Question about 1993 Geo Prizm

1 Answer

HOW DO I FIX FRONT TRANSMISSION SEAL AND HOW MUCH WILL IT COST?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,317 Answers

You'll need to remove the transmission, the remove the torque coverter from the transmission, the seal is mounted in the transmission where the torque converter goes in. The seal is $10-$20. I a garage may charge between 2 and 4 hours of labor.

Posted on Nov 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 93 crown victory Lx is leaking fluid from the back end of the motor and the front end of the transmission what is and how I fix it step by step


If its dark color it is likely rear main seal on engine. If it is red color it is front seal on transmission. check fluid levels, overfilling engine oil or transmission fluid can cause this also. both require major removal of tyranny etc. If you never done this get qualified help. .

Sep 17, 2014 | 1993 Ford Crown Victoria

1 Answer

How much would it cost to replace a front seal on transmission of a 1995 buick century special? How much for parts? Labor?


The seal is very cheap-a few dollars. The cost of labor will drain your wallet-the transmission has to be removed to replace the seal- a good 5 or 6 hour job, if not more.

Sep 12, 2014 | Cars & Trucks

1 Answer

My trans mission is leaking from the front and its not the pan gasket what could it be?


This area between the engine and transmission is where the front main seal is for the transmission. This could be a leaking seal or also the pump gasket. You could try some new transmission fluid with an additive to stop leaks. This would be the easiest, least expensive fix. To replace the seal the trans. has to come out of the car, and there is always other parts that will need to be replaced along with the seal or the new one will not last long. Hope this helps Fix Ya up.

Aug 11, 2011 | 2002 Chrysler Voyager

1 Answer

How much will it cost to replace the front seal on the transmission?


It will entail dropping the transmission. It will cost way more for the labor than the seal. Unless it is really bad I would put some Lucas transmission additive in and it should slow it down if not stop it. It is hard to tell you how much it would cost because depending on where you live labor rates can vary greatly. If you did decide to do it it may cost anywhere from $400-$1200.

May 10, 2011 | Ford Explorer Cars & Trucks

2 Answers

I have a 2000 beetle turbo and just notices it is leaking oil from around the plug which is tight and seeping transmission fluid. Is this going to be a costly fix?


OIL LEAK AROUND THE SPARKS PLUGS COULD BE LEAKING VALVE COVER GASKETS ALLOWING OIL TO SEEP BY GASKET FLOW DOWN AROUND SPARK PLUGS.TRANSMISSION LEAK IS NOT VERY EXPENSIVE LONG AS TORQUE CONVERTER SHAFT SEAL NOT LEAKING WHICH TRANSMISSION HAS TO DROPPED OUT TO REPLACE SHAFT SEAL.IF TRANSMISSION LEAK AROUND FRONT AXLE SEAL IT MAY COST A LITTLE.BUT PAN GASKET LEAK OR OIL COOLER LINES WONT COST TOO MUCH NOT HARD TO GET TO REPAIR.PHONE AROUND GET PRICE CHECKS.

Mar 24, 2011 | 2000 Volkswagen Beetle

2 Answers

My transmission fluid is leaking out of my torq converter housing. Any ideas as to why and what may need to be done to fix it?


HI. WELL MY FRIEND YOU HAVE A FRONT SEAL GONE IN YOUR TRANSMISSION. IF ITS A 2 WHEELE DRIVE IT NOT A BIG JOB BUT IF ITS A 4X4 ITS GOING TO COST ABOUT TWICE AS MUCH. SORRY. JIMBO

Aug 18, 2009 | 1983 Chevrolet Silverado

1 Answer

Transmission leak


the front shaft seal is bad on the transmission,pull out the transmission and replace the front seal which is about$8.00 for the seal

May 19, 2009 | 2002 Ford F250 Super Duty SuperCab

2 Answers

Leaking seal cost to fix?


which engine? if it's a 4.0L the seal is in the rear main bearing cap...I have seen people do a replacement without removing crankshaft but have never seen one done this way that worked. If leak is small, try some lucas sealer...It softens the seal and swells it a bit. Also use oil for high mile engines afterwards...that too contains a conditioner.
(cheper to try this than removing engine)
Good luck!!! If engine is not 4.0 check back with me and I'll tell you what I think. I didn't mention cost because engine removal is a lot of $$$

Apr 26, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Manual Transmission Filter?


The Borg Warner T-5 manual transmission has no filter. Assuming the leak is not really the rear main seal of the engine leaking, which is more likely, then it leaking from the front of the transmission. You will need to drop the transmission to get to the front seal on the first motion shaft. Unless you are really mechanically inclined or have a friend who is, leave it to a good shop.

Mar 03, 2009 | 1996 Chevrolet S-10 Pickup

1 Answer

1988 xj6 transmission front pump seal


The two seals should be fairly cheap. the seal itself shouldnt cost more than 5-10 dollars for each one. its a little round ring looking piece of metal with a rubber lining. to fix the front pump seal you'll have to drop the whole transmission and remove the torque converter which (will slide off without complications). the seal will be right behind the torque converter attached to the transmission... it should just pop out and the new one should just pop in. Fro the rear seal all you have to do is take out the drive shaft from the transmission and the seal will be on the end of the transmission.. it should also pop out and the new one should pop right in also. However, if the transmission was drivin with little or no tranny fluid and would not go into gear ..( meaning it would just go into high rpms and not move) your gears are probably shot. If it hasnt been drivin an easier way to tell if this may be the case is to look at the tranny fluid and see how dark it is. if it looks like motor oil instead of transmission oil its probably burnt up... if thats the case it will also smell burnt.

Feb 27, 2009 | 1988 Jaguar XJ6

Not finding what you are looking for?
1993 Geo Prizm Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...