Question about 2007 Chevrolet Tahoe

1 Answer

2007 chev tahoe revere lights stay on - 2007 Chevrolet Tahoe

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 339 Answers

The fuse for the reverse lights is located on the underhood fuse block. Look for the fuselabel VEH Backup and it's 10amps. If the ignition is switched off, transm in Park, and the reverse lights still on, try removing this fuse. The reverse lights shoud be off, which means the wiring from the fuseblock going to the reverse lamps is not the fault. If the lights stayed on after removing the fuse, then you have two possible culprits. The underhood fuseblock may be shorted, or a BCM (Body Control Module) that is malfunctioning. This is assuming that the wirings going to these components are normally sound. This requires thorough testing procedures.. goodluck and have a nice day. : )

Posted on May 20, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2007 tahoe o2 sensor, installed new o2 sensor but engine light stays on. code says bad

which sensor was replaced
there are 2 sensors involved
one after the cat converter and one in the exhaust manifold /pipe before the cat converter
the code will read the same for both

Apr 01, 2017 | 2007 Chevrolet Tahoe

1 Answer

I replaced the rear breaks rotars and shocks on my 2007 chev tahoe and now the abs light and service traction control and servive stabilitrak light came on. Jow can I reset?

Sounds like you may have disconnected or damaged one or both of the rear wheel speed sensors. Inspect the wiring going to the rear hub assembly, just a two wire harness.

Jun 12, 2011 | 2007 Chevrolet Tahoe

1 Answer

I have a 2001 chev tahoe and if i dont run it for two days the battery dies. i already change the battery once had the alternator check it was good. Could there be another problem i'm missing. Thank You

there is something draining your battery if you have a light under your bonnet check to see that it is not staying on, also all other lights,also the light in the boot that it is not staying on, if you can't find any problems there you probably have a short circuit somewhere look for any bare wires around the engine or for a wire rubbing on something, this may be easier when it is dark to see any sparks just give any wires a shake and see what happens....hope this helps.....cheers

Jul 07, 2010 | 2001 Chevrolet Tahoe

2 Answers

I slightly over-inflated by tires on a 2007 Chev Tahoe and now a warning continuely flashes telling me to check my tire pressure. How to I reset the system to quit telling me to check my tires.

why do you want your tires over inflated?
I would let some air out of the tires - use the back side of a tire gauge, or just press the valve stem with a small screwdriver (philips is easier)

Feb 25, 2010 | 2007 Chevrolet Tahoe

1 Answer

Service engine light

you need to have the chev checked for what code set the light on and then go from there

Dec 09, 2009 | 1997 Chevrolet Tahoe

1 Answer

My 07 Tahoe reverse lights stays on even after I turn it off

I'm afraid the dealership is probably right. You might get lucky and after you remove it check for bad solder joints, but I agree with the dealer's findings on this one. Unfortunately, that fuse block is a non-serviceable item so the fuse block will need to be replaced.
Hope this helps

Nov 17, 2009 | 2007 Chevrolet Tahoe

1 Answer

97 chev tahoe service engine light is on and it wont start

P0300 is random multiple misfire. If its been more then 3years since the last tune-up, do one. Usually it is caused by debris inside the distributor cap but could also be plugs wires, fuel and air filter.

Apr 28, 2009 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

414 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides