Question about 2006 Volvo S60

Open Question

How do i change the tail light bulb on my 2005 volvo s60. I purchased the bulbs and have accessed the tail light section through the trunk. Now what?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2005 Mustang, Rear Center Tail-light replacement

I remove back cover by pulling directly (straight) down.......It has no screws, that was what was a little confusing.......

Posted on Jun 09, 2008

Ad
  • 1 Answer

SOURCE: how to change bulb in bumpers on volvo v40

The amber lights in the bumper are a complete unit, (bulb cannot be removed without some or all of the amber light assembly) so unfortunatey you will have to go to your Volvo spare parts store & pick one up - front & back are different, as are left & right - check it. I paid €25 for a unit in Ireland.

Changing is a case of unscrewing as much of the bumper as you need to access it and clipping it out. It takes quite a bit of force to clip the new unit back.

Unfortunately I can't help about dash bulb.

Ciaran

Posted on Dec 17, 2008

latoss101
  • 47 Answers

SOURCE: Change dipped headlight bulb on a S60 volvo 2005

under the bonnet at the back of the light you will find a plstic cover this twist off then you can change the bulb .

Posted on Jan 03, 2009

  • 1 Answer

SOURCE: 2005 Subaru Outback XT - Real Tail light- bulb replacement

1. Open the rear hatch, and look down towards the bumper, in the direction of the tail light bulb needing replacement.
2. You should see the dark colored plastic trim piece, which is held in place by two small plastic body style philips head screws.
3. These wil only 'loosen' a little bit, you will need to slip a fingernail or some other slim item, underneath the heads of each of the screws, and pull back on them firmly by grasping the body of the screw, not the head (which is flimsy, and can crush if squeezed).
3. remove the plastic trim piece - it can be achieved by lifting out and towards you - set aside.
4. Using a 10mm socket or wrench, unscrew the upper and lower bolts holding the taillight assembly in place.
5. the taillight assembly is now loose - it can pulled rearwards, and will slide off of the small guide slots holding it in place.
6. The bulb is a twist lock style, underneath the tan cap- twist the cap counter-clockwise, and it will pop out. The bulb is a number 7440, for the running light/ brake light, and a 7443 for the turn signal. a 3757 will not fit through the cut out hole in the taillight assembly.
7. Re-assemble in reverse, making sure to check the function of the bulb PRIOR to re-assembly.
Good Luck.

Posted on Jan 03, 2009

  • 36 Answers

SOURCE: Message board states "Bulb Failure Position Light: What is this>

Hello mtsign

This a problem with "A" bulb, no real way to find the problem one unless you test the output of each bulb. You will have to replace them one or two at a time. Start with the rear bulbs as they get the most use i.e. brake lights. Sounds strange but, over time a bulb will lose it's strength and the computer picks it up as a bad bulb and sends the message, quite common with these vehicles. I would use quality replacement bulbs or you could be chasing around weak cheaper bulbs for a while. Hope this helps and good luck.

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change tail light bulb


I am not familar with your specific vehicle but most tail light bulb are replaced by unscrewing the outside lens cover. The other style has an access from inside the trunk. You remove the cover and there are the bulbs.

Feb 20, 2010 | 2005 Dodge Durango

3 Answers

Bulb failure, position light


Bulb failure, position light means you have a burned out light bulb somewhere. I had the same problem on my 2002 s60. It looked like all the lights were working but I found out that there are several bulbs in the tail lights, so even though the tail lights were working there was in fact a burned out bulb. Look at the bulbs a bit closer and you will probably find one thats bad.

Oct 06, 2009 | 2006 Volvo S60

1 Answer

Bulb Failure position option


the position bulbs are located in the trunk and you access them the same way you access the tail lights im not sure what the bulb does but its a 10 dollar fix. FYI when you replace the bulb the message center will still tell you that it has failed you have to take it to the dealer to have them to erase the message (i just left mine it seemed a waist of money)

Sep 01, 2009 | 2004 Volvo S60

1 Answer

How to replace rear turn signal bulbs?


Remove trim panel inside trunk. A plastic nut retains tail light assembly in body. Remove the bolt, slide whole tail light from body, disconnect the wires, twist bulb socket to access bulbs.

Jul 04, 2009 | 2005 Volkswagen New Beetle Convertible

2 Answers

Position Light on Volvo S60


Not sure but maybe you should verify rear position lights located in the trunk.
There are two bulbs on each side, even if you replaced one of them the other one could be burned.

Jean

Mar 13, 2009 | 2002 Volvo S60

2 Answers

Right side blinker/tail light out


That is just a Bulb. Replace that Bulb by opening the Trunk to access the Plastic Wingnuts to Open the Panel where the Bulbs are.

Jan 22, 2009 | 2005 Chevrolet Malibu

1 Answer

How to replace a tail light bulb in 2005 nissan maxima


Pop The Trunk And Inside The Trunk, Immediately Behind Where The Light Is There Will Be A Panel Of Carpeting Remove It. Then You'll Have Access To The Rear Of The Light Find The Burnt Bulb Grasp And Twist As You pull. Then Pull The Bulb From The Harness And Replace.

Jan 18, 2009 | 2005 Nissan Maxima

1 Answer

Change dipped headlight bulb on a S60 volvo 2005


under the bonnet at the back of the light you will find a plstic cover this twist off then you can change the bulb .

Jan 03, 2009 | 2001 Volvo S60

1 Answer

Replacing rear turn signal bulb in 2003 Mustang


remove the trim panel at the very rear of trunk, remove it and place it out of the way, remove tail light Assembly retaining nuts top and bottom, I think there are 6 per side, pull the tail light assembly straight back to access the bulbs for replacement.

Dec 04, 2008 | 2003 Ford Mustang

Not finding what you are looking for?
2006 Volvo S60 Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...