Question about 2004 Land Rover Range Rover

1 Answer

Wont lift up on air it did and that day it slow lee went down and no wont lift up and the abs lihts on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,098 Answers


It sounds like the ABS pump has failed, or possibly two unrelated faults, could be the ABS sensor causing the light to come on but might be the fuse in the ABS that has gone. Its worth checking these two things first as they are cheaper.

Posted on Nov 07, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why do ABS brakes grab and push air?

hey check ur abs wheel speed sensors. check data when ur moving lf rf and rears should be reading same speed. its probably gonna be a bad wheel bearing cause that where ur speed sensors are built in to. u need a abs scan tool to monitor ur wheel speed parameters in order to pin point ur bad sensor. or pull codes from ur abs module and see what side it says is failing. good luck

Jul 13, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

1993 Lincoln Town car 3 years ago on a very HOT day my right front brake started violently grabbing, even without touching the brake. The ABS light comes on intermittently, it usually goes off after...

I had a very similar problem in my 93 town car. I ended up changing the Calipers, rotors, and pads. This stopped the grabbing, but still every once and a while the ABS light would come on and grip the brakes on me. I ended up pulling the ABS relay from under the hood.and the problem has stayed away. The only thing is that now i dont ABS brakes. Its a heavy car tho and i havent had an issue yet. Also, if you decide to do this, the relay way mis marked in my car, when i pulled the ABS relay, the Air shocks went out instead. Had to pull one at a time until the anti lock light came on, then i knew i had it.

Jul 13, 2011 | 1993 Lincoln Town Car

1 Answer

Abs liht on

What is the question?

ABS is the electrical part of your braking system

Do you not check for codes within a couple of days,
of getting any check light on your dash?

Their not new,they have been on all vehicles for 31 years

If you can't check for codes in a couple of days & diagnose
& repair the vehicle shortly after,stop using it.

Jul 05, 2011 | 2002 Mercedes-Benz E-Class

2 Answers

I,m tired to figure out the lihts ABS and Brake on some times and the abs system dont respond and emergencies cases,I replace the shocks front and rear, also i change the master cilynder and the brake...

check out the abs sensor, it is located on the rear axle of the truck, bolted to the 'pumpkin'-they commonly fail and exhibit all the symptoms you are describing.

Jan 26, 2011 | 1999 Dodge Durango

1 Answer

Car ran four days, went to start it and 'click', nothing. Went to repair shop who said it needed a new battery, installed. Ran another four days, went to start and 'click', nothing. Repair facility now...

If there is no power from battery to altenator, than the altenator is bad. Even some new ones can do that. Do check all your battery cable wires including ground wires. Make sure they are all clean. also tight.

Sep 08, 2010 | 1995 Lincoln Mark VIII

1 Answer

My 1994 buick lesabres abs lights on and when i went to drive it after it been sittin for a few month i went to stop it slowed down but then the brakes lock up

Locate where your abs sensor is and clean it this might do the trick.I have a ford F150 this does the trick just to clean it

Oct 03, 2009 | 1994 Buick LeSabre

1 Answer

Air Bag Light, Brake Light, & ABS Light came on in the dashboard.

Check and see if your alternator is charging
Low voltage will cause those lights to come on, as the computer is shutting down.

To check your alternator you will need a volt meter... WITH the engine running you should have about 14 volts coming out. IF NOT you need to replace the Alternator!

Apr 19, 2009 | 2003 Ford Windstar

3 Answers

97 sierra ABS problem

ABS comes on all by it self at low speed braking, A GM defect with their brakes!!!! Sensor thinks the tires are locking up an puts on the ABS, my advice pull the ABS fuse the brakes work better!!!!! Sensor is **** never had a problem with my Honda's ABS I sent a letter to GM 0 response, never will buy one again!!!

Feb 28, 2009 | 1998 GMC Sierra

1 Answer

ABS brakes, Traction Controll, Rear Air suspension, Wont Start

I recommend that you go to an autozone or a dealer or another mechanic and have the car put on the computer. That should pinpoint the problem for you.

Feb 12, 2009 | 1997 Lincoln Continental

1 Answer

Battery light comes on and stays on

Does it have a brand new alternator and battery? It definetly sounds like an alternator. Look for shorts and check the power cables connections and ground.

Jun 17, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2004 Land Rover Range Rover Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides