Question about 1996 Ford Ranger SuperCab
In my case was the Temperature Blend Door Actuator (electric motor inside is weak) this is very usual in Ford Ranger 2008. For all models part Number 19E616 AA.
1. Open the Gloves Box all the way down (is very simple, you will see it).
2. A white little box in front of you with a electric connector. That is the part to replace (see pic below).
3. Only 3 screws 5/16" and the electric connector (with a clip) The access is bad to the back screw, but I did it in like 2 hrs. Ford Dealer is going to charge you 6.3 hrs. because they remove the air bag.
Use a Combination Wrench (small) and a Roto Ratchet (small) this is all you need and lots of patience. You will get tired just rest and try little later.
Posted on Oct 06, 2012
One of two things heater core needs to be flushed out or heater control valve is bad
Posted on Nov 06, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Uplanders with the 3.9 engine are prone to no heat at idle speeds. Probably weeping head gasket. Air bubble trapped. Dealers will remove rad cap and let it sit at about 25 deg. angle for a couple hours. Good for awhile.
Posted on Nov 23, 2010
Sorry i don't see the problem, You say your heater motor is blowing hot air, Do you mean while the a/c is on? If so i would say your you may need your a/c charged up. But no the thermostate does not have a fuse, It is eather open or closed. Good luck .
Posted on Apr 01, 2011
You can put a higher temp thermostat and that should help, but it should at least have 170 degree air right now if it was working right. There are two other things you might check for, the diverter door make some sound when you switch from heat to cool and back, I can't tell you for sure if it is a manual, vacumn or electric but that would definitely cause it to blow cold air. There is also a valve which cuts off circulation to the heater core when your not using it. This valve will be in line with the heater hoses going to your heater core. I have seen some that were actually part of the heater core box. I feel pretty sure one of these will be your problem. Also if your car is low on coolant it would not heat properly. Hope this can help you!
Posted on Dec 15, 2008
Tips for a great answer:
Oct 10, 2016 | 1987 Ford Ranger
Oct 02, 2012 | 2008 Ford Ranger
Oct 26, 2011 | 2008 Ford Ranger
Apr 01, 2011 | 2008 Ford Ranger
Dec 26, 2010 | 2008 Ford Ranger 2WD
Feb 05, 2010 | 1998 Ford Ranger SuperCab
Oct 26, 2009 | 1997 Ford Ranger SuperCab
Oct 02, 2009 | 1991 Ford Ranger Supercab
8,979 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: