEVERE VIBRATION IN MY FORD WINDSTAR...


2000 Ford Windstar shakes, wildly at times. Seems to get less noticeable the faster it is driven, but the engine looks like it is having an epileptic fit while idling. No check engine light on. PCV hose seems to be fine. Spark plugs replaced. What can it be?

Jan 10, 2011 | 1997 Ford Windstar

1 Answer

The front of my van wheel makes squilling nose and vibrates but i just replace the tire last week and the tire is not losing air pressure


the strut bearing is worn out please replace it it costs $45.00 and will get rid of the vibration and squeeling. this is a common problem for thid ==s car.

Oct 05, 2009 | 1995 Ford Windstar

1 Answer

I am trying to find a diagram for belt for a 1995 Ford Windstar


i dont have a diagram but know how it goes on. from the passenger side of the van starting at the crank shaft. it goes from the crank shaft to the ac pump straight up to the power steering pump down to the ideler pully then back up to altinator then down aroun the water pump then over to the tensioner and back down to the crank saft

Mar 30, 2009 | 1995 Ford Windstar

1 Answer

When i drive my 2000 windstar . i put my foot on the gas petal and sometime i feel a vibration.


if you run the van about 50o60. MPH.and stars the vibration.have the tires being balanced. and outer tie rods check. inner tie rods o alignament

Feb 26, 2009 | 1997 Ford F150 Regular Cab

2 Answers

Fuse for rear wiper blade 1995 ford windstar van gl


The rear wiper fuse number is 24 in the passenger compartment fuse box.

Nov 04, 2008 | 1995 Ford Windstar

1 Answer

Distributor timing set


hmm ok
this will risk serious eletric shock..

start the vehicle
slowly turn the distributor left or right until you get the neat ideling tone and little to no vibration. If you turn it one way the car speeds up
the other way it slows down.. Find a place that you are comfortable with.

BTW some vehicles have the original settings marked, look for a colord(usually red) mark on the distributor and engine just line up these two.

Jul 20, 2008 | 1995 Ford Windstar

Not finding what you are looking for?
1997 Ford Windstar Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...