Question about 2009 Jeep Patriot

2 Answers

I changed the oil and need to reset the change oil light?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,826 Answers

1. Turn the ignition switch to the ON position. Do not

start the engine.

2. Fully depress the accelerator pedal, slowly, three times

within 10 seconds.

3. Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you

start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
---
Good luck on resetting the change oil light.

That was a new one for me and found the solution in the .pdf file
located on the owners section of the jeep.com website for the 2009 Jeep Patriot.



Posted on Nov 08, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 869 Answers

Check the owner manual for resetting oil light in your jeep.

Posted on Jan 06, 2011

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jagjeffery
  • 318 Answers

SOURCE: BMW528i 1999-How do you reset oil service light after oil change?

With the key in the ignition but in the off postion press and hold your odometer trip button in then turn your key to the first postion hold the trip button in for 5 seconds the display will read oil service or inspection then it will say reset release the button and then press it again untill the reset starts to flash then release and press the button briefly to reset

Posted on May 28, 2009

greg_margo
  • 1959 Answers

SOURCE: how to reset oil light after oil change on 2005 trailblazer

  1. Turn the key to the "ON" position
  2. Press the accelerator all the way to the floor 3 times within 5 seconds
  3. You should see the oil light flash, once it stops flashing, turn the key off
  4. Wait 10 seconds before starting the vehicle, the oil light should now be reset
  5. If this doesn't reset the light, repeat steps 1-4 paying careful attention to pressing accelerator all the way to the floor 3 times within 5 seconds
Best of luck.
Greg

Posted on Aug 10, 2009

  • 333 Answers

SOURCE: how do you reset change oil light on mitsubishi outlander

Turn the key off.

Press the "Info" button on the left of the dash cluster until your maintenance miles/months screen is displayed.

Press and hold the "info" button until the maintenance screen begins flashing.

Release the "info" button and then push and hold it it for one second.

Your Maintenance intervals should reset to +6 months and +7500 miles since the last interval amount.

Note that if you have not reset it for more than one interval, you may need to do it more than once. If you have not done it for many intervals, you may need to have it reset with the scantool at a dealer, as I have run into a handful of vehicles that the oil change reminder locked up after 3-4 "intervals" were skipped/not reset.


Posted on Sep 11, 2009

techbuster
  • 5081 Answers

SOURCE: Reset oil change for a 2008 dodge aveneger

To reset your maintenance reminder system (even if the light hasn’t come on yet), you’ll need to turn your key to on (but don’t start!) and make sure your odometer is on TRIP A. Then key off. Press and hold the Odometer/Trip button. While holding down on the button, key the ignition to on (Don’t start the engine!) The display panel will count down from “------“ to “-“Continue pressing the button until the Trip A is displayed. After this step, you are done.

Posted on Oct 21, 2009

johnjohn2
  • 5763 Answers

SOURCE: How do I reset the oil change light on a 2006

there are two types of displays heres both.hope this helps.for base instrument cluster.
1) press and release trip/reset button until setup menu hold reset displayed
2)press & hold trip/reset untilreset for sys check or sys check hold reset is displayed
3)release trip/reset button
4)press and release trip to scroll until hold reset if new oil is displayed
5)press and hold resetuntil oil life set to 100% and let button go you are done.
if you have a message center dash display then do this one. 1)push and release setup button until you see press reset to begin (2)press& release reset button until hold resetif new oil is displayed.(3)press and hold reset for 2secondsuntiloil set to 100%. done. hope this helps.

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Had an oil change on 2011 chevy cruze now oil light comes on


It is probably the change oil soon light. It needs to be reset manually at every oil change. Here is how:
http://oilresetpro.com/how-to-reset-oil-maintenance-life-on-2011-2013-chevy-cruze/

There is also a mobile app for your phone that has all the oil maintenance light reset procedures from these guys. Hope this helps!

Jun 22, 2012 | Dodge Stratus Cars & Trucks

2 Answers

The oil light keep telling me that i need oil when i already did a oil change what could it be


If you definitely got to change the oil after the oil change counter reset and then went out and had to be either a faulty oil pressure sensor or oil pressure failure.

Mar 04, 2011 | 2001 Chevrolet Monte Carlo

3 Answers

I had the oil changed but the change oil light is still on, how do i reset the computer? 2000 oldsmobile alero


How to Reset the Change Oil Light

After changing the engine oil, the system must be reset.

With the ignition key to ON, push the RESET button

located in the driver's side instrument panel fuse block. The

CHANGE OIL light will start to flash, press and hold the

RESET button again. The reset is complete when you hear
the chimes sound and the CHANGE OIL light goes out.

