Question about 2001 Hyundai Tiburon
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: HYUNDAI TRANSMISSION
1. Drive the vehicle until the fluid temperature reaches normal operating the usual temperature [80-90°C (176-194°F)]. 2. Place the vehicle on a level floor. 3. Move the selector lever sequentially to every position. This will fill the torque converter and hydraulic system with fluid, then place lever in "N" (Neutral) position. 4. Before removing the dipstick, wipe all contaminate from area around the dipstick. Then take out the dipstick and check the condition of the fluid. The transaxle should be overhauled under the following conditions. a. If there is a "burning" odor. b. If the fluid color has become noticeably blacker. c. If there is a noticeably excessive amount of metal particles in the fluid. 5. Check to see if the fluid level is in the "HOT" range on dipstick. If fluid level is low, add automatic transaxle fluid until the level reaches the "HOT" range. Transaxle fluid: GENUINE HYUNDAI ATF SP-II, DIAMOND ATF SP-II or AUTRAN MMSP-II. Low fluid level can cause a variety of abnormal conditions because it allows the pump to take in air along with fluid. Air trapped in the hydraulic system forms bubbles which are compressable. Therefore, pressures will be erratic, causing delayed shifting, slipping clutch and brakes, etc. Improper filling can also raise fluid level too high. When the transaxle has too much fluid, gears churn up foam and cause the same conditions which occur with low fluid level, resulting in accelerated deterioration of automatic transaxle fluid. In either case, air bubbles can cause overheating, and fluid oxidation, which can interfere with normal valve, clutch, and servo operation. Foaming can also result in fluid escaping from the transaxle vent where it may be mistaken for a leak. 6. Be sure to examine the fluid on the dipstick closely.
Posted on Jun 30, 2008
You're right, the PO154 has to do with the O2 sensor. The code has the info of Oxygen Sensor Circuit No Activity Detected (Bank 2 Sensor 1).
Bank 2 is the exhaust manifold that cylinder #2 uses.
Sensor 1 is the sensor in BETWEEN the exhaust manifold and the catalytic converter.
No Activity Detected in the circuit could mean the O2 sensor is dead, or an open/cut wire going to the sensor.
That's about all the info you can get out of that code PO154.
Posted on Jun 07, 2009
Tips for a great answer:
Oct 28, 2014 | 2001 Volkswagen Passat
Jul 16, 2014 | 2001 Hyundai Tiburon
Dec 24, 2013 | Cars & Trucks
Dec 09, 2012 | Cars & Trucks
Aug 25, 2011 | Hyundai Tiburon Cars & Trucks
Feb 11, 2011 | 2001 Jeep Grand Cherokee
Aug 20, 2009 | 2001 Audi A6
May 20, 2009 | 2002 Volkswagen Passat
Jul 30, 2017 | 2001 Hyundai Tiburon
25 people viewed this question
Usually answered in minutes!