Question about 1993 Dodge Caravan

1 Answer

When I start the car in the morning it sounds like it is going to stall. The idling speed goes up and down. It will run fine ,no lose of power or hesitation. I have replaced the distributor cap and rotor, the spark plugs and wires. Could it be a sensor. I have a 1993 Dodge Caravan 6 cylinder 3.0 liter.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 707 Answers

The EGR valve may need to be changed out............Hope this helps.

Posted on Nov 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix my BMW X3 2004 it has trouble starting on cold starts in winter and it stalls? Any solutions? More details below.


First thing to do is run a fuel pressure leakdown test. borrow or buy a fuel pressure test gage for you car and hook it to the fuel injection rail test port, then start the engine and shut it off the pressure should not drop by more than 5 PSI, if overnight it drops to near zero PSI you have a failed fuel pump pressure check valve and you need a new fuel pump. Also clean the throttle valve and the idle speed control valve with spray throttle valve cleaner.

Jun 24, 2016 | 2004 BMW X3

1 Answer

Why it stalls at stops and low speeds


accord stalling on every stop. (1/2) - EricTheCarGuy ...

www.ericthecarguy.com/.../8.../46884-accord-stalling-on-every-stop
The car runs good but stalls every time i come to a stop. ... a stop then it diesagain.only on the stops does the idle drop very low to the point of stalling.what ... only when I start slowing down and come to a complete stop RPM's go down and the cardies. ... The popular Honda Civic and Accord vehicles share many powertrain ...

1998 Honda Accord loses rpm/ stalls coming to a stop ...

honda-tech.com/honda-accord.../1998-honda-accord-loses-rpm-stalls-co...
Jan 10, 2013 - I just bought a 1998 4 cyl 2.3 L Honda Accord two days ago. ... 1998Honda Accord loses rpm/ stalls coming to a stop. .... Is clockwise high idle or low idle? all in all i probable rotated counterclockwide 1.5 or 2 turns. maybe this ...

1999 Accord, 130k+, stalls when slowing to a stop - Honda Accord ...

www.hondaaccordforum.com > ... > General > General Tech Help
Mar 10, 2010 - My fiancee's '99 Accord EX Coupe 4-cylinder automatic, with 130,000+ miles, has recently (in .... No low RPM & feeling like it's GOING TO stall.

99 Honda Accord - Strange Stalling Issues! HELP!

https://www.2carpros.com/.../1999-honda-accord-99-strange-stalling-issu...
My 1999 Honda Accord is having sporadic stalling problems. I've noticed a pattern. Itstalls while going slow speeds and stop and go traffic, etc. The engine just ...

Stalling or Low Engine Idle Speed Due to Dirty ... - Repair


Jan 02, 2016 | 1999 Honda Accord

1 Answer

My car is stalling when idling and sputtering when driving like it is losing power


Try some gas line anti freeze (methle hydrate) It will dissipate water which may have been at the bottom of the tank. If he put regular gas and you put super, add octane boost. and drive for half hour and it will clear.

Dec 15, 2013 | 1999 Saab 9-3

2 Answers

My car will start and idle fine sometime and sometime it dies and dies when put in gear


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 06, 2012 | 1986 Ford Mustang

1 Answer

I have a 2000 ford explorer sport 4.0L OHV, in the mornings when first started it runs real rough until it goes through its cycle of runing rough then it cleats up and runs ok. Then when u park it after...


Here are the most common causes of idle surge, rough idle esp when cold, other symptoms include stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Jul 09, 2017 | Cars & Trucks

1 Answer

I have mercury villager 1999 ,when started in morning idler ok , after run for 20 mnts engine stall in idler turn off ,end stared back up ok give gas go normal , and star again idler low like lose power...


Read the following and follow the instructions for this problem.

Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Sep 28, 2017 | 1999 Mercury Villager

2 Answers

Car starts poorly during cold mornings. The idle


Sounds like a cold start valve (which is actually an additional injector in the intake to assist in cold starting) If you can get it to your local prts store while the light is on they will read the codes for free and tell you what the car thinks is amiss.

Nov 13, 2009 | 1992 Acura Vigor

2 Answers

I have a 2001 ford focus


near the fire wall in the back of the engine you have the throttle body where the air goes in the engine 3or 4 inch bellow that there a hose it goes in the air intake start the car you should ear a hissing sound in there the rubber pice that plug in the throttle body got a hole in it block it with our finger the car should run fine that part come with the hose that go in the front hope it help fixya our post thanks pierre

Jul 19, 2008 | 2001 Ford Focus

Not finding what you are looking for?
1993 Dodge Caravan Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...