Question about 1992 Chevrolet K1500

2 Answers

92 chevrolet 3100 engine no spark on 1&4 i ghanged coil still no spark

Posted by on

  • boba275 Nov 07, 2010

    92 chevy corcica no spark on 1&4 it has 3 coils i replaced the one that had no spark it starts easy but still has no spark on1&4

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, if your engine cranks normally but will not start because it has no spark, or it stalls and won't restart because it has no spark, the problem may be due to any of the following:

  • A bad pickup inside the distributor (on engines that have a distributor), a stripped distributor drive gear (common problem with plastic distributor drive gears), broken, loose or corroded wires from the pickup to the ignition module or PCM.
  • A bad crankshaft position (CKP) sensor (on engines that do not have a distributor), or broken, loose or corroded wires from the sensor to the PCM.
  • A bad ignition module (on engines that have a distributor or use an ignition module separate from the PCM)
  • A bad ignition coil (on engines that have a distributor and a single coil)
  • A bad rotor or distributor cap (cracks or carbon tracks that are allowing the spark to short to ground)
  • Faulty ignition switch.

Posted on Nov 07, 2010

×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,841 Answers

First off the K1500 did not come with a 3100 V6 but instead has the 4.3L V6. But assuming this is the correct engine in whatever 1992 vehicle you have then the 1 & 4 plugs are fired by the same coil pack on the 1991 3100 V6. If you replaced the coil and still have no spark you either got a defective new coil, which is possible, or you have a wiring or connector issue. Check the wiring and the connections very carefully. I also assume you have replace the spark plugs and have run a compression test on #1 & 4 cylinders just to make sure you do not have a burnt valve or blown head gasket. Not likely as the cylinders are on opposite banks, but you never know.

Posted on Nov 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the Wire Order with distributor?


theres no distributor and the firing order for your 3.8 is 1-6-5-4-3-2-the following link shows the coil pack
Buick General Motor 3800 V6 Engine Firing Order DIS IDI ignition timing 3.8 Buick Engine Coil Pack Firing Order Spark Plug Wire Location Which way do the spark plug wires go on & what cylinder is what?
.
For the Buick V6 231 3.8 liter turbocharged engine:
.
Answers!
.
Firing order:
1 - 6 - 5 - 4 - 3 - 2.
.
Spark plug wire location on coil pack:
.
Closest to the back of the car, left to right: 1 - 5 - 3.
Closest to the front of the car, left to right: 4 - 2 - 6.
.
Spark plug wire location on engine:
.
drivers side, front to back of car: 1 - 3 - 5.
passenger side, front to back of car: 2 - 4 - 6.
.----and this link shows the coil pack to cylinders
.
3 8 Buick Turbo Engine Coil Pack Firing Order Spark Plug Wire Location

Aug 15, 2015 | 1987 Buick Regal

2 Answers

What is the Spark Plug Firing order for chevy impala with a 3400 engine?


from left to right 2-4-6 is in the front, 1-3-5 is in the rear of engine. The coils are numbered if factory coils 5-2, 6-3, 1-4, God-Bless!

May 15, 2015 | 2003 Chevrolet Impala

1 Answer

Where can I find the spark plug wiring diagram for 1994 Camaro, v6 3.4 liter?


Engine Coil Pack
5 6 / #4 / / #3 / / #5 /
3 4 / #1 / / #6 / / #2 /
1 2
Front Ignition Wires on Coils
#1 #4 #6 #3 #2 #5
' ' ' ' ' '
O O O O O O

Firing Order: 1-2-3-4-5-6

Feb 24, 2015 | 1994 Chevrolet Camaro

2 Answers

How do you change spark plugs in a 2004 hyundia sonata


It depends on which engine is in the vehicle. The 2004 Sonata came with two possible powertrains -- the 2.4 Lit L4, and the 2.7 Lit V6.

On the 4 cylinder engine, there are two coil packs and two ignition wires, Below each coil pack is a spark plug (#2 and #4 cylinders). The wire from # 2 coil pack goes to #3 spark plug, and the wire from #4 coil pack goes to #1 spark plug.

Photo:

ghost45_15.jpg
Now the 2.7 Lit V6 requires you remove the surge tank (intake manifold) in order to access the spark plugs & wires on Bank 1 (Right Hand side of the engine).

