Question about 1995 Chrysler Cirrus

2 Answers

How to disarm a factory alarm without the keyfab

Hello,
Recently, I just had some work done to my 95 cirrus and inadvertently the factory alarm which I didnt know existed in the car, tripped and now the car wont start. I bought the car from a dealer who got it from a dealer auction. He didnt give me a keyfab and I actually didnt know I was supposed to have one to begin with. In any event, the car wont start. The mechanic who did the work was even stumped a bit by this. He tried to disarm the car by (1)locking the doors from the inside,(2)getting out and shutting them,(3)unlocking them manually from outside,(4)getting in and restarting the car. No dice. So, HELP! Is there any other way? Your help will be greatly appreciated! Thanx.

Posted by on

  • 2 more comments 
  • shasta806 Jul 19, 2008

    Hello,
    Recently, I just had the crank shaft sensor on my 95 cirrus and inadvertently the factory alarm which I didnt know existed in the car, tripped and now the car wont start. I bought the car from a dealer who got it from a dealer auction. He didnt give me a keyfab and I actually didnt know I was supposed to have one to begin with. In any event, the car will start but turn right off in about 5 seconds with this alarm going off??? don't know if there is a reset button somewhere or what to do to at least get the alarm off??

  • Cris_taggart Aug 23, 2008

    I also have a 1995 Cirrus, and today I went into Target, locked the car (manually, no key fob) and when I came back out, my car wouldn't unlock. I manually unlocked the car and the alrm went off, without stopping. I pulled a relay and a fuse, disconnected the battery, all with no luck. My car is still sitting in the Target parking lot. I hope to have an answer soon....

  • mrenner4 Sep 08, 2008

    i need to find out how to disconnect or bypass the factory alarm on my 95 cirrus 2.5L V-6. with out the remote lock/unlock that i dont have?

  • Anonymous Jan 21, 2009

    hello my car after i put the sterio my alarm when on now the car starts but die realy fast and the alarm goes on?

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Here is what I do on my 95 Cirrus I also do not have a keyless remote (well I do but is broke) and after frustation after frustation trying to disarm the factory alarm I find out that by unlocking the passenger front door with the ignition key from the outside will disarm it you may have to try few times before it's disarm you need to make sure that the blinking red light stops blinking and all of the locks on all 4 door are up or unlocked, this is what I been doing for 3 years now and that's how I disarm the alarm on my car, I hope this helps.

Posted on May 19, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 78 Answers

Have the door panel removed. On the back of the lock cylinder(should be but it maybe loose)harness. manipulate the harness to disarm the factory alarm. Car should start. Vonfrankln@aol.com

Posted on Apr 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Interior lights on 95 grand am done went slap stupid.


Power Output Diagnostic Mode
You may use a power output diagnostic mode in the multifunction alarm module in order to run a quick test on the operation of the following outputs:
• The courtesy lamps control
• The inadvertent power control
The power output diagnostic mode activates after you perform all of following actions:
• Close all of the doors.
• Set the park brake.
• Turn the ignition switch to RUN.
Before 15 seconds pass, perform the following steps:
• Open the right front door.
• Cycle the headlamp switch from OFF to PARK three times.
During a normal operation, the multifunction alarm module will flash the interior lamps until the ignition switch turns OFF. If an internal short occurs in the multifunction alarm module, the module will chime in the following patterns:
• One chime every 3 seconds implies an inadvertent output failure.
• Two chimes every 3 seconds implies a courtesy output failure.

Sep 14, 2017 | Cars & Trucks

1 Answer

Just replaced the crank sensor on my chrysler cirrus 1996. the factory alarm reset itself. i had previously turned it off. cut the volume wire so lights just blink and makes clinking noise. i can start the...


Thats not a factory alarm that aftermarket. go under the steering column and remove the whole alarm set up. or better yet find a relay that is attach to the starter signal (match the color) and restore how it used to be then you should be able to crank the car , if you sucessfull have bypass the alarm then go ahead and look for its ground and just cut it. The aftermarket cuts into the ignition switch starter signal so that is where you locate the starter relay alarm.

May 22, 2011 | 1996 Chrysler Cirrus

1 Answer

95 camaro, factory alarm wont let me start the car what


U will need to bypass the factory VATS (vehicle anti-theft system) system, it is very simple and all you need to know is at the web page link below.

http://vats.likeabigdog.com/

Jul 20, 2010 | 1995 Chevrolet Camaro

2 Answers

How can i disarm the factory security alarm.i have tried the key locks. i have no remote with the car. i didnt know it had an alarm when i bought it . 1995 chrysler cirrus


Here is what I do on my 95 Cirrus I also do not have a keyless remote (well I do but is broke) and after frustation after frustation trying to disarm the factory alarm I find out that by unlocking the passenger front door with the ignition key from the outside will disarm it you may have to try few times before it's disarmed you need to make sure that the blinking red light stops blinking and all of the locks on all 4 door are up or unlocked, this is what I been doing for 3 years now and that's how I disarm the alarm on my car, I hope this helps.

May 15, 2010 | 1995 Chrysler Cirrus

1 Answer

A shop worked on my 98 mustang. they disabled the factory alarm. how do i enable the alarm so i can use the remote entry, etc.


The only sure way is to ask them where they disconnected it. I don't know if they unplugged a connector, cut a wire, or pulled a fuse. If they did this inadvertently, they should repair it at no charge.

Sep 21, 2009 | 1998 Ford Mustang

1 Answer

Alarm system malfunction


Do you have a (FOB) for your car, if so use the unlock button

Jul 06, 2009 | 1995 Chrysler Cirrus

1 Answer

Alarm system stoped working on 87 caddy fleetwood


First question , is it a FACTORY alarm or an AFTER MARKET alarm. Regardless, I haven't met an alarm yet, that protects the radio.. My guess is, that if it is an aft/market alarm, inadvertantly placed the system in the "VALET" where it doesn'i work. Let me know if you disconnected battery, and are there alarm toggle switches.

Mar 23, 2009 | 1995 Cadillac DeVille

2 Answers

Coolant sensor


refill and bleed the cooling system.  The water from your overflowing radiator may be the cause of you engine problems....dry of the motor.

Oct 16, 2008 | 1996 Chrysler Cirrus

Not finding what you are looking for?
1995 Chrysler Cirrus Logo

1,381 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...