Question about 2002 Chevrolet Tracker

Open Question

My 2002 Chev Tracker 2.0 engine 4 cylinder horn won't blow.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 13 Answers

SOURCE: 1999 Chev Cavalier power steering oil - 4 cylinder

Most older gm cars you can use dexron 2 transmission fluid or find in your local parts store a good brand of universal fluid.

Posted on Jun 08, 2008

  • 44 Answers

SOURCE: oxygen sensor 2000 2 liter Tracker

You have an heated Oxygen sensor. 2 of the wires heat up the sensor and keep it at a certain temperature, it is turned on and off by the computer. The other 2 are use to send a very low voltage reading back to the computer to tell the computer if the engine is running rich or lean. I don't have a diagram to tell you which wire does what but you can get a manual and that should give you the information that you need and tell you how to trouble shoot it to tell if the sensor is bad or not, you may want to look for a wire laying on the exhaust, I have found wires burnt and lay on the metal.

Posted on Oct 31, 2008

  • 272 Answers

SOURCE: 1989 jaguar xj6 new engine or new cylinder???

At that price replace the engine. Make sure though that you get a warranty for the engine that includes the cost of installation if the new one fails. Most shops will warranty for 90 days which is long enough to find out if there is going to be a problem.

Posted on May 29, 2009

  • 83 Answers

SOURCE: how to change spark plugs on 2 lt 4 cylinder chevy

Remove spark pug wires from spark plugs. On this engine, it is located on the top. Remove all plugs with socket and ratchet. The socket size is a 13/16th. The new plugs should be pregapped if the correct ones where given to you. But check the factory spec for the gap. There is a sticker in the engine compartment that should tell you the gap. Gap the plugs as required and install them. DO NOT OVERTIGHTEN PLUGS, Double check factory tightening specs for plugs. Use a torque wrench to tighten plugs to required torque. If this this information is not available to you, then snug will be fine.

Posted on Jul 23, 2009

  • 1 Answer

SOURCE: tickin 2000 chev tracker

if its a ticking when you start from cold and goes away soon after start as the engine warms up it is most likely a crack in your exhaust manifold ( you may call it a header in the us) as it is getting the hot exhaust straight from the cylinder it heats up very quickly and closes the crack stopping the ticking. you should be able to get a nechanic to run a weld along the crack easily enough depending on where it is.

Posted on Aug 16, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Paint code for 2002 chev tracker exterior trim

there is a small plate attached in the engine compartment that has the paint colour code stamped into it
The 54U may be the colour and you may have to go to a service dealer to have it explained.

Feb 10, 2015 | 2002 Chevrolet Tracker

1 Answer

How do I replace fan belt on 2002 4x4 automatic tracker

Haynes manual from your local auto parts store will tell you.

Jan 28, 2015 | 2002 Chevrolet Tracker

1 Answer

I need to change out my spark plug wires for my 2002 Chev. S-10, 4 cylinder P/u

Change them one at a time ,match up the wire size with the old ones

Apr 25, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

91 Chevy Tracker won't start. went the ought big

Sounds like you have water in some of your distributuin boxes. Remove the covers and blow them out with compressed air.

Jun 17, 2013 | Cars & Trucks

1 Answer

1993 Geo tracker blows fuse when the horn is honked

If blowing fuse when honking horn you have a bad ground to the horn or the horn itself has a internail switch. Try using a higher amp fuse, good luck

Apr 04, 2011 | 1993 Geo Tracker

1 Answer

How do i can fix the horn does not work of my tracker 2002 where is the horn located

hi I have a 2002 vitara which is the same thing, did you check the fuse? my wife has the truck now but, I think its in front of the radiator, get in front of truck and look up near radiator.

Jun 17, 2010 | 2002 Chevrolet Tracker

1 Answer

Rear brakes on 2002 chev tracker squeal when applied

They may have become seized, which is when the brakes are hot, and you hit a water puddle, the water crystallizes the brakes. Thee will need replaced, if not it will tear up the rotor,

Feb 18, 2010 | 2002 Chevrolet Tracker

2 Answers

Tickin 2000 chev tracker

new lifters?,,,,,,an over haul could help.....but it takes alot of money.....

does it sound like almost a "diesel engine"

you know.....there are products that can help release lifters that have become sticky or noisy.......

alot of brands and chemystries but "RISLONE" could help....

Jun 02, 2009 | 2001 Chevrolet Tracker

1 Answer

Timing Belt 1999 Chev Tracker

go to register and look at the repair manuels this should help

Apr 05, 2009 | 1999 Chevrolet Tracker

Not finding what you are looking for?
2002 Chevrolet Tracker Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides