Question about 1989 Honda CRX

1 Answer

Location of Thermostat. Front, top hose or back, lower hose?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 48 Answers

NOT 100 PERCENT BUT I THINK ITS UPPER HOSE ON MOTOR. COMMENT BACK @ ME

Posted on Nov 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of 2007 chevy trailblazer thermostat


Follow the radiator hose back to the engine on the top side. Where the hose connects to the engine is the thermostat housing. Remove the hose clamp and hose (when vehicle is cool). remove the housing itself and the thermostat will be right in front of you. .

Feb 17, 2015 | 2007 Chevrolet TrailBlazer SS

1 Answer

Location of thermostat


Open the hood and find the radiator.
Get help and a flashlight if you need to.
The radiator should have two black hoses attached to it, one on top and one on the bottom.
Those hoses are about 2 inches in diameter, maybe a little larger.
On cars made up to about 1985, the thermostat was found at the engine end of the top radiator hose.
There would have been a bell-shaped housing with the thermostat inside.
These were usually rear wheel drive vehicles.
Cars made since the mid-80's and particularly front wheel drive vehicles have the the thermostat located at the engine end of the lower radiator hose.

Jan 19, 2013 | Cars & Trucks

2 Answers

Location of thermostat 1997 ford taurus dohc 24 valve v6


on the 1997 Taurus DOHC v6 the thermostat is conveniently located at the front passenger side of the engine, just up over top of the the mud guard. There's about a dozen screws (bolt heads) to take off, slip out the mud guard and there's the lower radiator hose and the thermostat housing! The thermostat is held in by a reusable O ring and is pretty well engineered for being in such a surprising location.

Jul 14, 2011 | Ford Taurus Cars & Trucks

2 Answers

Thermostat location of a 1991 HondaAccord


The thermostat for your car is in the lower hose instead of the upper. Follow it back to the engine and the thermostat right there.
To see the thermostat located in your car.Please click the link below.
http://technoanswers.blogspot.com/2011/03/where-is-thermostat-located-on-1991.html ----------- in the link there is diagram and removing/ installing procedure for thermostat.----------- this should help.Thanks.Helpmech.

Mar 29, 2011 | 1991 Honda Accord

1 Answer

Where is the thermostat located in the 06 stratus


  • Find the location where the upper radiator hose connects to the intake manifold of the engine by tracing it from the radiator to thermostat intake housing bolted to the intake.
  • 2 Remove the radiator hose from the thermostat intake housing by loosening the band clamp that secures it into place. With the clamp loosened, pull the hose off the housing.
  • 3 Remove the two bolts that secure the housing to the intake manifold and then lift the housing off the intake.
  • 4 Lift the thermostat out of the intake manifold and place the new thermostat into the hole. The end of the thermostat with the pin protruding from it sticks out of the intake manifold.
  • 5 Lift the thermostat intake housing gasket off the intake manifold and place the new one onto the intake manifold.
  • 6 Place the thermostat intake housing onto the intake manifold and bolt it into place. Reconnect the hose using the band clamp.
  • Six-Cylinder Engines
  • 1 Drive the Dodge onto a set of front-end ramps and secure the parking break. Allow adequate time for the radiator fluid to cool down. Thirty minutes is usually adequate.
  • 2 Loosen the petcock on the lower right hand side of the radiator and drain all of the radiator fluid into a drain pan. Close the petcock once drained.
  • 3 Trace the lower radiator hose to the location where the hose connects to the engine block. The metal housing the hose connects to is the lower thermostat outlet. Remove the hose from the outlet by loosening the band clamp and then by pulling the hose off the outlet. Be careful--some fluid will drain from the hose.
  • 4 Remove the two bolts that secure the thermostat outlet to the engine block and pull the thermostat outlet off the block.
  • 5 Discard the O-ring inside the bottom edge of the thermostat outlet and place a new one into the outlet.
  • 6 Pull the thermostat out of the engine block and replace it with a new one. The end with the pin protruding from it sticks out of the engine block.
  • 7 Place the thermostat outlet onto the engine block and secure it into place. Reattach the lower radiator hose with the band clamp.
  • 8 Open the radiator filler cap located on top of the radiator and fill the radiator with the fluid previously drained from the system.


