Question about 1996 Dodge Stratus

Open Question

How do you replace the climate control module? the knob that turns the air flow from defrost to floor is broken and the air flow is stuck on floor. i'm told it's easier to replace the module than try and fix it.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: There is no air flow

You need part GM Part number 89018675 or ACDelco 15-73596. The Mode Selector Actuator. What happens is the part is a CHEAP part POORLY designed and when it goes to turn the flaps inside the HVAC unit its the plastic gear slips instead of turning the flap!!!

Just to forward you you might want a deal to install this art for you unless your good at fixing your own vehicle, because you need SMALL sockets and a lot of patience to get this part in!!!

The part is ALMOST directly above the steering shaft for your steering wheel, so theres a lot you got to remove before you will even see them!!!

I only recommend you to have a dealer put this part in for you, unless you have your own service manual!!

Because there is 5 of these darn things and if you pick the wrong one you will have to do it all over again!!!

3 on the Drivers side and 2 on the Passengers side!!

But replacing this part SHOULD solve all your problems!! AS it did for me and i was having the same issues as you have described!!


Posted on Jul 22, 2008

Ad
  • 512 Answers

SOURCE: 2003 Dodge Grand Caravan Blower stuck on

if this vehicle has auto temp control the pssible cause for your problem is the power module for the atc

Posted on Sep 25, 2008

  • 85 Answers

SOURCE: Heater/AC only works thru defroster vents on '98 Contour

you prob have a vac leak on the back of the intake. good luck

Posted on Nov 23, 2008

  • 75 Answers

SOURCE: 2002 Nissan Altima - Heat doesn't get hot and doors get stuck

Did the switch break because it was stuck? If so, then yes, they will have to change actuators and doors. Does the fan work on all speed setting? If so then you do not need a blower resistor. The resistor pack only controls the current flow to change speeds of the fan.

Posted on Dec 05, 2008

philriden
  • 146 Answers

SOURCE: 1998 Mustang - AC blows only through Defrost vents

You probably have a vacuum leak on the passenger side. its a small plastic hose some times they come unpluged from the engine. or brake.

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Ford Taurus front defrost not working


. Air won't blow out of the floor or center vents just defrost ? Do you have manual or automatic climate control ?
Air Flow Control
Air flow control is accomplished in the following manner:
  • Primary control is through the function selector knob mounted on the A/C-heater function selector switch, which is part of the integrated control panel.
  • The function selector knob has the following positions: OFF, MAX A/C, A/C, PANEL, PANEL/FLOOR, FLOOR, FLOOR/DEFROST and DEFROST. The A/C-heater function selector switch combines a vacuum selector valve with an internal electrical switch.
  • The vacuum selector valve directs source vacuum to various vacuum control motors (18A318). Refer to the Vacuum Control Diagram , System Airflow Schematics and Vacuum Control Chart .
  • Two internal, single-pole electrical switches are also controlled by the A/C-heater function selector switch. The combination of these electrical switches controls the electrical supply to the A/C clutch and heater blower motor switch (18578).
  • The position of the function selector knob determines the manner in which the system will operate.
  • Each position of the function selector knob is detented for positive engagement.
  • Vacuum Control Motors The vacuum control motors (18A318):
    • are located on the A/C evaporator housing, A/C recirculation air duct and heater air plenum chamber (18471).
    • direct system airflow to the vehicle interior as determined by the remote climate control module or manual override.
    • The five-passenger seating configuration has an additional vacuum control motor mounted on the heater air plenum chamber to control airflow to the rear seat A/C register (19893).


vacuum control motor-i4bq0ig33y1522pr2d2rrkk3-2-0.gif

Jul 09, 2017 | Ford Cars & Trucks

1 Answer

Replace climate control panel lights 05


take out the control box, check linkage and voltage both before and after the switch if you have voltage before the switch and not after then the switch is bad and needs to be replaced

Dec 11, 2013 | Volkswagen Jetta Cars & Trucks

1 Answer

1997 toyota camry climate control switch or servo not working fully


Blend doors not working. They are controlled electronically by small motors. Could also be something fell down in a vent and is blocking it from it's full range of motion.

May 26, 2017 | 1997 Toyota Camry

1 Answer

Climate Control - Heat and cool work fine. Air flow is directed to defrost /floor. No indication (Sound or sight) that the vacuum diaphrams are being activated. The display on the dash matches the...


Does your vehicle have manual or automatic climate control ? You system is stuck in floor an defrost mode ?

03 mercury grand marquis hvac air flow .-13qahwfdndst2y1hypmr2cdq-4-0.gif Item Part Number Description 1 18A318 Vacuum control motor-floor/defrost door 2 - Defrost air flow 3 18A478 Floor/defrost door 4 18476 Heater core 5 19860 Evaporator core 6 19805 Blower motor 7 - Outside air inlet 8 19A813 Air inlet door 9 18A318 Vacuum control motor-air inlet door 10 - Recirculated air inlet 11 18B545 Temperature blend door 12 18A559 Panel door 13 - Panel air flow 14 18A318 Vacuum control motor-panel door 15 - Floor air flow 16 - Vacuum from the engine intake manifold 17 19A563 A/C vacuum check valve 18 19A566 Vacuum reservoir tank and bracket 19 19980 EATC control
Pull the control panel an check for vacuum

vacuum lines hvac 03 grand marquis-13qahwfdndst2y1hypmr2cdq-4-2.gif Item Part Number Description 1 White Air inlet door 2 Yellow Floor/defrost door 3 Red Floor door 4 Blue Panel door 5 Black Source vacuum 6 - Not used


VACUUM APPLICATIONS CHART-ELECTRONIC AUTOMATIC TEMPERATURE CONTROL Switch Port Vacuum Harness Hose Color Func- tion Manual Override Selector Buttons OFF MAX A/C NORM A/C VENT FLOOR FLOOR/ DEF DEF 1 White Air inlet 2 Yellow Floor/ panel (partial) 3 Red Full floor 4 Blue Panel 5 Black
Source

May 21, 2017 | 2003 Mercury Grand Marquis

1 Answer

Floor heat does not work but defrost etc works is that still a heater core replacement?


If you have warm air coming through the defroster vents then your core is not gone. there is something blocking or bent on the heater box mechanism which directs the air flow up or down, or on the climate control knob which controls it, or in the cable which connect the two.

Nov 26, 2010 | 2000 Chevrolet Blazer

1 Answer

2003 Trailblazer No air from front face vents


first check to see if you have power going to the actuators when you switch the switch to it location if no power replace controller if you have power and no movement from actuators replace actuator. if actuators move remove hvac box and check for broken blend doors.

Jan 22, 2010 | 2003 Chevrolet TrailBlazer

2 Answers

The knob turns on the vent control but it does not change the air


you need to check the control wire is`nt broken most likely come out from flap connection just reconnect and it will work again,check the flap affected for free movement as could be jamming.

Jul 10, 2009 | 2000 Ford Focus

1 Answer

Climate control system only blow air out defrost vent


there is a good chance that you blend air door is stuck closed over your heater core and therefore not allowing the heat to flow, also your door that opens and close your direction of flow from the floor ,das,vent and defrost.your going to have to remove the lower cowling of the dash on the passenger side analso some of the center dash to actually check to see if the cable,servo motors. are acuating the doors.the issue could be just a stuck door or a misaligned cable or that it came off. that falls under the mechanical side of probabilities. electrical would most likely be a faulty selector switch or a servo motor

May 15, 2009 | 2002 Ford Expedition

1 Answer

I have a 97 SIERRA. HEAT WORKS FINE ON DRIVERS


If you have climate controls that are "slide type" knobs...likely that the cable that controls the diverter panel in the blower box is broken....

Feb 27, 2009 | 2000 GMC Jimmy

2 Answers

No dashboard heat output


The climate control was poorly designed on these cars.

There is only heat on the floor and defrost settings, due to the layout of the ductwork.

Oct 22, 2008 | 1989 Ford Festiva

Not finding what you are looking for?
1996 Dodge Stratus Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...