Question about Isuzu Trooper

1 Answer

Hey i have a 1994 isuzu trooper with 105k its a manual tranny i put a brand new clutch in it and its hard to put it into any gear even reverse what could it be

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Your clutch cylinders maybe bad

Posted on Feb 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reverse on 1994 Isuzu Trooper


run fault codes and look for a reverse solenoid /sensor fault.

Apr 25, 2013 | Cars & Trucks

2 Answers

Isuzu trooper gearbox problems


You need to be a bit more specific when describing your problem. By "not getting any gears" do you mean (A) the shift lever will not move into position to select a gear?, or (B) shifts into gear position, but does not move? For (A), try reverse (it is not synchronized); Do you get a grinding of gears sound when you try to engage it? If so, this sounds like a problem with the hydraulic clutch release system. If it gets low on fluid, it will not release enough to let you put it in gear. top off the reservoir(tiny 1/2 cup sized one on driver side fender under hood below and to the right of the brake master cylinder) and frantically pump the clutch pedal about 100 times (that\'s right, 100!)
If the tranny goes into gear but the vehicle won\'t move, this sounds like either the clutch disc is worn too thin to grab, or something is broken in the driveline. Try locking the hubs and putting it into 4WD and see if it moves then. If so, then the rear wheel driveline or driveshaft has a problem. Good luck!
<Splinter, LA, CA 1990 Trooper >352,000 miles>

Jan 22, 2013 | 1999 Isuzu Trooper

1 Answer

Manual transmition hard in reverse


manual transmissions have slave cylinder that requires DOT 3 brake fluid, there is usually a half dollar sized reservoir near the brake master cylinder. if your fluid is low you will have trouble getting it in gear and in time burn up your clutch. also consider having your trans fluid flushed and adding an additive, it's not expensive on a manual trans. :)

Aug 08, 2012 | 1994 Isuzu Trooper

1 Answer

We have a manual transmission Isuzu Trooper 1995, the gears will not change but car starts and drives in this one gear. The clutch is fine, doesn't stick or anything. What might the problem be?


The pressure plate to the clutch is not dis-engaging the tranny...most likely need a pressure plate and clutch change...Hope this helps.

Apr 25, 2011 | 1995 Isuzu Rodeo

1 Answer

My transmission don't respond when you put it in gear


This is a wire corrosion problem. I had to manually shift my transmission when i was working on redoing my tranny wiring, but that cleared the problem right up.

Apr 05, 2011 | 1994 Isuzu Trooper

1 Answer

Where is my tranny fluid.....no more clutch


if you do not have a clutch, you need a new clutch. Adding more gear oil to the manual gear box will not restore a clutch. It is a 94 and anything past 10 years on a transmission is good.

Nov 18, 2010 | 1994 Isuzu Rodeo

1 Answer

I installed a new clutch and cant get 5th or reverse.


remove gear stick and check its in properly, if you removed the gear shifter quadrant box bolted to top of gearbox you more than likely put it in while a gear was selected, remove and make sure gear box selectors are all lined up in nuetral then refit quadrant box and then gear lever.

Aug 09, 2010 | 1995 Isuzu Trooper

1 Answer

1994 isuzu trooper 3.2 dohc automatic will not shift into 3rd gear it will shift into 2nd gear and at around 40 mph goes into like nuetral and sets a 61 code after that hapens it will not shift out of 1st...


The 3rd clutch pack is very cheezy on this unit (4L30E). The 3 speed version of your trans was used in the Chevy Chevett back in the late 70's early 80's (GM's THM 180). Check the oil condition for a burnt smell. Other items to check are speed sensory, and the shift soleniod (I don't know what the codes translate to). Any issues with reverse? If you'll drop the pan of the trans you may find debris. In this case it very well may be internal damage (clutch pack for example). Don't bother with changing the filter or adding additives to solve this problem.<br /> RTB - ProBuilt

Jan 22, 2010 | 1994 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...