Photo:
ghost45_16.jpg

Jun 10, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

Can you show me a diagram of which spark plug wire goes to what spark plug on a 89 oldsmobile ciera please.


Standing in front of the car looking at the the coil packs, there are three of them. From left to right, the first coil pack is 1 & 4, the second coil pack is 6 & 3, and the third coil pack is 2 & 5. Now standing in front of the engine, the three cylinders in front of the radiator are 2,4 & 6 starting from the belt side of engine and the ones in the back off engine are 1,3 & 5.

Jun 05, 2011 | 1989 Oldsmobile Cutlass Ciera

1 Answer

Need to know the placement spark plug wires 2001 chevrolet malibu


do not have a diagram, but heres the firing order. 1-2-3-4-5-6, 1-3-5 is in back, # 1 is closest to alternator. from left to right, or facing engine from front 2-4-6 is in front. 5-2-3-6-4-1 is coil pack, from left to right (facing from front of engine).

Jul 30, 2010 | 2001 Chevrolet Malibu

2 Answers

Firing order on coil packs 92 lumina z34 5 spd


For the 1992 & 1993 Chevrolet Lumina 3.4L DOHC V6

Firing Order:
1-2-3-4-5-6

Cylinders:
.......(back)......
F|...1....3....5...|
A|...................|
N|...2....4....6...|
.......(front)

Ignition Coil Connections:
...............(back)
....1...4........3...6.......2...5...
.|..o...o..|..|..o...o..|..|..o...o..|
.|....O....|..|....O....|..|....O....|
...............(front)

May 03, 2010 | 1993 Chevrolet Lumina

2 Answers

Spark plug wiring diagram for 98 tahoe car is missing need to know which wire goes were


You didn't post your engine size so please pick the applicable diagram:


37926a4.gif
1996-98 4.3L Engines Firing Order: 1-6-5-4-3-2Distributor Rotation: Clockwise


8c292b0.gif
1996-98 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise



30ced3d.gif
4.3L Engines Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise


de67664.gif
4.8L, 5.3L and 6.0L Engines Firing order: 1-8-7-2-6-5-4-3 Distributorless ignition system (one coil on each cylinder)


bf80c63.gif
5.0L, 5.7L and 7.4L Engines Firing order: 1-8-4-3-6-5-7-2 Distributor rotation: Clockwise

Feb 14, 2010 | 1998 Chevrolet Tahoe

1 Answer

I need the diagram to put the spark plug cables


2003 Chevrolet Malibu 3.1L SFI OHV 6cyl
Spark Plug Wires - Removal & Installation

3.5L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.
  2. Remove the intake manifold cover, if required.
  3. Disconnect the left side spark plug wires from the spark plugs.
  4. Disconnect the left side spark plug wires from the ignition coil.
  5. Remove the spark plug wire clips from the Manifold Absolute Pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
  6. Remove the spark plug wire assembly.
  7. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.
  8. Disconnect the right side spark plug wires from the spark plugs.
  9. Disconnect the right side spark plugs from the ignition coils.
  10. Remove the spark plug wire assembly.
  11. If replacing only one plug wire, open the retaining clip and remove the appropriate spark plug wire.
To install:
  1. Install the spark plug wire assembly.
  2. Connect the right side spark plugs to the ignition coils.
  3. Connect the right side spark plug wires to the spark plugs.
  4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
  5. Install the spark plug wire assembly.
  6. Connect the left side spark plug wires to the spark plugs.
  7. Connect the left side spark plug wires to the ignition coil.
  8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
  9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
  10. Install the intake manifold cover, if required.

Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system
74d742b.jpg


Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
306b531.jpg


Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
9313fa7.jpg


Fig. 2.4L Engine Firing order: 1-3-4-2 Distributorless ignition system
2c9af72.jpg


Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
d929c16.jpg


Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system
f357cd3.jpg

Fig. 3.5L & 3.9L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system
09e9db9.jpg

I really hope help you with this (remember rated this help) Good luck.

Sep 23, 2009 | 2003 Chevrolet Malibu

Not finding what you are looking for?
1992 Chevrolet K1500 Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...