Question about 1995 Dodge Intrepid

1 Answer

Trunk release, interior lights, locks etc does not work

I replaced the fuse that controls all of these funtions but still none of them work. i recenly wired a system into my car and i need to get into my trunk to fix my subs. the key that goes to the trunk feels like it will snap if i turn it in there. it may not be the right key but im pretty sure it is, and im defintly hurting without my interior lights and locks. any solutions?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi,

To open the trunk, you could try:
1. using the key, push down on the back of the trunk while turning the key. A word of caution and try not to force otherwise, the key might be twisted cut;
2. use the automatic trunk opener (in the glove compartment). You would need someone to press down on button while another is pushing down on the back of the trunk;
3. alternately, there are some models where the rear seats fold down and opens into the trunk.

On the fuse/interior lights and locks, if you have replaced with a known good fuse and problem persist, it may be caused by:
a. corroded or loose fuse holder;
b. corroded or loose fuse block connector;
c. corroded or loose harness connector (unfortunately inside the trunk);
d. defective wiring harness;
e. loose ground.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2008 CTS trunk won't unlock


Hi Jeff,
I was going to say, check fuse/ jump the load side of relay Good post.
trunk 1-a4vvaacye2kqxo12bveg1ioe-1-0.jpg

trunk 2-a4vvaacye2kqxo12bveg1ioe-1-2.jpg

Mar 19, 2017 | Cars & Trucks

1 Answer

Fuse diagram


boot wont unlock pergut 307

Nov 10, 2013 | 2009 Nissan Maxima

1 Answer

Interior lights, radio, power mirors, remote door lock and power truck release do not work at all. Replace fuse and still dont work. Any ideas? Thanks


it is your body control module. . did not mix it up with the computer. the bcm runs every thing inside the car locks/radio/mirrors /etc.. in your car it is part of the fuse box under the dash

Jan 04, 2013 | 2001 Chrysler Sebring

1 Answer

Is there a fuse for the trunk release button for a 2003 bmw 325i


Yes there is a fuse for the trunk opener.also,do you have a valet switch to shut it off?

Aug 28, 2012 | Cars & Trucks

1 Answer

No trunk light, trunk release, or back-up lights: Please help!


How can I adj. . a trunk light switch on a 02 Buick Century

Sep 26, 2009 | 1999 Buick Century

2 Answers

2000 Concorde - power locks, interior lights, radio not working


There is most likely a fault in the system and it will have to be reapired by certified tech

Jun 25, 2009 | 2000 Chrysler Concorde

2 Answers

Electric windwows, door locks, alarm, interior lights not working


Sounds like you may have a bad ground clean battery terminals!! get wiring schematic!!!! Good Luck!!!!

Jun 22, 2009 | 2002 Audi A4

1 Answer

Power lock , interior top light, Trunk button are not working


Your vehicle is not a Hyundai Elantra -- problem solved!

May 11, 2009 | Hyundai Elantra Cars & Trucks

1 Answer

Trunk release, interior lights, locks etc doesn't work


You might want to check with the dealer to see if you have the correct key. You could try some WD-40 on the lock. As far as getting to your trunk, you could go in from the back seat.
Did you check the circuit going to your lights with a meter?

Jun 15, 2008 | 1995 Dodge Intrepid

Not finding what you are looking for?
1995 Dodge Intrepid Logo

360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

71043 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6981 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...