Question about 2000 Nissan Xterra

1 Answer

I started my 2001 Nissan Exterra this morning and noticed that the caytalac converter was spraying fluid looking like oil and water. It is all rusted on the outside. Do you suggest I need a new caytalac converter? Haven't noticed any other symptoms.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

This is acutally quite common on all vehicles to drip condensation buildup. Most cats and mufflers have a little pin sized hole to release the fluid.

Posted on Nov 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil capacity for 2001 Nissan exterra


There are two engine that can come with this truck. i will list both the 3.3 engine holds 3.5 qts and then the 2.4 engine hold 3.75 Qts. good day.

Jun 25, 2011 | 2001 Nissan Xterra

1 Answer

I took the exterra for oil change and after that it started to make a noise like little stones jumping in front in the hood inside.


If the noise is there all the time,I would suspect the timing chain

All Frontiers,Exterra and Pathfinders,2004 thru Nov 2009 have that problem

There is a new Borg Warner chain out, to fix that,of coarse any chain guide issues and oil activated tensioners,should be checked out or replaced

Nov 06, 2010 | 2004 Nissan XTerra

1 Answer

2001 mazda tribute ,starting backfiring when I washed the engine. Rough ride when driving,hesitates 99 % of the time when I'm driving Figure it was the spark splugs,may of gotten some water in one of them...


First of all, never wash the engine..second, check the oil and cooling fluid if there is any traces of oil /fluid and third, you probably got water leaked by spark plugs...

Jun 14, 2010 | 1988 Nissan Maxima

1 Answer

I have a 2001 mercury sable. when the car is idling it shakes and idles a lil high ive had a tune up, trans fluid change and oil change. i was told that my right trans axle seal needed to be replaced. it...


Take a spray bottle and put water in it and with engine running start spraying around the vaccum hoses and manifold intake, even ignition wires and coils...you are looking for vaccum leaks of some kind, or electical leaks. If the engine levels out at any point that you spray, inspect that area for a bad hose or leaking gasket. If it gets worse around the electrical wires, coil, ect, you can replace that componet. You will be able to buy an empty spray bottle at Automotive stores.

Mar 07, 2010 | 2001 Mercury Sable

1 Answer

My 2000 exterra started running like there was watter in the fuel iput isoprople alcahal in ranit five miles it cleared up ran fine for a day the runabilty problem came back and it died on the way home...


If the pipe got cherry red while trying to start, it was because of unburnt fuel entering the catalytic converter, most likely. Check for signs of plug fouling and injectors hanging open. You're likely flooding your engine due to dirt accumulation in an injector.

Dec 27, 2009 | 2000 Nissan Xterra

1 Answer

Exterra slave cylinder bleedinf procedure


for the clutch
open the bleeder valve and wait for the fulid to come out when all the bubbles are gone close it and your done.
dont let it run out of fluid in this time.
for the brakes you do the same thing but start with the wheel the farest from the cylinder and work in closer to the last wheel is done.right rear first then driver rear second passenger front third and driver front wheel last.
thats all the bleed inf you need.dont run out of fluid when bleeding.

thank you
jm

Jun 12, 2009 | 2004 Nissan XTerra

1 Answer

Cant deactivate d 4wheel gear of nissan exterra frm 4H gear to 2H


check vacuum diagram see if any pit hoes are in it also check hoses that connect to it are broken

Dec 28, 2008 | 2001 Nissan Xterra

2 Answers

Rpm problem


hello, my name is johnatan and i will be helping you to day.

Q.
you have a nissan pathfinder 2001 and when i start up the car early in the morning the rpm goin up and down


A.
When you start your car check you oil preacher gage and see if it is jumping if it dose check you oil dipstick it mite be low on oil or time for a oil chang.
If you car is not low on oil or your oil is not thick and creamy or watery then thar is a good possibility that you oil pump is on it's way out

Sep 28, 2008 | 2001 Nissan Pathfinder

Not finding what you are looking for?
2000 Nissan Xterra Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...