Question about Ford F-150

1 Answer

My is joel i have foed f150 2002 and the heat dont work i renplace thermostat and tempature control switch. do you gays can helpme please

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 8,172 Answers

Please see my tip at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Posted on Nov 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater not working from my 97 GMC jimmy. Change


Do you feel heat on both heater core hoses? If not then it might have a blocked heater core, low coolant level, defective heater control valve or a blend door issue.

Jan 04, 2015 | 1997 GMC Jimmy

1 Answer

Heat doesnt work


check your fluids radiator should be full and resavor should be at full level if you dont have enough anti freeze it wont push fluid into your heater core also pay attention to your tempature gage if the temp is low you wont get good heat your thermostat could be stuck wide open I would try adding anti-freeze first though that usually fixes it make sure its 50/50 if you just add water sooner or later that water will evaporate

Dec 08, 2012 | 2005 Pontiac G6

1 Answer

My tempature gauge will register normal tempature after engine runs and heats up but will drop back to no tempature.


ZI suggest you have the engine thermostat replaced, it is likely sticking open and allowing the engine to cool down. The thermostat is under the cover that the upper radiator hose connects to on most GM engines.

Jul 24, 2012 | 2005 Chevrolet Silverado

2 Answers

1999 Alero: where is the a/c control tempature :problem is wh...


WELL TURN ON AC MAX COLD HIGH TO SEE IF COOLANT FANS TURN ON.IF NOT YOUR REFRIGERANT SO LOW THAT THE AC REFRIGERANT PRESSURE SENSOR WONT CLOSE CIRCUIT TO TURN ON COOLING FANS.MEANING YOU NEED HAVE AC CHECKED AND CHARGED.ALSO CHECK COMPRESSOR FOR POWER IF NOT YOU HAVE BLOWED FUSE OR BAD RELAY.IF FUSE AND RELAY GOOD YOUR AC COMPRESSOR CLUTCH COIL OPEN OR THE AC CONTROL SWITCH IS BAD.IF COMPRESSOR IS RUNNING WHEN YOU TURN ON AC YOUR AIR TEMPERATURE ACTUATOR NOT WORKING.

May 17, 2010 | 1999 Oldsmobile Alero

3 Answers

My temperature gage is going over in the red and my heat is not


Check the sensor which controls the cooling fans that cools the radiator it prevents the engine from over heating and allows the temp gauge to stay at normal range.recently had problems with my 2003 impala overheating it was the sensor had the thermostat replace as well.

Feb 10, 2010 | 2003 Chevrolet Impala

1 Answer

2001 Alero- heat gage does not show heat tempature. Blows warm air.Engine felt cold after a 50 mile trip. Out side tempature 20 degrees fernaheight.


with winter being here you might want to consider having a new thermostat put in to increase the heat in side,but make sure your radiator is full when engine is cold

Dec 26, 2009 | 2002 Oldsmobile Alero

1 Answer

2002 Windstar Knocking or clicking sound from temp control switch


You need a blend door actuator. It's located behind the radio and a/c control head.

Apr 05, 2009 | 2002 Ford Windstar Cargo

1 Answer

No heat


the temp is controlled by a blend door near the heater core and A/C evaporator core deep inside the dash, the blend door has an electric motor called a stepper motor, it has failed, so whenever the door was when it failed is where it will stay, in your case cold air position, to change this part the dash assembly must be removed.

Dec 13, 2008 | 1999 Cadillac DeVille

1 Answer

NO HEAT BLOWS OUT WHEN I TURN MY HEAT ON


Is the car tempature gauge working ? Another words is the car operating at tempature? it could be just that your thermostat is stuck open and probably needs replaced

Dec 05, 2008 | 2004 Chevrolet Monte Carlo

1 Answer

Ac problems (over heating)


Did you tried to change the gas? i had same problems but it was the gas, change it.

Jun 17, 2008 | 1992 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...