Question about 2002 Nissan Maxima
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2002 nissan maxima, check engine
About DTC P1800, I suggest check the harness and verify it is plugged in and still functioning.
Also, try checking your vac tubes to verify that they are not reversed. Also read this TSB with details about correct diagnostic: DTC P1800 VIAS CONTROL SOLENOID VALVE
The VIAS control solenoid valve cuts the intake manifold vacuum signal for power valve control. It responds to ON/OFF signals from the ECM. When the solenoid is off, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger downward and feeds the vacuum signal to the power valve actuator.
DTC detecting condition:
• An excessively low or high voltage signal is sent to ECM through the valve
• Harness or connectors (The solenoid valve circuit is open or shorted.)
• VIAS control solenoid valve
Will need replaced the solenoid valve (P/N - 149558J10A). The valve is located under the engine cover. It's a Nissan only part so you have to order from the dealer, either online or in person. It's cheaper online. Check this sample Nissan engine location (click image for zoom)...
DTC P1147 - Bank1 Sensor 2 O2 sensor maximum voltage monitoring
Component Description: The heated oxygen sensor 2, after three way catalyst, monitors the oxygen level in the exhaust gas on each bank.
Even if switching characteristics of the heated oxygen sensor 1 are shifted, the air fuel ratio is controlled to stoichiometric, by the signal from the heated oxygen sensor 2.
This sensor is made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. Under normal conditions the heated oxygen sensor 2 is not used for engine control operation.
DTC detecting condition: The maximum voltage from the sensor is not reached to the specified voltage.
Harness or connectors (The sensor circuit is open or shorted)
Heated oxygen sensor 2
Majority of cases this is either a faulty O2 sensor, or short/open in wiring harness. Bank1 sensor2 is the rear O2 sensor on the passenger (right) hand side (click image for zoom):
Here is simple test with voltmeter to test O2 sensor. If it fails test, replace sensor. If not, then you will have to start tracing the wiring harness for a short/open in it (click for zoom):
And here additional details: DTC P1147 O2 Sensor
Keep us updated.
Posted on Aug 01, 2011
Tips for a great answer:
Jan 16, 2018 | Nissan Cars & Trucks
Feb 01, 2013 | Cars & Trucks
Sep 21, 2012 | Cars & Trucks
Jul 13, 2012 | Cars & Trucks
Aug 10, 2017 | Infiniti Cars & Trucks
Jan 20, 2011 | 1998 Mercury Villager
Apr 23, 2010 | 2002 Nissan Altima
Jan 25, 2010 | 2002 Nissan Altima
Jul 29, 2015 | 2002 Nissan Maxima
3,972 people viewed this question
Usually answered in minutes!