Question about 2004 Chevrolet Impala

1 Answer

Brake lights and turn signals don't work. Any ideas of why they don't work? Jiffy Lube just put in new lamps and Pep Boys tightened my battery connections.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Possibly a broken connection inside the socket for the lamp. Or, one or more wires are not making connection in the connector that goes between the wiring harness and the lamps.

Posted on Dec 05, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hazards, turn signal and brake light dont work

Has to be a fuse, or something electrical. Examine the fuses for signs..if not, then take it to Pep Boys to read the codes

Mar 18, 2014 | Ford Expedition Cars & Trucks

1 Answer

My 1997 GMC Jimmy will not start, when I turn the key nothing happins. I put new battery in it and my power locks worked and windows, lights, then I turn the key and nothing everything dies???????

Did this happen after you put the new battery in?
I have run into where people just put a new Pep Boys or Kragen or whomever battery in and had issues afterwards. Soemtimes the terminals don't tighten. The bolt will be as tight as you can get it without stripping and the terminal can still be moved. The battery terminal hole may be too shallow not alloing the bolt to go deep enough.
Things will work until you try to start, The starter will draw a lot of juice and cause the loose terminal to arc and lose connection.

Now if this was happening before you replaced the battery then it may be the starter orits circuit. Hook a test light to the starters small "S" terminal and try to start. If the ight comes on its a bad starter. If no light then you need to trace that back. Manual transmission should have a safety switch on the clutch pedal. Automatic will have a neutral safety switch on the transmission (right side where the gear selector hooks to).

But that sudden loss of power makes me thing there is a loose connection arcing. If not at the battery then check the under hood fuse and relay panel.

Aug 30, 2011 | 1997 GMC Jimmy

1 Answer

Yellow warning light that says check is on What does it want? In manual it says take to dealer

Take it to a Pep boys if you don"t have a code reader.
They will check out the computer code warning you are getting right noe.
The cost will be about $40 or 50 bucks.
The dealer will charge you three times that much,plus Pep boys will give you a up front free estimate if you need any repairs.
Bet it's the gas cap though.
Try tightening your gas cap and driving the car around far a hundred miles or so.
remember never put gas or loosen the gas cap when the engine is on.
The computer will pick up the venting like it would a leak,thus sending a warning code to the computer.

Nov 25, 2010 | 2005 Toyota Corolla

3 Answers

Turn signals don't work but hazard and brake lights do.

Check your fuses. There is probably a separate fuse for turn signals.

Sep 02, 2010 | Ford Expedition Cars & Trucks

2 Answers

Engine light came on recently and Jiffy Lube guys did diagnostics and found nothing and turned it off and now it just came back on, malfunction or get checked?

If the check engine light came back on after the computer was reset you need to take it and have the code read to see what the problem is. Most auto parts stores will check it for you free such as Autozone, O'riely, Pep Boys.

Jan 21, 2010 | 1996 Honda Odyssey

1 Answer

How do I change the motor oil

If you have to ask this question you probably don't have the proper tools to do the job and would be better going to a Jiffy lube, Firestone, Pep Boys or some national chain. Check the newspaper to find one that has a special.

Dec 24, 2009 | 2008 Chevrolet Impala

2 Answers

Whats the average price of a tune-up on a 2000 Infiniti I30? I was quoted a price from the dealership of $250 for spark plugs only. Is this right? Can I get it tuned up at a jiffy lube or discount tire or...

your parts are probably expensive but it sounds high.I would get another opinion from someone else and try to find a friend that has had work done there before

Oct 07, 2009 | 1997 Infiniti.5 J30

3 Answers

Trany slipping

Check level of fluid. If ok then to the shop the car must go

Sep 07, 2009 | 2002 Dodge Neon

1 Answer

I am seeing small puddles of oil under our 96 nissan quest?

you can take it to any auto repair place.Like sears pep boys or a local repair shop. some times you can get away with a few turns on the bolts holding the pan up

Jan 19, 2009 | 1993 Nissan Quest

Not finding what you are looking for?
2004 Chevrolet Impala Logo

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

83951 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22441 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides