Question about Chevrolet Tahoe

1 Answer

ABS light on. Abs pump continues to run after engine shutoff. Where is the 60 amp fuse, so I can remove and continue to use my 2001 Chevy Tahoe. Also, can I get the abs module fixed instead of having to shell out $800 for another and $350 for labor to repair? Ernest

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,608 Answers

The fuse should be in the under hood fuse panel.The other thing you can do is disconnect the power wire to the ebcm.The ebcm is located on the passengers side below the drivers door area.Just unplug the 2 wire connector.It is the red and a black wire.About 10 gauge.The top part of this unit is the electronic brake control module and it is the cause of the motor running continuously.The problem is that water gets in to this and shorts out the unit.There are only 4 torx screws that hold this on but they are not easy to get at and sometimes they strip.I believe it is a number 20 torx bit.Hope this helps.Good luck.

Posted on Nov 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 Tahoe abs relay location


images for 2002 Tahoe abs relay location

Chevy ABS and Brake Dash Light fix - YouTube

? 24:15
https://www.youtube.com/watch?v=Jo76ylqgUR8
Dec 22, 2012 - Uploaded by Skizzot7
This is how to fix intermittent ABS and Brake dash lights on all Chevrolet ... That board is rather robust and is installed external to the vehicle in a location that sits .... I took the module out of a2002 Sierra and it is engineered with no T10 .... ABS Sensor and Harness 2000-06 Chevy Suburban Tahoe GMC ...

How I fixed a Chevy with an Abs and Brake light on - YouTube

images for 2002 tahoe wiring



Dec 09, 2015 | Cars & Trucks

1 Answer

Looking for Location of ABS relay on 2000 Chevy Suburban


there are 2 fuses only for the abs on the trk. 60 amp #2 maxi fuse and fuse #3 10 amp fuse for the ebcm. there isnt any relays for the abs.

Sep 27, 2012 | 2001 Chevrolet Silverado

1 Answer

Abs/tc continues to run with engien off and key removed. had to remove fuse to shut it down


When this occured on my vehicle, I was told the ABS controllor had failed, at a cost of over $1000. (This was on a 2001 Tahoe.)

Best to leave fuse removed till you get it repaired, a 2007 should still be under warranty I hope.

Aug 24, 2009 | 2007 Chevrolet Uplander

1 Answer

Anti lock brake pump always running and noisy


If the ABS pump continues to run, the most common cause is a leak in the hydraulic control unit. The pump may continue to run in order to to try to maintain operating pressure. Also a malfunction in the pump, stuck valves and devective accumulators are possible causes. A shorted pressure switch may also cause this condition.

Jul 09, 2009 | 2001 Chevrolet Tahoe

1 Answer

How do I fix my ABS control Module for 2001 Tahoe


you dont... you need to take it to a certified shop air bags are like that

Jan 06, 2009 | 2001 Chevrolet Tahoe

3 Answers

Where is the abs control module located on a 02 chevy avalanche ?


THE EBCM IS BAD this is the electronic control module that is on abs pump. you can replace seperate I think it is around 500 for part

Dec 30, 2008 | 2002 Chevrolet Avalanche

4 Answers

2001 Chevy Tahoe with ABS & Brake light on.


I hope you have the problem fixed by now, but, it is the ABS control under the truck. You need to go under the hood and open the fuse box and disconnect the 60 amp fuse for the ABS, this will turn it off before it burns up. This however will also cause the traction assist off light to stay lit all the time. To the fix the problem you can pay tons of money ($700 or so) to have the dealership install a ABS control and the problem will happen again over time. Or, remove it yourself, go on ebay and ship it off to a guy who repairs them for about $150 and you will never have the problem again. Also, if you wrap your cable ends with plastic and protect them good, you can still drive you truck while the part is being worked on. It takes about a week.

Nov 12, 2008 | 2001 Chevrolet Tahoe

1 Answer

2001 GMC Yukon SLT 5.3L V8 - whirring sound after engine is off


that is most likely your abs control module locate your 60 amp abs fuse under the hood and remove it if the noise stops you need to replace your control module

Sep 21, 2008 | 2001 GMC Yukon

1 Answer

ABS light and pump


after you took the fuse out and it stopped did you put the fuse back in and see if it continued to run?

Sep 02, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...