Oct 25, 2010 | 2000 Oldsmobile Alero

1 Answer

How to turn change oil light


iI you mean 'how to turn change oil light off" go to fuse panel. Open drivers door there is a panel cover on the side of dash board, remove cover there is a red RESET button that resets oil pressure and tire pressure. Turn the ignition key to the on position but don't start the car. Now press and release the reset button the change oil light should start to flash, now press and hold the reset button until you hear chimming hold until chimming stops then release, the change oil light should go off. If you need to reset tire pressure press reset button twice, the first push will make the change oil light flash the second press will make the tire pressure light flash then hold untill chimming stops, light should go out . Hope this helps.

Sep 30, 2010 | 2000 Pontiac Grand Am GT

2 Answers

Reset change oil light


hello, here is the instructions on how to reset the light

When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary. A CHANGE ENGINE OIL SOON message will come on. Change the engine oil as soon as possible within the next 600 miles (1000 km). It is possible that, if driving under the best conditions, the oil life may not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset.
If the system is ever reset accidentally, change the engine oil at 3000 miles (5000 km) since last oil change.
To reset the Engine Oil Life System, do the following:
  1. Turn the ignition to ON, with the engine off.
  2. Slowly fully press and release the accelerator pedal 3 times within 5 seconds.
  3. The reset is complete when the chimes sound and the CHANGE OIL lamp goes out. If the lamp stays on and no chime is heard, repeat the reset procedure.
  4. Turn the key to OFF.
If the CHANGE OIL lamp comes back on when the vehicle is started, the engine oil life system has not reset. Repeat the procedure.

Jun 20, 2010 | 2001 Pontiac Grand Am SE

1 Answer

How do i reset the oil light on my 95 fleetwood cad


1993 BROUGHAM & 1993-96 FLEETWOOD
Oil Life Indicator
1. Oil life indicator will display CHANGE OIL when oil change is needed, based upon engine oil temperatures and driving patterns. After changing oil, reset
oil life indicator.
2. To reset, turn ignition switch to ON position. Do not start engine. Fully press and release accelerator pedal 3 times within 5 seconds. If CHANGE OIL light
comes on and stays on for 5 seconds, it did not reset. Reset system again.

Jun 08, 2010 | 1995 Cadillac Fleetwood

2 Answers

The Change Oil (not oil light) in my 2002 Camaro came on less than 10 miles after it left the shop for new brakes, and less than 300 miles since its last oil change. What would cause the change oil light...


If you changed your oil just less than three miles ago, you just need to reset the computer. In this vehicle it may be the same as other chevys. what you will need to do is turn the key to the run position. Depress on the gas pedal three times and turn off the key. this should reset the computer. good Luck

Mar 23, 2010 | 2002 Chevrolet Camaro

2 Answers

How to reset the change oil light for a 2007 lincoln town car. Hitting reset button doesn't do it.


FIRST press and release the setup button to display oil life= xxx
then press and hold the reset button for about 2 sec it should then display oil life set to 100%
--------------------------------
Just pressing the reset button when the change oil light comes on while driving will not reset the computer

Feb 15, 2010 | 2007 Lincoln Town Car Signature Limited...

4 Answers

Oil light stays on


You need to put the key on and push the gas pedal to the floor three times within five second to reset the oil life light.Some g.m.'s have a reset buttom in the fuse panel that needs to be pushed first and some don't.Check the owners manual under change oil for your specific year car.

Oct 21, 2009 | 2003 Chevrolet Impala

2 Answers

2006 ford exsplorer oil light did not go off after a oil change.


In the owners manual, you will find reset procedures.

I found this for ya, hope it helps!

Please Rate!

Oil Change Reset
A press of the OIL CHANGE RESET switch will allow you to
reset the oil life feature to 100% (or your Personalized Oil Reset
Percentage). After you have the oil changed, you must execute
the following procedure. Press the OIL CHANGE RESET switch
and hold for five seconds as the M/C counts down for five
seconds. After a successful reset the Message Center will display
“OIL LIFE RESET TO 100%.” If you have established a
Personalized Oil Reset Percentage, the display will show that
percentage instead of 100%. To ensure accurate oil life
indicators, perform this reset procedure only after an oil change.
Your Personalized Oil Reset Percentage allows you to establish a
smaller oil change interval than the manufacturer’s
recommended interval. To establish your Personalized Oil Reset
Percentage perform the following procedure:
1. Press and hold the OIL CHANGE RESET switch and press
the RESET switch while the display is still counting down
the 5 seconds to reset. The display will change to “START
OIL LIFE AT XXX%.”
2. Press the OIL CHANGE RESET switch until the displayed
percentage is the Personalized Oil Reset Percentage that you
desire. Your choices are 100%, 90%, 80%, 70%, 60%, 50%,
40% and 30%.

Mar 03, 2009 | 2006 Ford Explorer

Not finding what you are looking for?
2009 Jeep Patriot Logo

1,724 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...