Question about 1994 Lexus GS 300
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 98 lexus gs300 codes p1120 p1121
I wanted to start a thread specifically about failures within the throttle body concerning the GS300 (1998 in my case)
My symptons were:
VSC, VSC OFF, and ENGINE Lights would come on, followed by my car going into Limp Mode, where only that last 25% (if that) of the throttle would respond (basically have to floor the pedal to even move at all).
During the mornings, or when the engine was COLD, the throttle operated normal...then once the car warmed up, usually at about 10 mins, the problem would start...it happened intermitantly at first...1 or 2 days over the course of a week, then it became more consitent, until last week it became a daily problem.
The first part I tried was the Throttle Position sensor, which is on the front side of the throttle body, and the easiest thing to replace...this didnt help at all. $300 part from Lexus, $80 part from RockAuto.com (exacly same part toyota OEM)
THE PART THAT FIXED THE PROBLEM:
"Idle Valve Motor", which is the larger electrical object next to the TPS on my 98 GS300. Problem is solved.
The Codes I got were P1120 and P1121 - Accelerator Sensor problem. However it wasnt really the Accelerator Sensor, it was indeed to actual electrical Motor that controls the opening of the Butterfly valve inside the Throttle body.
I found the problem by good old trouble shooting, and using an ohm meter to see if the throttle electric motor was getting elev, I found that the elec motor just to the left of the TPS was basically freaking out and shutting down. The Accelerator Pedal Sensor is on the Back-side of the throttle body where the throttle cable connects to, and has a spring on it. It was fine.
GS300's are indeed "drive by wire" concerning the throttle...the cable triggers the Accel Pedal Sensor, which sends a signal to the ECU, the ECU then sends power to the Idel Valve Elec Motor (next to the TPS), which opens and closes the mechanical butterfly valve, then the TPS sensor detects how far the elec motor is actually opening the butterfly valve...its a closed-loop feed-back system, meaning any failure in any sensor will cause the entire systm to fail.
The throttle cable apparently is ONLY there to allow the fail-safe of having that last 10-25% throttle when the electronic system fails...there is a gearbox inside the throtle body which allows the tail end of the throttle to manually engage the butterfly valve...the rest of the time, the butterfly valve is 100% opened and closed via the idle control motor.
Posted on Jul 08, 2009
The 100 Amp alternator fuse is blown under the hood in the fuse block,
it has a clear plastic cover on it for inspection, the designation is
marked inside the fuse panel. This fuse is bolted in inside the fuse
box, the fuse box has to be removed and opened to get to the bolts that
connect the fuse in.
Here you have the Lexus-GS-300-Wiring-Diagram-Manual
Good luck (remember rated this help).
Posted on Dec 01, 2009
Tips for a great answer:
Mar 07, 2013 | 1994 Lexus GS 300
these case go with the solved problems related to these issue.
the link below and follow the procedure: -----
1994 Lexus GS300: Power seat will not go back?
POWER SEAT WILL NOT WORK?
These will help.
Dec 10, 2012 | Lexus SC 400 Cars & Trucks
Oct 02, 2012 | 1994 Lexus GS 300
Jun 30, 2012 | 1994 Lexus GS 300
Jun 11, 2012 | 1994 Lexus LS 400
Jan 20, 2011 | 1994 Lexus GS 300
Mar 07, 2010 | 1999 Lexus Gs 300
Jan 01, 2010 | 1994 Lexus Es 300
Sep 16, 2014 | 1994 Lexus GS 300
126 people viewed this question
Usually answered in minutes!