Question about 2005 Suzuki Swift

Open Question

I get a shaky start up in morning engine light and p1781 code is showing on the reading usually does this 2 or 3 time a week seems to be ok when car is going for a while is 2004 suzuki swift hatch back

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 68 Answers

SOURCE: high fuel consumption on Suzuki swift 2003.

hi
im dave
Is there a leak in one of the fuel lines? Check the length of the fuel lines from the pump (you may need an extendable mirror to see the top of gas tank) right up to the point where it enters the fuel rail on the engine. Take special note of the junctions and try to do it with the car running and at a slight idle so fuel is pumping. Check next for a smell of too much gasoline along the fuel rail as one of the injectors may be improperly seated and or broken and leaking. Has the service engine check engine light come on at all or come on and gone out. If your o2 sensor(s) go you use more fuel. If they go there should be a code stored in your PCM (computer). You can pull any codes out of that car by finding the connector and jumping it. Also if your air element(filter) or any pipes are clogged in that system up to the throttle body you will use much more fuel.

Let me know how these tests go

Posted on Jul 15, 2008

Ad
  • 132 Answers

SOURCE: my check engine light is

Yes this is the code. Code 51 is a EGR flow problem

Posted on Feb 01, 2009

  • 1 Answer

SOURCE: reassembling gearbox 1995 suzuki swift

Hi,i have a problemh with gare box for my suzuki swift 1996.reg no is p476kov,when i change the gare from first in to the second makes a loud noise,could you help me and advice me how to solve this problem,and if the gare box is broke can u give an estimate price,thanks

Posted on Feb 08, 2009

  • 87 Answers

SOURCE: Check Engine light reset on 2004 Suzuki Verona

You can disconnect the negative cable of the battery for a couple of minutes (but you will lose radio settings and possibly others that the car will relearn), or you can go to an auto parts store such as Advance Auto or Pep Boys and they have a free scanner service to diagnose problems that should be able to reset the light. Mine does.

Posted on Jun 02, 2009

  • 74 Answers

SOURCE: I have purchased Suzuki Swift 2004 Model. Which

use the oil the manual says to use

Posted on Jun 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car struggles to start from cold; when it starts, it immediately dies out again.


have the fault codes read
indicates a problem ambient temp sensor, baro sensor or MAP/VAF sensor problems
reading the fault codes is something the garage should done forst

Mar 12, 2017 | Cars & Trucks

2 Answers

P0300: SOMETIMES rough idle, shake a lot OR less power above 50mph then got this code


Spark plugs in your car are good for 100,000 miles. try changing fuel filter and add a can of B&G 44K fuel additive. This stuff is the best on the market and only available at dealerships. It conditions fuel pump and injectors, also absorbs water in fuel (methanol). Try this first, your car is too new for any other problems. this should help drivability and fuel mileage. If Nissan does not have B&G, I know Toyota does. Also stay with 91 octane fuel. Check oil and coolant often. do not risk overheating in traffic, watch your gauges......

Feb 28, 2017 | Nissan Sentra Cars & Trucks

1 Answer

Check engine light is on. Codes are p1781, p0113 and p0700. What do they mean? Thanks.


DTC P0113 - Intake Air Temperature Sensor High Voltage
To diag this code you will need a volt/ohm meter. Need to check for 5 volt reference in to sensor from PCM, and ground side of sensor to PCM. Also, check carefully the wires at the sensor. The wires may be broken inside the insulation, right at the connector of the sensor. Pull on each wire slightly and see if it starts stretch. If it does, then the wire is broke inside the insulation, and will need to be repaired.


DTC P0700 - EATX ControllerIs
Is a generic transmission control code. This code lets you know that a specific failure code is stored in the TCM (Transmission Control Module) and needs to be retreived with a diagnostic scanner with TCM reading capabilities. It may or may not be related to the ROM failure in the ECM (Engine Control Module).


DTC P1781 - Engine Torque Signal Circuit
This code is set during engine start up when the ECM and TCM do not communicate properly during initial power up. It will only illuminate the service light if the condition occurs in 2 consecutive start cycles, but the DTC will be stored in the failure records after the first cycle.


Hope this helps.

Sep 30, 2011 | 2003 Saturn ION

1 Answer

P1781 DTC


DTC P1781 - Engine Torque Signal Circuit

This code is set during engine start up when the ECM & TCM do not communicate properly during initial power up. It will only illuminate the service light if the condition occurs in 2 consecutive start cycles, but the DTC will be stored in the failure records after the first cycle.

Hope helps.

Jun 24, 2010 | 2004 Chevrolet Aveo

2 Answers

Battery warning light coming on after a mile , but battery isnt flat and car starts 1st time and lights are ok Car is puegeot partner combi. Stop car and it and it ok for another mile . Battery doesnt seem...


Check your alternator as it sounds like it may be starting to go. The battery light trips when it detects an issue with the charging system. Very rarely, the battery light can trip if there's an issue with the PCM, but this is very rare.

Take a voltmeter with the car off and measure the voltage on the leads of the batter, should be around 12V+-.2. With the car running, measure again and this time it should read 13V-14V. If it does read 13V-14V then it means that the alternator is working. If it is below 12V, then it means your alternator is not charging the battery properly. If it's above 14V, then it means your alternator is overcharging and damaging the battery.

Oct 21, 2009 | 2005 Peugeot 405

1 Answer

SERVICE ENGINE SOON LIGHT CAME ON YET MY CAR DOESNT MAKE ANY FUNNY NOISES


THE OIL CHANGE INDICATOR WILL NOT CAUSE THE SES LIGHT TO COME ON.THEY MAY HAVE LEFT SOMETHING DISCONNETED NEAR THE AIR CLEANER HOUSING WHEN CHECKING THE FILTER.IF NOT HAVE CODE READ(SHOP/PARTS STORE)

May 15, 2009 | 2004 Mitsubishi Endeavor

1 Answer

2000 Dodge Intrepid Wont Start


first of all, check your code to see what the car computer shows. To do that , insert the key in the ignition and switch it on three time within 2 seconds and the third time live the key in the on position. All the instrument panel lights will lite and the oddometer will display the fault code that may br the cause for your car not starting. goood luck.

Apr 29, 2009 | 2000 Dodge Intrepid

1 Answer

Mitsubishi Mirage 97 1.8 Starts shaky


buy yourself a couple bottles of gas line antifreeze... it's alcohol (not the kind you drink)... try that and let me know how runs after that.

Robert

Sep 22, 2008 | 1997 Mitsubishi Mirage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...