Question about 2002 Mazda Protege

1 Answer

How to remove a factory 2002 protege stereo system

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Hmmm........take out the screws and pull on it!

Posted on Nov 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mazda protege 2002 started shaking after I put in a new stereo system I thought it might be my battery terminals not hooked up to the battery properly but it wasn't Any suggestions


Firstly remove the stereo system and see if that fixes the problem as if it started after you installed it then you have interfered with the power systems for the ECM. Best have the stereo system fitted professionally if that is the case.

Apr 19, 2014 | Cars & Trucks

1 Answer

Remove dash on 2002 chevy tracker and remove factory stereo and install new one


Glad I didn't read this page before I replaced my stereo.

Remove stereo fascia with three screws - 1 at the top, two on each side of ash tray. Remove 4 screws holding in stereo. Done - takes about 3 minutes.

Oct 29, 2011 | 2002 Chevrolet Tracker

1 Answer

Mazda protege fuel pump 02


to take the seat out you have to pull up on it hard. before u start connect the neg. side of the battery. open the gas cap to help to let the or some of the pressure out of the tank.remove the fuel pump cover and unplug the electrical connector and disconnect the wire on top of the fuel pump. disconnect the fuel supply and return hoses from the pump. be careful when trying to unscrew to screws you might have to tip on them to loosing up the lock tight that was put on the screws from the factory. than carefully lift the pump out. disconnect the electrical and move the hose clamp clear the pump fitting. remove the band securing the pump to the bracket and bracket at the bottom of the pump with the rubber mount. remove pump and always remember that gasoline is extremely flammable so take extra precautions when you work on any part of the fuel system. good luck.

Jan 03, 2010 | 2002 Mazda Protege

1 Answer

Mazda protege with no dashlight on.


First you must cut the Dimmer wire from your stereo installation.Second, replace the 5amp or maybe the 7amp fuse that blew at the fuse panel near the LEFT foot rest.If you are certain that all the fuses check fine, then go to your MAZDA dealer and purchase a new thumbwheel dimmer control,because the rheostat has burned in your present one.Do not reconnect the dimmer control wire 2 your stereo wiring,because U don't need to.

Aug 30, 2009 | 2002 Mazda Protege

1 Answer

Car stereo sound cuts in an out


had the same problem. volume super high or nothing.auto wreckers $100.00 problem fixed

Mar 25, 2009 | 2002 Mazda Protege

1 Answer

How do i take out the factory stereo in a 95 mazda protage


this takes a special tool designed for european cars - you can get this usually at wal mart or an auto parts store - relatively cheap (couple of bucks) and easy to use - well worth the money considering it is almost impossible to remove without them! hope this helps

Jan 03, 2009 | 2002 Mazda Protege

3 Answers

How to remove the stereo from a 2000 Mazda Protege


gently pull of the moulding around the top ac vents and control knobs, then yes, use a flat head screw driver to pry at the feathered mount at the bottom of the stereo. careful not to pull to hard the ac/heat controls could disconect. pain in the *** to put back.

Sep 13, 2008 | 2000 Mazda Protege

1 Answer

Mazda protege antitheft system


2001 protage the battery keeps dying. What could be the problem.

Sep 11, 2008 | 2002 Mazda Protege

1 Answer

Pontiac 2002 stereo


hi
im dave
your vehicles stereo is equipped with an antitheft system that render it inoperable once removed. If you are replacing with another ac delco make sure you have the code for that stereo. If you are replacing it with after market then find the section in your owners manual that tells you how to set the code, set it and write it down (maybe on the stereo) so you can sell it as those factory ac delco stereos are quite pricey

Jul 15, 2008 | 2002 Pontiac Aztek

Not finding what you are looking for?
2002 Mazda Protege Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...