Question about 1985 Ford Ranger

1 Answer

85 ford ranger 2.8 v6

It spits, sputters, and pops, but onlt after i drive it for a while, and it heats up. its, hard to tell if its an electrical or a fuel problem. i've changed the spark plugs, plug wires, fuel filter, and the ignition coil. any comments please.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 27 Answers

Try replacing the ignition module in the distributor. This is a common problem on these engines.

Posted on Jun 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speraticly keep losing a cylnder and when it does it really loads up on fuel spits and sputters dies and blows white smoke


White Smoke -- is Coolant & a Bad Head Gasket

Do a Cylinder Leak Down Test & a Combustion
Leak Test

Nov 26, 2012 | 1987 Ford Ranger

1 Answer

When advancing down highway vehecle spits and sputters then clears up then spits and sputters what is it


When was last tune up? Plugs, wires, all filters & fluids? Especially fuel filter. I'd start there and run a good fuel system cleaner through it.

Mar 15, 2011 | 1988 Ford Ranger

1 Answer

My 1986 ford ranger spits and sputters like its running out of gas and popping through air cleaner put new fuel filter on


Check the EGR make sure it is not stuck open. Then Check the timing and check for dirt and grease and moister in and on the Distributor cap and on the rotor check spark gap and clean plugs with fine sandpaper.

Feb 01, 2011 | 1986 Ford Ranger 2WD

1 Answer

My 1986 ford ranger 2.9 v6 engineafter driving for a while it sputters from gas and stalls.does it have (2) fuel pumps? 1 in the outside frame and 1 in the tank?


Yes there are two (2) fuel pumps on these pickups, one low pressure one in the tank that gets the fuel to the high pressure pump which is in the inside of the drivers frame rail beneath the cab towards the front of the cab.

Jul 01, 2010 | 1987 Ford Ranger

1 Answer

85 ford F-150 5.8 carb was rebuilt and ran awsome


CARBURETOR FLOATS SETTING TOO LOW OR MIXTURE SCREWS SET TOO LEAN NEED ADJUSTING.

Mar 20, 2010 | 1985 Ford F150

1 Answer

1993 ranger sputters until warm?


replace the Oxygen senson before catalytic converter this sensor tells the computer to send signal to fuel injectors to allow rich mixture upon start up for warm up then leans out mixture as it heats.

Feb 24, 2010 | 1993 Ford Ranger SuperCab

1 Answer

Vaccume diagram for a ford ranger 85 with a 2.8 v6


This if for an '83 Ranger, but a 2.8 Ford is a 2.8 Ford.

http://www.therangerstation.com/tech_library/diagrams/1983vacuumhoseguide.jpg

Nov 04, 2009 | 1985 Ford Ranger

1 Answer

Spit and sputter on highway


I'd spend the money to change plugs & wires & cap & rotor, if you that style ignition.

Jul 23, 2009 | 1993 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

513 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...