  • please dont forget to give good rateing thank you

    Dec 28, 2010 | 2006 Dodge Stratus

    1 Answer

    Engine does not heat up. I think thermostat is bad but can't find the location. It is not located a the engine block where the top radiator hose is connected to the engine block. It is a 1996 Toyota Rav4...


    Its on the front of the engine block under the alternator. Follow the lower radiator hose til it meets with the block, you have to take that hose off of the block and the thermostat is inside mounted to the block. When you replace you'll want to replace the gasket too.

    Nov 26, 2010 | 1996 Toyota RAV4

    2 Answers

    Over heats. Can;t find the location of the thermostat


    check to make sure your cooling fans are working and your radiator is full and the reserve.the thermostat is under the housing where the top radiator hose connects to engine

    Dec 27, 2009 | 2005 Chevrolet Cavalier

    3 Answers

    Location of thermostat on 2002 dodge stratus 2.7 eng.


    The thermostat on this car is located on the passenger side lower Engine block. Follow the lower radiator hose and it will lead you right to it. The Wheel and splash guarding need to be removed as well as the Alternator to gain access to the housing bolts. It about a 3 hour job to replace thermostat.

    Jun 20, 2009 | 2002 Dodge Stratus

    2 Answers

    Location of thermostat on 2001 dodge stratus


    It's not the most convenient location, but if you follow to top radiator hose back to where it meets the engine, that is the thermostat housing. It should have the radiator hose and a heater hose hooked up to it. Here's the shop manual directions for changing it, if you want them. The following instructions come from my Hanes Repair Manual #25040 for the replacement of a thermostat on the 2.7 L engine:

    1. Raise the vehicle and place it securely on jackstands. Remove the right front wheel. Remove the accessory drivebelt splash shield.
    2. Remove the accessory drivebelts.
    3. Remove the lower alternator mounting bolt.
    4. Lower the vehicle.
    5. Disconnect the alternator electrical connectors.
    6. Disconnect the electrical connectors from the air conditioning compressor.
    7. Remove the oil dipstick and the dipstick tube. Plug the hole in the oil pan with a clean shop rag to prevent debris from entering the pan.
    8. Remove the rest of the alternator mounting bolts and then remove the alternator.
    9. Loosen the hose clamps and then disconnect the two hoses from the thermostat housing cover.
    10. Remove the thermostat housing cover bolts and then remove the housing.
    11. Note how the thermostat is installed, with the "jiggle valve" at the 12 o'clock position, and then remove the thermostat.
    12. Remove all traces of sealant from the housing and coverr with a gasket scraper.
    13. Install the thermostat housing cover and then tighten the bolts to the correct torque.
    14. Reattach the hoses to the thermostat housing cover. Make sure that the hose clamps are still tight.
    15. The remainder of the installation is the reverse of the removal.
    16. When you're done, refill the cooling system.
    17. Start the engine and allow it to reach normal operating temperature, then check for leaks and proper thermostat operation.

    Jan 10, 2009 | 2001 Dodge Stratus

    3 Answers

    Thermostat location 1995 jeep grand cher. straight 6


    Thermostat is located on 4.0L I-6 on front cylinder head. The 3.7L V-6 thermostat is located where the lower radiator hose attaches to engine. The 4.7L V-8 thermostat is located where the lower radiator hose attaches to engine. The 5.7L V-8 thermostat is located where the upper radiator hose attaches to engine. The 3.9L V-6 and 5.9L V-8 Thermostat is located on front top of intake manfold (between alternator and ac compressor)

    Jul 31, 2008 | 1995 Jeep Grand Cherokee

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    26 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts

    yadayada
    yadayada

    Level 3 Expert

    76630 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Kevin Daniels

    Level 3 Expert

    1455 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...